journal article·2008-09

Effects of the high temperature plasma immersion ion implantation (PIII) of nitrogen in AISI H13 steel

L. L. G. da Silva, M. Ueda, C. B. Mello, E. N. Codaro, C. M. Lepienski

Journal of Materials Science· Volume 43· Issue 17
Publisher page

Abstract

In this paper we report the effect of high temperature PIII of nitrogen on the chemical and physical properties of AISI H13 steel. The implantation of H13 steels was carried out at different temperatures ranging between 300 °C and 720 °C. After the treatment, the surface morphology was drastically changed as observed by SEM analysis. Nitrogen penetration depth reaching up to 12 μm was achieved at 620 °C and 720 °C. The maximum hardness of about 592 HV was obtained for the sample treated at 470 °C that is 17% higher than for untreated specimen. There was a decrease of the hardness values for temperatures above 470 °C. The same hardness behavior with the temperature was confirmed by nanoindentation testing. Although an enriched nitrogen layer was obtained, no evidence of nitride compounds was detected by XRD analyses. On the other hand, improvements of the H13 steel tribological properties and corrosion resistance were obtained. The wear tests were conducted by pin-on-disk tribometer (rotating mode). The wear volume decreased by factor of 4.5 compared to the standard tempered and annealed H13 steel and 2.6 times reduction of the coefficient of friction was achieved. The electrochemical measurements were performed in 3.5% NaCl solution, pH = 6. Open circuit potential curves showed that the potentials are nobler for the PIII treated samples than for untreated specimen. In addition, the corrosion current density of the samples treated at 620 °C and 720 °C diminished to 3 × 10−8 A/cm2.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Diamond and Carbon-based Materials Research · Ion-surface interactions and analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (19)

Show source-provided references
1. Conrad JR, Radke JI, Dodd RA, Worzala FJ, Tran NC (1987) J Appl Phys 62:4591. doi: https://doi.org/10.1063/1.33905510.1063/1.339055 ↗
2. Tóth A, Mohai M, Ujvári T, Bell T, Dong H, Bertóti I (2004) Surf Coat Tech 186:248. doi: https://doi.org/10.1016/j.surfcoat.2004.04.03110.1016/j.surfcoat.2004.04.031 ↗
3. Silva LLG, Ueda M, Nakazato RZ (2007) Surf Coat Tech 201:8291. doi: https://doi.org/10.1016/j.surfcoat.2006.03.06310.1016/j.surfcoat.2006.03.063 ↗
4. Kostov KG, Ueda M, Lepiensky M, Soares PC Jr, Gomes GF, Silva MM et al (2004) Surf Coat Tech 186:204. doi: https://doi.org/10.1016/j.surfcoat.2004.04.02710.1016/j.surfcoat.2004.04.027 ↗
5. Ueda M, Mello CB, Beloto AF, Rossi JO, Reuther H (2007) Nucl Instrum Methods Phys Res B 257:71010.1016/j.nimb.2007.01.134 ↗
6. Fouquet V, Pichon L, Straboni A, Drouet M (2004) Surf Coat Tech 186:34. doi: https://doi.org/10.1016/j.surfcoat.2004.04.00610.1016/j.surfcoat.2004.04.006 ↗
7. Silva LLG, Ueda M, Silva MM, Codaro EN (2007) IEEE Trans Plasma Sci 34:1141. doi: https://doi.org/10.1109/TPS.2006.87839110.1109/TPS.2006.878391 ↗
8. Voltz K, Ensinger W (2002) Surf Coat Tech 156:237. doi: https://doi.org/10.1016/S0257-8972(02)00098-110.1016/S0257-8972(02)00098-1 ↗
9. Mändel S, Manova D, Gerlach JW, Assmann W, Neumann H, Rauschenbach B (2004) Surf Coat Tech 180:362. doi: https://doi.org/10.1016/j.surfcoat.2003.10.13410.1016/j.surfcoat.2003.10.134 ↗
10. Zagonel LF, Figueroa CA, Alvarez F (2005) Surf Coat Tech 200:2566. doi: https://doi.org/10.1016/j.surfcoat.2004.10.12610.1016/j.surfcoat.2004.10.126 ↗
11. Zagonel LF, Figueroa CA, Droppa R Jr, Alvarez F (2006) Surf Coat Tech 201:452. doi: https://doi.org/10.1016/j.surfcoat.2005.11.13710.1016/j.surfcoat.2005.11.137 ↗
12. Hutchings R, Collins GA, Tendys J (1992) Surf Coat Tech 51:489. doi: https://doi.org/10.1016/0257-8972(92)90287-K10.1016/0257-8972(92)90287-K ↗
13. Collins GA, Hutchings R, Tendys J (1991) Mater Sci Eng A 139:171. doi: https://doi.org/10.1016/0921-5093(91)90613-R10.1016/0921-5093(91)90613-R ↗
14. Ueda M, Leandro C, Reuther H, Lepienski CM (2005) Nucl Instrum Methods B 240:204. doi: https://doi.org/10.1016/j.nimb.2005.06.11610.1016/j.nimb.2005.06.116 ↗
15. Ueda M, Berni LA, Castro RM (2005) Surf Coat Tech 200:517. doi: https://doi.org/10.1016/j.surfcoat.2005.02.14610.1016/j.surfcoat.2005.02.146 ↗
16. Bullens DK (1948) Steel and its heat treatment. Wiley, INC, New York, p 53
17. Samandi M, Pauza A, Hatziandoniou G, Yasbandha H, Hutching R, Collins GA et al (1992) Surf Coat Tech 54/55:447. doi: https://doi.org/10.1016/S0257-8972(07)80064-810.1016/S0257-8972(07)80064-8 ↗
18. Anders A (2000) Handbook of plasma immersion ion implantation and deposition. Wiley, INC, New York, p 553
19. Kariofillis GK, Kiourtsidis GE, Tsipas DN (2006) Surf Coat Tech 201:19. doi: https://doi.org/10.1016/j.surfcoat.2005.10.02510.1016/j.surfcoat.2005.10.025 ↗