Rheological Characterization of Mineral Slurries Based on the Principle of Maximum Entropy
Source abstract
Abstract
The rheological characterization of mineral slurries is a complex task, especially in the presence of coarse particles with high specific gravity, such as hematite. In laboratory rotational rheometers (LRRs), entrance effects, particle settling, and Taylor vortices can jeopardize the accuracy of the results. This paper presents a new methodology for the rheological characterization of mineral slurries in tubular devices and the Principle of Maximum Entropy (PME) supports this new approach. Iron ore slurries were prepared at mass concentrations of 36.8% and 43.6% solids and subjected to rheological characterization in LRR and a pumping loop tubular device (PLTD). The results from LRR revealed shear-thickening behavior for the slurries; whereas the results from PLTD, associated with entropic equations for the friction factor and shear rate, revealed shear-thinning behavior (at low shear rates) and shear-thickening behavior (at high rates). The results from LRR plus PLTD were plotted in a single rheogram, and curve fitting was accomplished by the power law model (R2=0.995), indicating an overall shear-thickening behavior. PME proved to be capable of supporting the rheological characterization of mineral slurries at shear rates above 1500s–1 in PLTD, complementing the results obtained by LRR.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Rheology and Fluid Dynamics Studies · Granular flow and fluidized beds · Hydraulic Fracturing and Reservoir Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Geosciences and Engineering Institute, Federal University of Southern and Southeastern Pará, Brazil
Department of Mining and Petroleum Engineering, Polytechnic School, University of São Paulo, Brazil
Mineral Development Center (CDM), Vale S.A., Brazil
Funding
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior · Instituto Tecnológico Vale
References (38)
Show source-provided references
1. Barnes H.A., Hutton J.F., Walters K., An Introduction to Rheology, 1st ed., Elsevier, Amsterdam; New York, 1989, ISBN: 9780444871404.
2. Boger D.V., Rheology and the resource industries, Chemical Engineering Science, 64 (2009) 4525–4536. https://doi.org/10.1016/j.ces.2009.03.00710.1016/j.ces.2009.03.007 ↗
3. Brown E., Jaeger H.M., Shear thickening in concentrated suspensions: phenomenology, mechanisms and relations to jamming, Reports on Progress in Physics, 77 (2014) 1–23. https://doi.org/10.1088/0034-4885/77/4/04660210.1088/0034-4885/77/4/046602 ↗
4. Chhabra R.P., Richardson J.F., Non-Newtonian Flow in the Process Industries, Elsevier, 1999, ISBN: 978-0-7506-3770-1. https://doi.org/10.1016/b978-0-7506-3770-1.x5000-310.1016/B978-075063770-1/50002-6 ↗
5. Chilton R.A., Stainsby R., Pressure loss equations for laminar and turbulent non-Newtonian pipe flow, Journal of Hydraulic Engineering, 124 (1998) 522–529. https://doi.org/10.1061/(asce)0733-9429(1998)124:5(522)10.1061/(ASCE)0733-9429(1998)124:5(522) ↗
6. Chiu C., Entropy and probability concepts in hydraulics, Journal of Hydraulic Engineering, 113 (1987) 583–599. https://doi.org/10.1061/(asce)0733-9429(1987)113:5(583)10.1061/(ASCE)0733-9429(1987)113:5(583) ↗
7. Chiu C., Velocity distribution in open channel flow, Journal of Hydraulic Engineering, 115 (1989) 576–594. https://doi.org/10.1061/(asce)0733-9429(1989)115:5(576)10.1061/(ASCE)0733-9429(1989)115:5(576) ↗
8. Chiu C., Lin G., Lu J., Application of probability and entropy concepts in pipe-flow study, Journal of Hydraulic Engineering, 119 (1993) 742–756. https://doi.org/10.1061/(asce)0733-9429(1993)119:6(742)10.1061/(ASCE)0733-9429(1993)119:6(742) ↗
9. Fangary Y.S., Ghani A.S.A., El Haggar S.M., Williams R.A., The effect of fine particles on slurry transport processes, Minerals Engineering, 10 (1997) 427–439. https://doi.org/10.1016/s0892-6875(97)00019-810.1016/S0892-6875(97)00019-8 ↗
10. Fox R.W., McDonald A.T., Pritchard P.J., Introdução À Mecânica Dos Fluidos, 6. ed., LTC, Rio de Janeiro (RJ), 2006, ISBN: 9788521614685.
11. Giguère R., Fradette L., Mignon D., Tanguy P.A., Analysis of slurry flow regimes downstream of a pipe bend, Chemical Engineering Research and Design, 87 (2009) 943–950. https://doi.org/10.1016/j.cherd.2009.01.00510.1016/j.cherd.2009.01.005 ↗
12. Groisman A., Steinberg V., Elastic turbulence in a polymer solution flow, Nature, 405 (2000) 53–55. https://doi.org/10.1038/3501101910.1038/35011019 ↗
13. Gürgen S., Kuşhan M.C., Li W., Shear thickening fluids in protective applications: a review, Progress in Polymer Science, 75 (2017) 48–72. https://doi.org/10.1016/j.progpolymsci.2017.07.00310.1016/j.progpolymsci.2017.07.003 ↗
14. Kawatra S.K., Bakshi A.K., On-line viscometry in particulate processing, Mineral Processing and Extractive Metallurgy Review, 14 (1995) 249–273. https://doi.org/10.1080/0882750950891412610.1080/08827509508914126 ↗
15. Kawatra S.K., Bakshi A.K., On-line measurement of viscosity and determination of flow types for mineral suspensions, International Journal of Mineral Processing, 47 (1996) 275–283. https://doi.org/10.1016/0301-7516(96)00009-910.1016/0301-7516(96)00009-9 ↗
16. Kelessidis V.C., Maglione R., Yield stress of water–bentonite dispersions, Colloids and Surfaces A: Physicochemical and Engineering Aspects, 318 (2008) 217–226. https://doi.org/10.1016/j.colsurfa.2007.12.05010.1016/j.colsurfa.2007.12.050 ↗
17. Kitanovski A., Vuarnoz D., Ata-Caesar D., Egolf P.W., Hansen T.M., Doetsch C., The fluid dynamics of ice slurry, International Journal of Refrigeration, 28 (2005) 37–50. https://doi.org/10.1016/j.ijrefrig.2004.07.01010.1016/j.ijrefrig.2004.07.010 ↗
18. Klein B., Laskowski J.S., Rheological measurements on settling suspensions: characterization of a cyanide leach pulp, Mineral Processing and Extractive Metallurgy Review, 20 (2000) 41–55. https://doi.org/10.1080/0882750990896246210.1080/08827509908962462 ↗
19. Louzada J.C.G., Souza Pinto T.C., Meier R.G., Souza P.A., Leal Filho L.S., Entropic friction factor modeling for mineral slurry flow in pressurized pipes, Journal of Hydraulic Engineering, 147 (2021) 1–6. https://doi.org/10.1061/(asce)hy.1943-7900.0001934
20. Lu P., Zhang M., Resistance properties of coal–water paste flowing in pipes, Fuel, 81 (2002) 877–881. https://doi.org/10.1016/s0016-2361(01)00217-410.1016/S0016-2361(01)00217-4 ↗
21. Ma X., Duan Y., Li H., Wall slip and rheological behavior of petroleum-coke sludge slurries flowing in pipelines, Powder Technology, 230 (2012) 127–133. https://doi.org/10.1016/j.powtec.2012.07.01910.1016/j.powtec.2012.07.019 ↗
22. Metzner A.B., Reed J.C., Flow of non-Newtonian fluids—correlation of the laminar, transition, and turbulent-flow regions, AIChE Journal, 1 (1955) 434–440. https://doi.org/10.1002/aic.69001040910.1002/aic.690010409 ↗
23. Mezger T., The Rheology Handbook: For Users of Rotational and Oscillatory Rheometers, 5th revised ed., Vincentz, Hannover, 2020, ISBN: 9783748603702. https://doi.org/10.1515/978374860370210.1515/9783748603702 ↗
24. Mooney M., Explicit formulas for slip and fluidity, Journal of Rheology, 2 (1931) 210–222. https://doi.org/10.1122/1.211636410.1122/1.2116364 ↗
25. Peker S.M., Helvaci S.S., Solid-Liquid Two Phase Flow, 1st ed., Elsevier, Amsterdam; Boston, 2007, ISBN: 9780444522375.
26. Pereira A.S., Soares E.J., Polymer degradation of dilute solutions in turbulent drag reducing flows in a cylindrical double gap rheometer device, Journal of Non-Newtonian Fluid Mechanics, 179–180 (2012) 9–22. https://doi.org/10.1016/j.jnnfm.2012.05.00110.1016/j.jnnfm.2012.05.001 ↗
27. Salunkhe A.A., Overney R.M., Berg J.C., The use of boundary lubricants for the reduction of shear thickening and jamming in abrasive particle slurries, Colloids and Surfaces A: Physicochemical and Engineering Aspects, 537 (2018) 13–19. https://doi.org/10.1016/j.colsurfa.2017.09.02910.1016/j.colsurfa.2017.09.029 ↗
28. Senapati P.K., Mishra B.K., Rheological characterization of concentrated jarosite waste suspensions using Couette & tube rheometry techniques, Powder Technology, 263 (2014) 58–65. https://doi.org/10.1016/j.powtec.2014.04.09210.1016/j.powtec.2014.04.092 ↗
29. Seto R., Mari R., Morris J.F., Denn M.M., Discontinuous shear thickening of frictional hard-sphere suspensions, Physical Review Letters, 111 (2013) 218301-1-218301–218305. https://doi.org/10.1103/PhysRevLett.111.21830110.1103/PhysRevLett.111.218301 ↗
30. Shi F., Determination of ferrosilicon medium rheology and stability, Minerals Engineering, 98 (2016) 60–70. https://doi.org/10.1016/j.mineng.2016.07.01610.1016/j.mineng.2016.07.016 ↗
31. Singh V., Sivakumar B., Cui H., Tsallis entropy theory for modeling in water engineering: a review, Entropy, 19 (2017) 1–25. https://doi.org/10.3390/e19120641
32. Singh V.P., Entropy Theory in Hydraulic Engineering: An Introduction, American Society of Civil Engineers, Reston, Virginia, 2014, ISBN: 9780784412725.10.1061/9780784412725 ↗
33. Slatter P., The role of rheology in the pipelining of mineral slurries, Mineral Processing and Extractive Metallurgy Review, 20 (2000) 281–300. https://doi.org/10.1080/0882750990896247810.1080/08827509908962478 ↗
34. Souza P.A., Moraes E.L., The flow resistance factor treated by the maximum entropy principle, International Journal of Hydraulic Engineering, 6 (2017) 1–8. https://doi.org/10.5923/j.ijhe.20170601.01
35. Souza Pinto T.C., Moraes Junior D., Slatter P.T., Leal Filho L.S., Modelling the critical velocity for heterogeneous flow of mineral slurries, International Journal of Multiphase Flow, 65 (2014) 31–37. https://doi.org/10.1016/j.ijmultiphaseflow.2014.05.01310.1016/j.ijmultiphaseflow.2014.05.013 ↗
36. Stickel J.J., Powell R.L., Fluid mechanics and rheology of dense suspensions, Annual Review of Fluid Mechanics, 37 (2005) 129–149. https://doi.org/10.1146/annurev.fluid.36.050802.12213210.1146/annurev.fluid.36.050802.122132 ↗
37. Tozzi E., Hartt W., Non-Newtonian laminar flow in pipes using radius, stress, shear rate or velocity as the independent variable, Physics of Fluids, 33 (2021) 103–104. https://doi.org/10.1063/5.006799310.1063/5.0067993 ↗
38. Whiten W., Steffens P., Hitchins J., An examination of pulp viscosity in tubes at higher shear rates, Minerals Engineering, 6 (1993) 397–404. https://doi.org/10.1016/0892-6875(93)90018-I10.1016/0892-6875(93)90018-I ↗