journal article·2021-05

Role of Si in the wetting of TiC by Al

Rui-Fen Guo, Ya Wang, Yun-Hai Ma, Ping Shen

Journal of Materials Science· Volume 56· Issue 13
Publisher page

Abstract

The wettability of TiC by Al alloys plays a key role in the preparation of TiC-reinforced Al matrix composites. Despite some prior work has been reported on this issue, few studies concern the influence of Si. In this work, the effects of Si concentration (0, 7Si, 12Si in wt%) and temperature on the wettability in the Al/TiC system were investigated by a dispensed sessile drop method at 1073–1173 K in a high vacuum. The initial contact angles were 103°–105°, almost independent of temperature, while the final contact angles decreased with increasing temperature. Formation of an Al4C3 phase and adsorption of the displaced [Ti] at the solid–liquid interface were two primary driving forces for the wetting improvement. On the other hand, an increase in the Si concentration greatly weakened the stability of TiC in Al melt, promoted the formation of Al4C3, and thus led to the faster spreading of the liquid in the early wetting stage. However, as the interfacial reaction progressed, the displaced [Ti] was bound by the Si in the Al melt due to their strong chemical affinity, thus weakening the adsorption effect of [Ti] for the wetting. As a consequence, the final apparent wettability of the Al–Si/TiC system was even worse than that of the Al/TiC system, and this situation was more prominent with increasing Si content.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloys Composites Properties · Advanced materials and composites · Advanced ceramic materials synthesis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (23)

Show source-provided references
1. Anandkumar R, Almeida A, Vilar R (2012) Microstructure and sliding wear resistance of an Al-12 wt%Si/TiC laser clad coating. Wear 282:31–39. https://doi.org/10.1016/j.wear.2012.01.02210.1016/j.wear.2012.01.022 ↗
2. Karantzalis AE, Wyatt S, Kennedy AR (1997) The mechanical properties of Al-TiC metal matrix composites fabricated by a flux-casting technique. Mater Sci Eng A 237:200–206. https://doi.org/10.1016/S0921-5093(97)00290-610.1016/S0921-5093(97)00290-6 ↗
3. Contreras A, León CA, Drew RAL, Bedolla E (2003) Wettability and spreading kinetics of Al and Mg on TiC. Scr Mater 48(12):1625–1630. https://doi.org/10.1016/S1359-6462(03)00137-410.1016/S1359-6462(03)00137-4 ↗
4. Rhee SK (1970) Wetting of ceramics by liquid aluminum. J Am Ceram Soc 53:386–389. https://doi.org/10.1111/j.1151-2916.1970.tb12138.x10.1111/j.1151-2916.1970.tb12138.x ↗
5. Samsonov GV, Panasyuk AD, Kozina GK (1968) Wetting of refractory carbides with liquid metals. Powder Metall Met Ceram 7(11):874–878. https://doi.org/10.1007/BF0078030610.1007/BF00780306 ↗
6. Froumin N, Frage N, Polak M, Dariel MP (1997) Wettability and phase formation in the TiCx/Al system. Scr Mater 37:1263–1267. https://doi.org/10.1016/S1359-6462(97)00235-210.1016/S1359-6462(97)00235-2 ↗
7. Laurent V, Chatain D, Chatillon C, Eustathopoulos N (1988) Wettability of monocrystalline alumina by aluminium between its melting point and 1273 K. Acta Metall 36(7):1797–1803. https://doi.org/10.1016/0001-6160(88)90248-910.1016/0001-6160(88)90248-9 ↗
8. Giuranno D, Ricci E, Arato E, Costa P (2006) Dynamic surface tension measurements of an aluminium–oxygen system. Acta Mater 54(10):2625–2630. https://doi.org/10.1016/j.actamat.2006.02.00510.1016/j.actamat.2006.02.005 ↗
9. Arato E, Ricci E, Giuranno D, Costa P (2006) Composition transients and saturation phenomena at a liquid metal–vapour interface—the oxidation of tin and aluminium. J Cryst Growth 293(1):186–192. https://doi.org/10.1016/j.jcrysgro.2006.03.06410.1016/j.jcrysgro.2006.03.064 ↗
10. Lin QL, Shen P, Yang LL, Jin SB, Jiang QC (2011) Wetting of TiC by molten Al at 1123–1323 K. Acta Mater 59:1898–1911. https://doi.org/10.1016/j.actamat.2010.11.05510.1016/j.actamat.2010.11.055 ↗
11. López VH, Kennedy AR, García R (2010) Flux-assisted spreading of an Al-7 wt%Si alloy on TiC. J Mater Sci 45:4321–4331. https://doi.org/10.1007/s10853-010-4418-310.1007/s10853-010-4418-3 ↗
12. López VH, Scoles A, Kennedy AR (2003) The thermal stability of TiC particles in an Al-7 wt%Si alloy. Mater Sci Eng A 356:316–325. https://doi.org/10.1016/S0921-5093(03)00143-610.1016/S0921-5093(03)00143-6 ↗
13. Ding HM, Wang XL, Liu Q, Wang JF, Li CY, Zhang XC (2017) The stability and transformation of TiC with different stoichiometries in Cu–Si melts. Mater Des 135:232–238. https://doi.org/10.1016/j.matdes.2017.09.03010.1016/j.matdes.2017.09.030 ↗
14. Qiu F, Liu T, Jiang ZH, Shen P, Jiang QC (2008) Formation of a multiphase gradient structure in a Zr–Cu–Ni–Al–O alloy. Adv Eng Mater 10:384–388. https://doi.org/10.1002/adem.20070030410.1002/adem.200700304 ↗
15. Zhang LY, Shen P, Qi Y, Jiang QC (2013) Wettability in reactive Sn-base alloy/Ni-base metallic glass systems. Appl Surf Sci 276:424–432. https://doi.org/10.1016/j.apsusc.2013.03.11010.1016/j.apsusc.2013.03.110 ↗
16. Barin I (1995) Thermochemical data of pure substances, 3rd edn. Wiley, Weinheim. https://doi.org/10.1002/9783527619825.ch12b10.1002/9783527619825.ch12b ↗
17. Ferro AC, Derby B (1995) Wetting behavior in the Al–Si/SiC system: interface reactions and solubility effects. Acta Metall Mater 43:3061–3073. https://doi.org/10.1016/0956-7151(95)00014-M10.1016/0956-7151(95)00014-M ↗
18. Dezellus O, Hodaj F, Eustathopoulos N (2003) Progress in modelling of chemical-reaction limited wetting. J Eur Ceram Soc 23(15):2797–2803. https://doi.org/10.1016/S0955-2219(03)00291-710.1016/S0955-2219(03)00291-7 ↗
19. Tabaian SH, Maeda M, Ikeda T, Ogasawara Y (2000) Thermodynamic study of molten Si-Ti binary alloys. High Temp Mater Process 19:257–264. https://doi.org/10.1515/HTMP.2000.19.3-4.25710.1515/HTMP.2000.19.3-4.257 ↗
20. Reddy RG, Yahyaa AM, Brewer L (2001) Thermodynamic properties of Ti–Al intermetallics. J Alloy Compd 321:223–227. https://doi.org/10.1016/S0925-8388(01)00972-010.1016/S0925-8388(01)00972-0 ↗
21. Eustathopoulos N, Nicholas M, Drevet B (1999) Wettability at high temperatures. Elsevier, Oxford
22. Kaufman L, Bernstein H (1970) Computer calculation of phase diagrams. Academic Press, New York
23. Takeuchi A, Inoue A (2005) Classification of bulk metallic glasses by atomic size difference, heat of mixing and period of constituent elements and its application to characterization of the main alloying element. Mater Trans 46(12):2817–2829. https://doi.org/10.2320/matertrans.46.281710.2320/matertrans.46.2817 ↗