journal article·2003-01

Dihedral angle measurement in microgravity liquid phase sintered microstructures

S. Ye, Y. He, J. E. Smith

Journal of Materials Science· Volume 38· Issue 2
Publisher page

Abstract

Liquid phase sintered materials are characterized by a connected microstructure composed of contacting grains in a solidified matrix phase. Characterizations on the sintered microstructure are typically performed by two-dimensional cross sections. A new dihedral angle model based totally on the geometry of the spherical solid grains without any further assumptions is presented in this paper to determine the dihedral angles measured in two-dimensional sections vs. the dihedral angles in three dimensions. The result shows that the average dihedral angle measured on sections is 14/15 the dihedral angle in three dimensions. The expected frequencies of the simulation are favorably compared with the experimental results obtained from microgravity liquid phase sintered Fe-Cu alloys with four different solid volume fractions (50, 60, 70, 80 vol% Fe balanced with Cu) and six different sintering times (10, 20, 30, 40, 60 and 330 minutes) when a 3-D dihedral angle with a standard deviation of 10°, in our case, 40° ± 10°, was employed in the model. The goodness of fit of the theoretical 2-D results with the experimental data was determined by chi-squared test. The fit of the data is good since all the computed values of χ2 are smaller than the critical value.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Powder Metallurgy Techniques and Materials · Metallurgy and Material Forming · Metal Forming Simulation Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (12)

Show source-provided references
1. R. M. German, Metall. Trans. A 18A (1987) 909.10.1007/BF02646932 ↗
2. E. E. Underwood, in “Quantitative Stereology” (Addison-Wesley, Reading, MA, 1970).
3. H. E. Exner, Inter. Metall. Rev. 17 (1972) 25.10.1179/095066072790137729 ↗
4. Y. Liu, R. M. German and R. G. Iacocca, Acta Mater. 47 (1999) 915.10.1016/S1359-6454(98)00395-4 ↗
5. R. M. German, in “Liquid Phase Sintering” (Plenum Press, New York, 1985).10.1007/978-1-4899-3599-1 ↗
6. D. Harker and E. Parker, Trans. ASM 34 (1945) 156.
7. CH. A. Stickels and E. E. Hucke, Metall. Soc. AIME, Trans. 230 (1964) 795.
8. S. R. Jurewicz and A. J. G. Jurewicz, J. Geophys. Res. 91 (1986) 9277.10.1029/JB091iB09p09277 ↗
9. O. K. Riegger and L. H. van Vlack, Metall. Soc. AIME, Trans. 218 (1960) 933.
10. J. Naser, J. E. Smith Jr. and A. K. Kuruvilla, J. Mater. Sci. 33 (1998) 5573.10.1023/A:1004403912910 ↗
11. R. T. Dehoff, Metallography 19 (1986) 209.10.1016/0026-0800(86)90036-4 ↗
12. S. Dowdy and S. Wearden, in “Statistics for Research” (John Wiley and Sons, New York, NY, 1983).