article·2018-01-01Open access

Wear behavior of GTA coated FeCrC based bond alloy on an AISI 1040 steel substrate

İbrahim Savaş Dalmış, Tanju Teker, Serdar Yılmaz

Abstract

Powders of FeCrC alloy were used for cladding on AISI 1040 plain steel base metal by using gas tungsten arc (GTA) processing. Microstructures of clad layers were examined by an X-ray energy dispersive spectrometer (EDS), scanning electron microscopy (SEM), X-ray diffraction (XRD) and microhardness test. The obtained results indicated that there was a similar microstructure in the all clad layers. The adhesion of the clad layers to the base metal was very good. The microstructures of the clad layers were quite dense. Hypoeutectic or hypereutectic microstructures of the cladded surfaces depend on the powder type and processing parameters. Martensite, austenite () and eutectic M7C3 carbides were obtained at interface zone. The wear tests of the cladded surfaces were performed under dry sliding conditions. It was determined that the pearlitic/bainitic matrix had a lower wear resistance than the primary austenitic matrix. K e y w o r d s : GTA, clad layer, dry sliding wear
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Advanced materials and composites · Intermetallics and Advanced Alloy Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.