article·2018-01-01Open access

Influence of holding time of annealing treatment on microstructure and properties of TIG welded joint for P91 heat-resistant steel tube

P. Liu, Shoujin Sun, Shiwei Xu, Miao Cao, Keyan Feng

Abstract

Optical microscope, micro-hardness tester, scanning electron microscope (SEM) and X-ray diffractometer (XRD) were applied to analyze the microstructure and properties of tungsten inert-gas arc welding (TIG) joint for P91 heat resistant steel under the different holding time of annealing treatment. The test results show that the martensite structure and retained austenite structure had a change in weld zone and heat affected zone (HAZ) with the increase of the holding time from 4 to 6 h with 760 C annealing. The microstructure in the weld zone shows the finer characteristic. The hardness in all regions tends to decrease after the annealing treatment, and the hardness is about 200-240 HV. However, the hardness in the weld zone is about 200-270 HV. The highest hardness in the weld zone and HAZ was observed when the holding time was 6 h, and some carbide was dissolved partially with the increase of the holding time. Moreover, when the holding time was 6 h with 760 C annealing, some small dispersed precipitated phases were distributed in the substrate. Thus, the microstructure and properties of TIG welded joint used for holding time 6 h are better than those for holding time 4 and 5 h. K e y w o r d s : P91 heat-resistant steel, annealing, holding time, microstructure, phase constitution
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Welding Techniques and Residual Stresses · Microstructure and Mechanical Properties of Steels · Laser and Thermal Forming Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.