journal article·2006-07Open access

Electrical behaviour of materials based on monoclinic celsian derived from cation-exchanged commercial zeolites

A. Motori, F. Patuelli, A. Saccani, F. Andreola, F. Bondioli, C. Siligardi, A. M. Ferrari

Journal of Materials Science· Volume 41· Issue 13

Abstract

Monoclinic celsian has been obtained by a non-conventional way, i.e. the thermal treatment of 4A-type commercial zeolite: a stoichiometric amount of barium ions was included in the zeolite by means of a cation-exchange treatment. A small concentration of alkali ions (either sodium or lithium) was also present in the exchanged zeolite, since previous studies had underlined the positive effect of these ions on the formation of monoclinic celsian. This particular synthesis proves to be economic, due to the low-cost precursors, the low temperatures and the short times required. However, the presence of even a small content of alkali ions and a residual amorphous phase can negatively affect the insulating properties of the material, thus hindering its use in electrical insulating systems. The results so far obtained show that the material keeps good insulating properties at low temperature, but its conductivity and dielectric losses strongly increase above 200 °C.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Glass properties and applications · Zeolite Catalysis and Synthesis · Advanced Battery Materials and Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (18)

Show source-provided references
1. R. A. MCCAULEY, J. Mater. Sci. 35 (2000) 3939.10.1023/A:1004802002579 ↗
2. Y. SUNG and S.KIM, J. Mater. Sci. Letters 18 (1999) 1657.10.1023/A:1006661312786 ↗
3. N. B. BANSAL, Mater. Sci. Eng. A 342 (2002) 23.10.1016/S0921-5093(02)00313-1 ↗
4. I. G. TALMY, D. A. HAUGHT and E. J. WUCHINA, in Proceedings of 6th International SAMPE Electrical Conference June 1992, p. 687.
5. B. HOGHOOGHI, J. MCKRITTRICK, E. HENSEL and O. A. LOPEZ, J. Am. Ceramic Soc. 81 (4) (1998) 845.10.1111/j.1151-2916.1998.tb02418.x ↗
6. M. PANSINI, G. DELL’AGLI, M. C. MASCOLO and C. FERONE, Solid State Ionics 127 (2000) 309.10.1016/S0167-2738(99)00298-2 ↗
7. G. DELL’AGLI, C. FERONE, M. C. MASCOLO and M. PANSINI, Chem. Mater. 14 (2) (2002) 797.10.1021/cm0111938 ↗
8. A. ARONNE, S. ESPOSITO, C. FERONE, M. PANSINI and P. PERNICE, J. Mater. Chem. 12 (2002) 3039.10.1039/b203859e ↗
9. K. T. LEE and P. B. ASWATH, Mater Sci. and Eng. A. 352 (2003) 1.10.1016/S0921-5093(02)00118-1 ↗
10. M. BELLOTTO and C. CRISTIANI, Mater. Sci. Forum 79–82 (1991) 745.10.4028/www.scientific.net/MSF.79-82.745 ↗
11. A. F. GUALTIERI and G. ARTIOLI, Powder Diffraction 10 (1995) 269.10.1017/S0885715600014962 ↗
12. A. C. LARSON, R. B. VON DREELE, in “GSAS: General Structure Analysis System LANSCE” (MS-H805; Los Alamos National Laboratory: Los Alamos, NM, 1998).
13. M. C. MASCOLO, G. DELL’AGLI, C. FERONE, M. PANSINI and G. MASCOLO, J. Europ. Cer. Soc. 23 (2003) 1705.10.1016/S0955-2219(02)00418-1 ↗
14. C. FERONE, S. ESPOSITO, G. DELL’AGLI, R. PALMACCIO and M. PANSINI accepted for publication on J. Amer. Ceramic Soc.
15. C. SILIGARDI, F. ANDREOLA, T. MANFREDINI, C. FERONE and M. PANSINI to be submitted.
16. J. E. DAVIDSON, M. D. INGRAM, A. BUNDE and K. FUNKE, J. Non Cryst. Sol. 203 (1996) 246.10.1016/0022-3093(96)00355-9 ↗
17. J. E. KIM, S. J. KIM, K. OHNSHIMA, Y. H. HWANG and Y. S. YANG, Mater. Sci. Eng. A 375–377 (2004) 1255.10.1016/j.msea.2003.10.104 ↗
18. R. BALAJI RAO, GOPAL N. O. and N. VERAAIAH, J. Alloys and Comp. 368 (2004) 25.10.1016/j.jallcom.2003.08.077 ↗