journal article·2015-01Open access

He implantation for improved tribological performance in Au electrical contacts

J.-E. Mogonye, K. Hattar, P. G. Kotula, T. W. Scharf, S. V. Prasad

Journal of Materials Science· Volume 50· Issue 1

Abstract

This paper describes the role of He ion implantation on the friction, wear, electrical contact resistance (ECR), and near surface microstructure of Au films. The films were deposited by e-beam evaporation and implanted with He under two different conditions. Electrical contact resistance and friction data were collected simultaneously, while sliding a Au-Cu alloy pin on He ion implanted Au films. Results showed that friction coefficients were reduced from ~1.5 to ~0.5 and specific wear rates from ~4 × 10−3 to ~1 ×10−4 mm3/N m (both versus un-implanted samples) without a significant change in sliding ECR (~16 mΩ) as a result of He ion beam implantation. Subsurface microstructural changes due to tribological stress and the passing of current were analyzed using site-specific cross-sectional TEM. The implantation of He by itself did not induce changes to the grain size or crystallographic texture of e-beam Au. However, frictional contact during ECR testing of low energy He implanted films resulted in the formation of stable equiaxed nanocrystalline grains and the growth and redistribution of cavities beneath the wear surface. Plastic deformation as evidenced by transfer of Au to the pin during frictional contact was significantly reduced as a result of implantation. This was hypothesized to be a result of Orowan-like hardening due to He implantation.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Electrical Contact Performance and Analysis · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (40)

Show source-provided references
1. Goodman P (2002) Current and future uses of gold in electronics. Gold Bull 35(1):21–2610.1007/BF03214833 ↗
2. Bowden FP, Tabor D (2001) The friction and lubrication of solids, vol 1. Oxford university press, Oxford10.1093/oso/9780198507772.001.0001 ↗
3. Antler M (1981) Sliding wear of metallic contacts. IEEE Trans Compon Hybrids Manuf Technol 4(1):15–29. doi: 10.1109/tchmt.1981.113578410.1109/TCHMT.1981.1135784 ↗
4. Holm R, Holm E (1967) Electric contacts: theory and application. Springer-Verlag, New York10.1007/978-3-662-06688-1 ↗
5. Lo CC, Augis JA, Pinnel MR (1979) Hardening mechanisms of hard gold. J Appl Phys 50(11):6887–6891. doi: 10.1063/1.32589010.1063/1.325890 ↗
6. Chew Y, Wong C, Wulff F, Lim F, Goh H (2008) Strain rate sensitivity and Hall-Petch behavior of ultrafine-grained gold wires. Thin Solid Films 516(16):5376–538010.1016/j.tsf.2007.07.090 ↗
7. Fischer-Bühner J (2005) Hardening of low-alloyed gold. Gold Bull 38(3):120–13110.1007/BF03215246 ↗
8. Chen L, Lee H, Guo Z, McGruer NE, Gilbert K, Mall S, Leedy KD, Adams GG (2007) Contact resistance study of noble metals and alloy films using a scanning probe microscope test station. J Appl Phys 102(7):07491010.1063/1.2785951 ↗
9. Bannuru T, Brown WL, Narksitipan S, Vinci RP (2008) The electrical and mechanical properties of Au–V and Au–V2O5 thin films for wear-resistant RF MEMS switches. J Appl Phys 103(8):08352210.1063/1.2902954 ↗
10. Voevodin A, Hu J, Fitz T, Zabinski J (2001) Tribological properties of adaptive nanocomposite coatings made of yttria stabilized zirconia and gold. Surf Coat Technol 146:351–35610.1016/S0257-8972(01)01396-2 ↗
11. Williams JR, Clarke DR (2008) Strengthening gold thin films with zirconia nanoparticles for MEMS electrical contacts. Acta Mater 56(8):1813–1819. doi: 10.1016/j.actamat.2007.12.03810.1016/j.actamat.2007.12.038 ↗
12. Argibay N, Prasad SV, Goeke RS, Dugger MT, Michael JR (2013) Wear resistant electrically conductive Au-ZnO nanocomposite coatings synthesized by e-beam evaporation. Wear 302(1–2):955–962. doi: 10.1016/j.wear.2013.01.04910.1016/j.wear.2013.01.049 ↗
13. Schoeppner R, Bahr D, Jin H, Goeke R, Moody N, Prasad S (2014) Wear behavior of Au–ZnO nanocomposite films for electrical contacts. J Mater Sci. doi: 10.1007/s10853-014-8326-9
14. Antler M (1998) Gold-plated contacts: effect of thermal aging on contact resistance. Plat Surf Finish 85(12):85–90
15. Tompkins HG (1975) Diffusion of cobalt out of cobalt-hardened gold measured with auger electron spectroscopy. J Electrochem Soc 122(7):983–98710.1149/1.2134382 ↗
16. Tompkins HG, Pinnel MR (1977) Relative rates of nickel diffusion and copper diffusion through gold. J Appl Phys 48(7):3144. doi: 10.1063/1.32404510.1063/1.324045 ↗
17. Nastasi M (1996) Ion-solid interactions: fundamentals and applications. Cambridge University Press, Cambridge10.1017/CBO9780511565007 ↗
18. Zinkle S (1999) Fundamental radiation effects parameters in metals and ceramics. Radiat Eff Defects Solids 148(1–4):447–47710.1080/10420159908229104 ↗
19. Dearnaley G (1990) Ion beam modification of metals. Nucl Instrum Methods Phys Res Sect B 50(1):358–36710.1016/0168-583X(90)90382-5 ↗
20. Hartley N (1979) Friction and wear of ion-implanted metals—a review. Thin Solid Films 64(2):177–19010.1016/0040-6090(79)90508-X ↗
21. Sioshansi P (1984) Ion beam modification of materials for industry. Thin Solid Films 118(1):61–7210.1016/0040-6090(84)90106-8 ↗
22. Iwaki M (1987) Tribological properties of ion-implanted steels. Mater Sci Eng 90:263–271. doi: 10.1016/0025-5416(87)90220-510.1016/0025-5416(87)90220-5 ↗
23. Onate J, Alonso F, Garcıa A (1998) Improvement of tribological properties by ion implantation. Thin Solid Films 317(1):471–47610.1016/S0040-6090(97)00564-6 ↗
24. Knapp JA, Follstaedt DM, Myers SM (2008) Hardening by bubbles in He-implanted Ni. J Appl Phys 103(1):013518. doi: 10.1063/1.283120510.1063/1.2831205 ↗
25. Was GS (1989) Ion beam modification of metals: compositional and microstructural changes. Prog Surf Sci 32(3):211–33210.1016/0079-6816(89)90005-1 ↗
26. Sharon J, Hattar K, Boyce B, Brewer L (2014) Compressive properties of <110> Cu micro-pillars after high-dose self-ion irradiation. Mater Res Lett 2(2):57–6210.1080/21663831.2013.859179 ↗
27. Ziegler JF (2004) SRIM-2003. Nucl Instrum Methods Phys Res Sect B 219:1027–1036. doi: 10.1016/j.nimb.2004.01.20810.1016/j.nimb.2004.01.208 ↗
28. Van der Pauw LJ (1958) A method of measuring specific resistivity and Hall effect of discs of arbitrary shape. Philips Res Rep 13(1):1–9
29. Grovenor CRM, Hentzell HTG, Smith DA (1984) The development of grain-structure during growth of metallic films. Acta Metall 32(5):773–781. doi: 10.1016/0001-6160(84)90150-010.1016/0001-6160(84)90150-0 ↗
30. Emery RD, Povirk GL (2003) Tensile behavior of free-standing gold films Part II. Fine-grained films. Acta Mater 51(7):2079–2087. doi: 10.1016/s1359-6454(03)00007-710.1016/S1359-6454(03)00007-7 ↗
31. Rigney D, Hirth J (1979) Plastic deformation and sliding friction of metals. Wear 53(2):345–37010.1016/0043-1648(79)90087-5 ↗
32. Hartley NEW (1976) Tribological effects in ion-implanted metals. Appl ion beams mater 1975:210–223
33. Robic JY, Piaguet J, Gailliard JP (1981) Some measurements of hardness, wear and stresses in ion-implanted thin metallic films. Nucl Instrum Methods 182:919–922. doi: 10.1016/0029-554x(81)90822-310.1016/0029-554X(81)90822-3 ↗
34. EerNisse E, Picraux S (1977) Role of integrated lateral stress in surface deformation of He-implanted surfaces. J Appl Phys 48(1):9–1710.1063/1.323332 ↗
35. Li N, Nastasi M, Misra A (2012) Defect structures and hardening mechanisms in high dose helium ion implanted Cu and Cu/Nb multilayer thin films. Int J Plast 32:1–1610.1016/j.ijplas.2011.12.007 ↗
36. Orowan E (1948) Discussion: effects associated with internal stresses. In: Symposium on internal stresses in metals and alloys, Institute of Metals, London, 1948, p 451
37. Parish CM, Miller MK (2014) Aberration-corrected X-ray spectrum imaging and fresnel contrast to differentiate nanoclusters and cavities in helium-irradiated alloy 14YWT. Microsc Microanal 20(02):613–62610.1017/S1431927614000312 ↗
38. Nes E, Ryum N, Hunderi O (1985) On the Zener drag. Acta Metall 33(1):11–2210.1016/0001-6160(85)90214-7 ↗
39. Cottrell AH, Bilby B (1949) Dislocation theory of yielding and strain ageing of iron. Proc Phys Soc Lond Sect A 62(1):4910.1088/0370-1298/62/1/308 ↗
40. Scharf TW, Prasad SV (2013) Solid lubricants: a review. J Mater Sci 48(2):511–531. doi: 10.1007/2Fs10853-012-7038-210.1007/s10853-012-7038-2 ↗