journal article·2012-12

The effect of interfacial morphology on wetting of graphite by molten silver at high temperature

Paola G. Pittoni, Yao-Yuan Chang, Shi-Yow Lin

Journal of Materials Science· Volume 47· Issue 24
Publisher page

Abstract

The wetting of graphite by molten silver was investigated at the temperature range from 1000 to 1350 °C using the sessile drop method coupled with a video-enhanced image digitization technology and a best-fitting algorithm. At the temperature range from 1100 to 1175 °C the contact angle θ was observed suddenly increasing and then decreasing, repeatedly. A similar behavior was not found in the comparison test performed on wetting of refractory (ZrO2) by molten silver at the same range of temperature. A surface analysis of the graphite used in the measurements was performed, showing a rings-shaped surface morphology. The correlation between the wetting diameters, the ring diameters and the observed drop contractions was then brought out. The measured contact angle decreases while a “trough” forms at the three phases contact line. At the observed θ sudden increase, the drop is actually “jumping out” from the trough, since the rate of the formation of the trough is lower than the rate at which the drop changes its shape. The process then starts again, with the formation of a new trough. The measured θ is obviously affected by the trough geometry.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Surface Modification and Superhydrophobicity · Nanomaterials and Printing Technologies · Additive Manufacturing and 3D Printing Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (40)

Show source-provided references
1. Naidich YV, Kolesnichenko GA (1965) Powder Metall Met Ceram 3:19110.1007/BF00773947 ↗
2. Rhee SK (1972) J Am Ceram Soc 55:30010.1111/j.1151-2916.1972.tb11289.x ↗
3. Lee J, Tanaka T, Seo K, Hirai N, Lee JG, Mori H (2006) Rare Met 25:46910.1016/S1001-0521(06)60086-7 ↗
4. Lee J, Seo K, Hirai N, Takahira N, Tanaka T (2007) Met Mater Int 13:8310.1007/BF03027556 ↗
5. Hula RC, Edtmaier C, Holzweber M, Hutter H, Eisenmenger-Sittner C (2010) Appl Surf Sci 256:469710.1016/j.apsusc.2010.02.075 ↗
6. Dezellus O, Eustathopoulos N (1999) Scripta Mater 40:128310.1016/S1359-6462(99)00082-2 ↗
7. Chang YY, Lin SY (2011) J Taiwan Inst Chem Eng 42:92210.1016/j.jtice.2011.05.005 ↗
8. Chang YY, Wu MY, Hung YL, Lin SY (2011) Rev Sci Instrum 82:05510710.1063/1.3587621 ↗
9. Lin SY, McKeigue K, Maldarelli C (1990) AIChE J 36:178510.1002/aic.690361202 ↗
10. Bashforth F, Adams JC (1883) An attempt to test the theories of capillary action by comparing the theoretical and measured forms of drops of fluid. Cambridge University Press, Cambridge
11. Padday JF (1971) Philos Trans R Soc Lond A 269:26510.1098/rsta.1971.0031 ↗
12. Rotenberg Y, Boruvka L, Neumann AW (1983) J Colloid Interface Sci 93:16910.1016/0021-9797(83)90396-X ↗
13. Huh C, Reed RL (1983) J Colloid Interface Sci 91:47210.1016/0021-9797(83)90361-2 ↗
14. Carnahan B, Luther HA, Wilkes JO (1969) Applied numerical methods. Wiley, New York
15. Carnahan RD, Johnston TL, Li CH (1958) J Am Ceram Soc 41:34310.1111/j.1151-2916.1958.tb12931.x ↗
16. Wolf SM, Levitt AP, Brown J (1966) Chem Eng Prog 62:74
17. Brennan JJ, Pask JA (1968) J Am Ceram Soc 51:56910.1111/j.1151-2916.1968.tb13324.x ↗
18. Champion JA, Keene BJ, Sillwood JM (1969) J Mater Sci 4:39. doi:10.1007/BF0055504610.1007/BF00555046 ↗
19. Saiz E, Cannon RM, Tomsia AP (1998) Acta Mater 46:234910.1016/S1359-6454(98)80016-5 ↗
20. Saiz E, Cannon RM, Tomsia AP (1999) Acta Mater 47:420910.1016/S1359-6454(99)00279-7 ↗
21. Levi G, Kaplan WD (2002) Acta Mater 50:7510.1016/S1359-6454(01)00333-0 ↗
22. Ghetta V, Chatain D (2002) J Am Ceram Soc 85:96110.1111/j.1151-2916.2002.tb00199.x ↗
23. Shen P, Fujii H, Matsumoto T, Nogi K (2003) Acta Mater 51:489710.1016/S1359-6454(03)00332-X ↗
24. Levi G, Kaplan WD (2003) Acta Mater 51:279310.1016/S1359-6454(03)00084-3 ↗
25. Ohya M, Inoue D, Itoh H, Ichinokawa T (1996) Surf Sci 369:16910.1016/S0039-6028(96)00902-8 ↗
26. Ichinokawa T, Itoh H, Sakai Y (1999) J Anal At Spectrom 14:40510.1039/a806746e ↗
27. Li JG (1994) Mater Lett 18:29110.1016/0167-577X(94)90010-8 ↗
28. Fujii H, Izutani S, Matsumoto T, Kiguchi S, Nogi K (2006) Mater Sci Eng 417:9910.1016/j.msea.2005.10.055 ↗
29. Shen P, Zhang D, Lin QL, Shi LX, Jiang QC (2010) Mater Chem Phys 122:29010.1016/j.matchemphys.2010.02.052 ↗
30. Shi L, Shen P, Zhang D, Jiang Q (2011) Appl Surf Sci 257:1074310.1016/j.apsusc.2011.07.090 ↗
31. Shanahan MER (1995) Langmuir 11:104110.1021/la00003a057 ↗
32. Moffat JR, Sefiane K, Shanahan MER (2009) J Phys Chem B 113:886010.1021/jp902062z ↗
33. Karakaya I, Thompson WT (1988) Binary alloy phase diagrams, vol 2. ASM international, Materials Park, p 18
34. Moffatt WG (1976) Handbook of binary phase diagrams, business growth services. General Electric Co., Schenectady
35. Dorfman S, Fuks D, Suery M (1999) J Mater Sci 34:77. doi:10.1023/A:100446142371710.1023/A:1004461423717 ↗
36. Eremenko VN, Naidich YV (1963) The role of surface phenomena in metallurgy. Consultants Bureau, New York, p 65
37. Knox BE, Baker EH (1972) J Mater Sci 7:476. doi:10.1007/BF0240341410.1007/BF02403414 ↗
38. Sangiorgi R, Muolo ML, Passerone A (1982) Acta Metall 30:159710.1016/0001-6160(82)90180-8 ↗
39. Hibiya T, Morohoshi K, Ozawa S (2010) J Mater Sci 45:1986. doi:10.1007/s10853-009-4107-210.1007/s10853-009-4107-2 ↗
40. Ozawa S, Morohoshi K, Hibiya T, Fukuyama H (2010) J Appl Phys 107:014910-110.1063/1.3275047 ↗