The behaviour of highly over-stoichiometric LaNi5 Mn2 alloy as negative electrode for Ni/MH batteries
Source abstract
Abstract
Key electrochemical properties of highly over-stoichiometric LaNi 5 Mn 2 alloy with CaCu 5 -type structure have been measured and compared with those of stoichiometric LaNi 4 Mn alloy. LaNi 5 Mn 2 is obtained by mechanical alloying of two-phase La(Ni,Mn) 5 + (Ni,Mn) alloy previously produced by induction melting. The as-milled alloy was thermally annealed at 450 C for one hour to crystallise milling-induced amorphous phase. As derived from DSC and XRD measurements, further annealing at 550 C produces segregation of minor NiMn-phase (21 wt%), which leaves stoichiometric LaNi 4 Mn alloy (79 wt%) as a major phase. Electrochemical cycle-life and potential equilibrium measurements for both LaNi 5 Mn 2 and LaNi 4 Mn alloys show that the over-stoichiometric alloy has much lower discharge capacity than the stoichiometric one (135 mAh/g and 260 mAh/g, respectively). Conversely, the over-stoichiometric alloy exhibits much better cycle-life than the stoichiometric one (5% and 25% decay capacity after 55 cycles, respectively). These results demonstrate that stoichiometry is an effective parameter for tuning the discharge capacity and cycle-life of LaNi 5+x -type electrodes to the performances required by a particular application.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Hydrogen Storage and Materials · Advancements in Battery Materials · Inorganic Chemistry and Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (16)
Show source-provided references
1. J. H. N. Van Vucht, F. A. Kuijpers and H. C. A. M. Bruning, Philips Res. Rep. 25 (1970) 133.
2. H. Ogawa, M. Ikoma, H. Kawano and I. Matsumoto, J. Power Sources 12 (1988) 393.
3. P. H. L. Notten, R. E. F. Einerhand and J. L. C. Daams, J. Alloys Compd. 210 (1994) 221.10.1016/0925-8388(94)90142-2 ↗
4. Idem.,Ibid. 231 (1995) 604.10.1016/0925-8388(95)01736-4 ↗
5. P. H. L. Notten, M. Latroche and A. PercheronguÉgan, J. Electrochem. Soc. 146 (1999) 3181.10.1149/1.1392452 ↗
6. K. H. J. Buschow and H. H. Van Mal, J. Less-Common Met. 29 (1972) 203.
7. F. Cuevas, M. Hirscher, B. Ludescher and H. Kronmuller, J. Appl. Phys. 86 (1999) 6690.10.1063/1.371745 ↗
8. F. Cuevas, M. Latroche, M. Hirscher and A. Percheron-GuÉgan, J. Alloys Compd. 323/324 (2001) 4.10.1016/S0925-8388(01)01004-0 ↗
9. F. Cuevas, J.-M. Joubert, M. Latroche, O. Isnard and A. Percheron-GuÉgan, Appl. Phys. A 74 (2002) S1175.10.1007/s003390201686 ↗
10. C. Lartigue, A. Percheron-GuÉgan, J.-C. Achard and F. Tasset, J. Less-Common Met. 75 (1980) 23.10.1016/0022-5088(80)90365-3 ↗
11. J. Rodríguez-Carvajal, PhysicaB 192 (1993) 55.10.1016/0921-4526(93)90108-I ↗
12. R. W. Knoll, Mater. Lett. 3 (1985) 137.10.1016/0167-577X(85)90145-4 ↗
13. F. Cuevas and M. Hirscher, Acta Mater. 51 (2003) 701.10.1016/S1359-6454(02)00448-2 ↗
14. J. Honstra and K. H. J. Buschow, J. Less-Common Met. 27 (1972) 123.10.1016/0022-5088(72)90024-0 ↗
15. M. Latroche, J.-M. Joubert, A. PercheronguÉgan and P. H. L. Notten, J. Solid State Chem. 146 (1999) 313.10.1006/jssc.1999.8348 ↗
16. E. KrÉn, E. Nagy, I. Nagy, L. Pal and P. Szabo, J. Phys. Chem. Solids 29 (1968) 101.10.1016/0022-3697(68)90259-X ↗