journal article·2004-06

Fracture behavior of ultra-fine grained steel bar under dynamic loading

H. Qiu, Y. Kawaguchi, C. Shiga

Journal of Materials Science· Volume 39· Issue 11
Publisher page

Abstract

Ultra-fine grained steel bars were recently developed by thermo-mechanical controlled rolling with rapid cooling for increasing the strength of low carbon and low alloy steels. The developed steels are characterized by fine ferrite grains of less than 1 μm and high strength as a result of grain refinement. However, their correlations between tensile properties and impact behavior are not well understood. In this paper, impact absorbed energy (E p) and dynamic fracture toughness (J Id) were used to evaluate the dynamic fracture behavior of the ultra-fine grained steels, and the fracture mechanisms were also investigated. For the ultra-fine grained steels, tensile stress-strain curve was shown to be correlated with the impact curve of load vs. time, and to be related to the dynamic fracture toughness. The steel with large ferrite grains, small ferrite grain colony and martensite was found to have a good combination of strength and toughness.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Microstructure and Mechanical Properties of Steels · High-Velocity Impact and Material Behavior · Fatigue and fracture mechanics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (6)

Show source-provided references
1. T. Maki, J. Jpn. Soc. Heat Treat. 37 (1997) 5.
2. NATIONAL RESEARCH INSTITUTE FOR METALS, in Proc. of 98 Workshop of Structural Materials for 21st Century, Tsukuba, Japan, 1998.
3. NATIONAL RESEARCH INSTITUTE FOR METALS, in Proc. of 99 Workshop of Structural Materials for 21st Century, Tsukuba, Japan, 1999.
4. NATIONAL RESEARCH INSTITUTE FOR METALS, in Proc. of 2000 Workshop of Structural Materials for 21st Century, Tsukuba, Japan, 2000.
5. H. Qiu, Y. Kawaguchi, C. Shiga, M. Enoki and T. Kishi, Mater. Sci. Tchnol. (in press).
6. N. Matsukura and S. Nanba, in Proc. of 1st Symposium on Super Metal, R&D Inst. of Met. and Composites for Future Industries (RIMCOF) and The Japan Res. and Development Center for Met. (JRCM), Tokyo, Japan, 1998, p. 229.