journal article·2003-08

The effect of preparation method and Sb content on SnO2-CuO sintering

I. O. Mazali, W. C. Las, M. Cilense

Journal of Materials Science· Volume 38· Issue 15
Publisher page

Abstract

The sintering behavior of SnO2-CuO system has been investigated for two preparation methods and as a function of antimony concentration. A chemical preparation (Pechini's method) resulted in powders with smaller particle sizes than for a conventional oxide mixture. This led to smaller grain sizes in Pechini's method ceramics. The microstructures were heterogeneous in both systems, showing grain coarsening. The densification was aided by liquid phase formation, due to copper, in both systems, but the temperature of maximum shrinkage rate was larger for the Pechini's method ceramic because copper had to diffuse to the grain surface. Independently of the preparation method, antimony did not aid densification, and increasing its concentration led to a higher densification temperature and lower shrinkage rate.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Copper-based nanomaterials and applications · Gas Sensing Nanomaterials and Sensors · ZnO doping and properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (27)

Show source-provided references
1. 1._ J. F. Mcaleer, P. T. Moseley, J. O. Norris and D. E. Williams, J. Chem. Soc. Faraday Trans. 83 (1987) 1323.10.1039/f19878301323 ↗
2. G. Tournier, C. Pijolat, zR. LALAUZEAND and B. Patissier, Sens. Actuators B 26/27 (1995) 24.10.1016/0925-4005(94)01549-W ↗
3. S. A. Pianaro, P. R. Bueno, E. Longo and J. A. Varela, Ceram. Int. 25 (1998) 1.10.1016/S0272-8842(97)00076-X ↗
4. M. S. Castro and C. M. Aldao, J. Eur. Ceram. Soc. 18 (1998) 2233.10.1016/S0955-2219(97)00130-1 ↗
5. D. Gouvea, A. Smith, J. P. Bonnet and J. A. Varela, ibid. 18 (1998) 345.10.1016/S0955-2219(97)00127-1 ↗
6. J. A. Varela, D. GouvÊa, E. Longo, N. Dolet, M. Onillon and J. P. Bonnet, Solid State Phenom. 25/26 (1992) 259.10.4028/www.scientific.net/SSP.25-26.259 ↗
7. J. A. Cerri, E. R. Leite, D. GouvÊa, E. Longo and J. A. Varela, J. Amer. Ceram. Soc. 79 (1996) 799.10.1111/j.1151-2916.1996.tb07949.x ↗
8. L. Perazolli, T. R. Giraldi, R. S. Biscaro, J. A. Varela and E. Longo, Sint. Sci. and Techn. (2000) 117.
9. N. Dolet, J. M. Heintz, L. Rabardel, M. Onillon and J. P. Bonnet, J. Mater. Sci. 30 (1995) 365.10.1007/BF00354397 ↗
10. P. H. Duvigneaud and D. Reinhard, Sci. Ceram. 12 (1980) 287.
11. J. Lalande, R. Ollitrault-Fichet and P. Boch, J. Eur. Ceram. Soc. 20 (2000) 2415.10.1016/S0955-2219(00)00153-9 ↗
12. J. P. Bonnet, N. Dolet and J. M. Heintz, ibid. 16 (1996) 1163.10.1016/0955-2219(96)00046-5 ↗
13. D. GouvÊa, A. Smith and J. P. Bonnet, Eur. J. Solid State Inorg. Chem. 33 (1996) 1015.
14. P. A. Cox, R. G. Egdell, C. Harding, W. R. Patterson and P. J. Tavener, Surf. Sci. 123 (1982) 179.10.1016/0039-6028(82)90322-3 ↗
15. R. G. Egdell, W. R. Flavell and P. Tavener, J. Solid State Chem. 51 (1984) 345.10.1016/0022-4596(84)90351-7 ↗
16. W. C. Las, N. Dolet, P. Dordor and J. P. Bonnet, J. Appl. Phys. 74 (1993) 6191.10.1063/1.355188 ↗
17. D. Szczuko, J. Werner, S. Oswald, G. Behr and K. Wetzig, Appl. Surf. Sci. 179 (2001) 301.10.1016/S0169-4332(01)00298-7 ↗
18. D. Szczuko, J. Werner, G. Behr, S. Oswald and K. Wetzig, Surf. Interface Anal. 31 (2001) 484.10.1002/sia.1099 ↗
19. K. Uematsu, N. Mizutani and M. Kato, J. Mater. Sci. 22 (1987) 915.10.1007/BF01103529 ↗
20. K. Uematsu, Z. Kato, N. Uchida and K. Saito, J. Amer. Ceram. Soc. 70 (1987) 142C.10.1111/j.1151-2916.1987.tb05688.x ↗
21. M. A. Zaghete, J. A. Varela, M. Cilense, C. O. Paiva-Santos, W. C. Las and E. Longo, Ceram. Inter. 25 (1999) 239.10.1016/S0272-8842(98)00029-7 ↗
22. D. GouvÊa, J. A. Varela, E. Longo, A. Smith and J. P. Bonnet, Eur. J. Solid State Inorg. Chem. 30 (1993) 915.
23. I. O. Mazali, W. C. Las and M. Cilense, J. Mater. Synth. Process. 7 (1999) 387.10.1023/A:1021822115116 ↗
24. C. V. Santilli and S. H. Pulcinelli, Cer¢mica 39 (1993) 11.
25. D. Gouvea, J. A. Varela, A. Smith and J. P. Bonnet, Eur. J. Solid State Inorg. Chem. 33 (1996) 343.
26. M. R. Sahar and M. Hasbullah, J. Mater. Sci. 30 (1995) 5304.10.1007/BF00356085 ↗
27. Y. M. Chiang, D. P. Birnie III and W. D. Kingery, “Physical Ceramics: Principles for Ceramic Science and Engineering” (John Wiley & Sons, New York, 1997) p. 407.