journal article·2005-07

Geometrical features of wear debris

A. W. Momber, Y. C. Wong

Journal of Materials Science· Volume 40· Issue 13
Publisher page

Abstract

Image analysis software was used to analyse the geometry of debris formed during the erosion of low-carbon steel by impinging solid particles. Depending on the two-dimensional aspect ratio (ratio between debris height and debris width), three different debris types could be distinguished. The most frequent type observed was a platelet-type debris as suggested by the Bellman-Levy (1981) model. This wear debris shape type covered about 60% of all acquired debris. Plain micro-machining according to Finnie’s (1959) suggestion played a negligible role only, but other processes, namely ploughing as suggested by Winter and Hutchings (1974), were more important. The statistically estimated mean debris size was about 14 μ m. About 92% of all wear debris had sizes smaller than the target material grain size. This result supports the figure that ‘secondary’ removal modes—lip or platelet, respectively, detachment from crater rims—were responsible for material removal.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Erosion and Abrasive Machining · Metal Alloys Wear and Properties · High-Temperature Coating Behaviors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (10)

Show source-provided references
1. A. LEVY, “Solid Particle Erosion and Erosion-Corrosion of Materials” (ASM International, Materials Park, 1995).
2. A. W. MOMBER and R. KOVACEVIC, “Principles of Abrasive Water Jet Machining” (Springer Ltd., London, 1998).10.1007/978-1-4471-1572-4 ↗
3. P. SHEWMON and G. SUNDARARAJAN, Ann. Rev. Mater. Sci. 13 (1983) 301.10.1146/annurev.ms.13.080183.001505 ↗
4. I. FINNIE, in “Proc. 3rd National Congr. of Applied Mechanics,” edited by R. M. Haythornthwaite et al. (ASME, New York, 1958) p. 527.
5. R. E. WINTER and I. M. HUTCHINGS, Wear 29 (1974) 181.10.1016/0043-1648(74)90069-6 ↗
6. T. H. KOSEL, Z. Y. MAO and S. V. PRASAD, ASLE Trans. 28 (1984) 268.10.1080/05698198508981621 ↗
7. R. BELLMANN and A. LEVY, Wear 70 (1981) 1.10.1016/0043-1648(81)90268-4 ↗
8. A. HAMMERSTEN, S. SÖBHAT ODERBERG AND S. HOGMARK, in “Proceedings of the International Conference on Wear of Materials,” Edited. W. A. Glaeser (ASME, New York, 1983) p. 373.
9. S. TSCHERNY, E. WANDTKE and U. FRÖHNER, Schmierungstechnik 19 (1988) 235.
10. A. W. MOMBER, H. KWAK and R. KOVACEVIC, ASME J. Tribol. 118 (1996) 759.10.1115/1.2831605 ↗