Effects of Non-Uniform Temperature Distribution on the Degradation of Liquid-Cooled Parallel-Connected Lithium-Ion Cells
Source abstract
Abstract
Our previous work on an air-cooled stack of five pouch-format lithium-ion (Li-ion) cells showed that non-uniform temperature can cause accelerated degradation, especially of the middle cell. In this work, a stack of five similar cells was cycled at a higher C-rate and water-cooled to create a larger temperature gradient for comparison with the air-cooled stack. It was hypothesized that the larger temperature gradient in the water-cooled stack would exacerbate the degradation of the middle cell. However, the results showed that the middle cell degraded slightly slower than the side cells in the water-cooled stack. This trend is opposite to that in the air-cooled stack. This difference could be attributed to the combined effects of a smaller temperature rise and larger temperature gradient in the water-cooled stack than in the air-cooled stack. Post-mortem analysis of cycled cells and a fresh cell showed that the degradation mainly came from the anode. Increased lithium plating and decreased porosity in the side cells are possible mechanisms for the faster degradation compared with the middle cell. It was also found that all the cells in the water-cooled stack experienced a phenomenon of capacity drop and recovery after a low C-rate reference performance test and extended rest. This phenomenon can be attributed to lithium diffusion between the anode active area and the anode overhang area.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Advancements in Battery Materials · Advanced Battery Technologies Research · Advanced Battery Materials and Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Department of Mechanical & Aerospace Engineering, The University of Alabama in Huntsville, Huntsville, AL 35899, USA
References (37)
Show source-provided references
1. Degradation diagnostics for lithium ion cells10.1016/j.jpowsour.2016.12.011 ↗
2. Lithium ion battery degradation: What you need to know10.1039/D1CP00359C ↗
3. Temperature dependent ageing mechanisms in Lithium-ion batteries—A Post-Mortem study10.1016/j.jpowsour.2014.03.112 ↗
4. Fundamental Insights into Battery Thermal Management and Safety10.1021/acsenergylett.2c00077 ↗
5. A Critical Review of Thermal Issues in Lithium-Ion Batteries10.1149/1.3515880 ↗
6. Thermal Properties of Lithium-Ion Battery and Components10.1149/1.1391704 ↗
7. Thermal conductivity and internal temperature profiles of Li-ion secondary batteries10.1016/j.jpowsour.2017.05.045 ↗
8. Meta-analysis of experimental results for heat capacity and thermal conductivity in lithium-ion batteries: A critical review10.1016/j.jpowsour.2021.230829 ↗
9. Thermal modeling of a cylindrical LiFePO4/graphite lithium-ion battery10.1016/j.jpowsour.2009.10.105 ↗
10. Examining temporal and spatial variations of internal temperature in large-format laminated battery with embedded thermocouples10.1016/j.jpowsour.2013.04.117 ↗
11. In Situ Measurement of Radial Temperature Distributions in Cylindrical Li-Ion Cells10.1149/2.0051410jes ↗
12. Understanding the limits of rapid charging using instrumented commercial 18,650 high-energy Li-ion cells10.1016/j.electacta.2018.01.076 ↗
13. In Situ Measurement of Lithium-Ion Cell Internal Temperatures during Extreme Fast Charging10.1149/2.0441914jes ↗
14. Visualizing two-dimensional internal temperature distribution in cylindrical Li-ion cells10.1016/j.jpowsour.2019.227343 ↗
15. Surface Cooling Causes Accelerated Degradation Compared to Tab Cooling for Lithium-Ion Pouch Cells10.1149/2.0361609jes ↗
16. Directionality of thermal gradients in lithium-ion batteries dictates diverging degradation modes10.1016/j.xcrp.2021.100351 ↗
17. Current Distribution Measurements in Parallel-Connected Lithium-Ion Cylindrical Cells under Non-Uniform Temperature Conditions10.1149/2.0011709jes ↗
18. Paarmann, S., Cloos, L., Technau, J., and Wetzel, T. (2021). Measurement of the Temperature Influence on the Current Distribution in Lithium-Ion Batteries. Energy Technol., 9.10.1002/ente.202000862 ↗
19. Werner, D., Paarmann, S., Wiebelt, A., and Wetzel, T. (2020). Inhomogeneous Temperature Distribution Affecting the Cyclic Aging of Li-Ion Cells. Part I: Experimental Investigation. Batteries, 6.10.3390/batteries6010013 ↗
20. Effects of Nonuniform Temperature Distribution on Degradation of Lithium-Ion Batteries10.1115/1.4045205 ↗
21. Electrochemical and Post-Mortem Degradation Analysis of Lithium-Ion Cells Subjected to Long Term Cycling under Non-Uniform Thermal Conditions10.1149/1945-7111/ac2a7c ↗
22. Modeling of lithium plating induced aging of lithium-ion batteries: Transition from linear to nonlinear aging10.1016/j.jpowsour.2017.05.110 ↗
23. Challenges and Innovations of Lithium-Ion Battery Thermal Management Under Extreme Conditions: A Review10.1115/1.4056823 ↗
24. (Digital Presentation) Effects of Non-Uniform Temperature Distribution on the Degradation of Liquid-Cooled Lithium-Ion Cells10.1149/MA2022-012442mtgabs ↗
25. Comparison of Several Methods for Determining the Internal Resistance of Lithium Ion Cells10.3390/s100605604 ↗
26. Thermal-Electrochemical Modeling of Battery Systems10.1149/1.1393625 ↗
27. Heats of mixing and of entropy in porous insertion electrodes10.1016/S0378-7753(03)00283-0 ↗
28. Lin, N., Röder, F., and Krewer, U. (2018). Multiphysics Modeling for Detailed Analysis of Multi-Layer Lithium-Ion Pouch Cells. Energies, 11.10.3390/en11112998 ↗
29. Understanding Anomalous Behavior in Coulombic Efficiency Measurements on Li-Ion Batteries10.1149/2.0191503jes ↗
30. State of health assessment for lithium batteries based on voltage–time relaxation measure10.1016/j.electacta.2016.02.109 ↗
31. The effect of charging rate on the graphite electrode of commercial lithium-ion cells: A post-mortem study10.1016/j.jpowsour.2016.10.002 ↗
32. Failure Mechanism of Graphite/LiNi0.5Mn1.5O4Cells at High Voltage and Elevated Temperature10.1149/2.022305jes ↗
33. Hysteresis and current dependence of the graphite anode color in a lithium-ion cell and analysis of lithium plating at the cell edge10.1016/j.est.2017.10.015 ↗
34. The Effects of Non-Uniform Mechanical Compression of Lithium-Ion Cells on Local Current Densities and Lithium Plating10.1149/1945-7111/ac33e1 ↗
35. Lithium Plating on Graphite Negative Electrodes: Innovative Qualitative and Quantitative Investigation Methods10.1149/2.0451514jes ↗
36. Efficient Workflows for Detecting Li Depositions in Lithium-Ion Batteries10.1149/1945-7111/ad5ef8 ↗
37. In-Depth Characterization of Lithium-Metal Surfaces with XPS and ToF-SIMS: Toward Better Understanding of the Passivation Layer10.1021/acs.chemmater.0c03518 ↗