Fine spherical particles of narrow size distribution in the Cr2O3-Al2O3 system
Source abstract
Abstract
The preparation of spherical particles of composite alumina-chromia nature and amorphous character by a procedure of homogeneous precipitation at 100°C for 1 h, from aqueous Al(III) and Cr(III) nitrate solutions containing sodium sulphate, urea and polyvinylpyrrolidone, is described. This method allows controlling the Cr/Al ratio and the mean size of the particles (in the nanometer and the micrometer range) by adjusting the reagents concentrations. The structural and compositional changes originated in the particles on calcination were evaluated. It was found that for alumina-rich compositions (Cr/Al mole ratio ≤0.13), the particles transformed into fully developed corundum solid solutions at much lower temperature (1000°C) than those needed for samples prepared by previously reported procedures (≥1300°C), which was attributed to the high degree of chemical homogeneity at the atomic level attained in our case. It was also observed that an increase in the Cr/Al mole ratio of the composite systems resulted in an increase of the heating temperature required for the full development of the corundum solid solution.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Glass properties and applications · Pigment Synthesis and Properties · Advanced ceramic materials synthesis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (17)
Show source-provided references
1. C. P. Poole Jr and D. S. Maciver, Advan. Catalysis 17 (1967) 223.
2. L. Baraket and A. Ghorbel, Stud. Surf. Sci. Catal. 118 (1998) 657.10.1016/S0167-2991(98)80233-4 ↗
3. Y. Hirai, T. Fukuda, Y. Kobayashi, H. Kuwahara, Y. Kido and K. Kubota, Solid State Commun. 62 (1987) 637.10.1016/0038-1098(87)90205-5 ↗
4. A. Eliseev, A. V. Lukashin and A. A. Vertegel, Chem. Mater. 11 (1999) 241.10.1021/cm980721l ↗
5. A. Atkinson, J. Doorbar, D. L. Segal and P. J. White, Key Eng. Mater. 150 (1998) 15.10.4028/www.scientific.net/KEM.150.15 ↗
6. K. Shibata, M. Yoshinaka, K. Hirota and O. Yamaguchi, Mater. Res. Bull. 32 (1997) 627.10.1016/S0025-5408(97)00015-9 ↗
7. E. MatijeviĆ, MRS Bull. 14 (1989) 18.10.1557/S0883769400060917 ↗
8. T. A. Ring, ibid. 15 (1990) 34.10.1557/S0883769400060711 ↗
9. M. Watanabe, T. Hirayama, M. Yoshinaka, K. Hirota and O. Yamaguchi, Mater. Res. Bull. 31 (1996) 861.10.1016/0025-5408(96)00064-5 ↗
10. J. L. Shi, J. H. Gao and Z. X. Lin, Solid State Ionics 32/33 (1989) 537.10.1016/0167-2738(89)90266-X ↗
11. M. OcaÑa, J. Eur. Ceram. Soc., in press.
12. Natl. Bur. Stand. (U.S.) Monogr. (1976) 25:1335.
13. J. LIVAGE, M. HENRY and C. SANCHEZ, Prog. Solid St. Chem. 18 (1988) 259.10.1016/0079-6786(88)90005-2 ↗
14. N. B. Colthup, L. H. Daly and S. E. Wiberley, “Introduction to Infrared and Raman Spectroscopy” (Academic Press, San Diego, 1990).
15. M. RistiĆ, S. PopoviĆ and S. MusiĆ, Mater. Lett. 16 (1993) 309.10.1016/0167-577X(93)90198-7 ↗
16. J. Serna, J. L. RendÓn and J. E. Iglesias, Spectrochim. Acta 38A (1982) 797.10.1016/0584-8539(82)80070-6 ↗
17. M. OcaÑa and C. J. Serna, ibid. 47A (1991) 765.10.1016/0584-8539(91)80148-C ↗