Relation between microstructures of martensite and prior austenite in 12 wt% Cr ferritic steel
Source abstract
Abstract
Tempered martensitic 9–12 wt% Cr ferritic steels are used as heat resistant materials in power plant, where service under conditions of high temperature and pressure for several decades is required, and an adequate resistance to creep is one of the key requirements. In this type of steels, failure has been found to occur preferentially at prior austenite grain boundaries if the prior austenite grains are coarse. It appears that the prior austenite grain boundaries can act as a site of especial weakness in the tempered martensitic microstructure. It would therefore be useful to investigate whether the properties of prior austenite grain boundaries could be modified by some appropriate thermomechanical processing method. One approach to this is to attempt to increase the fraction of annealing twins in the austenite phase and to investigate whether this has an effect on the properties of the martensite after transformation and tempering. In this study, thermomechanical treatments involving hot-rolling have been applied and the fraction of austenite twins produced determined using electron backscatter diffraction analysis. The treatment giving the highest fraction of austenite twins was identified and the effect of the increase in twin fraction on the characteristics of the martensite was investigated. It was found that the fraction of coincidence site lattice boundaries in martensite along prior austenite grain boundaries increased with increasing fraction of prior austenite twin boundaries.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Microstructure and Mechanical Properties of Steels · Hydrogen embrittlement and corrosion behaviors in metals · High Temperature Alloys and Creep
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (21)
Show source-provided references
1. Otsuka T, Kaneko M (2007) In: Cen K, Chi Y, Wang F (eds) Challenges of power engineering and environment, vol 1. Springer, New York, p 21410.1007/978-3-540-76694-0_39 ↗
2. Hong SH, Yu J (1989) Scripta metall 23:105710.1016/0036-9748(89)90299-8 ↗
3. Kimura K, Ohi N, Shimazu K, Matsuo T, Tanaka R, Kikuchi M (1987) Scripta metall 21:1910.1016/0036-9748(87)90399-1 ↗
4. Yardley VA, Matsuzaki T, Sugiura R, Yokobori AT Jr, Tsurekawa S, Hasegawa Y (2010) J Phys: Conf Ser 240: 01207610.1088/1742-6596/240/1/012076 ↗
5. Brooks CR, Bogni F (1997) Mater Charac 38:10310.1016/S1044-5803(97)80030-7 ↗
6. Matsui M, Tabuchi M, Watanabe T, Kubo K, Kinugawa J, Abe F (2001) ISIJ Intern 41:S12610.2355/isijinternational.41.Suppl_S126 ↗
7. Abe F, Horiuchi T, Taneike M, Sawada K (2004) Mat Sci Eng. A 378:299
8. Abe F (2008) Sci Technol Adv Mater 9:01300210.1088/1468-6996/9/1/013002 ↗
9. Abe F (2009) Mat Sci Eng 510–511:6410.1016/j.msea.2008.04.118 ↗
10. Choudhury A, Padgett RA, Brooks CR (1990) Scripta metal mater 24:159310.1016/0956-716X(90)90438-M ↗
11. Gupta G, Alexandreanu B, Was G (2004) Metall Mater Trans A 35A:71710.1007/s11661-004-0382-3 ↗
12. Was G, Alexandreanu B, Andresen P, Kumar M (2004) Mat Res Soc Symp Proc 819:N.2.1.1
13. Shimada M, Kokawa H, Wang ZJ, Sato YS, Karibe I (2002) Acta Mater 50:233110.1016/S1359-6454(02)00064-2 ↗
14. Sugiura R, Yokobori AT Jr, Takamori S, Tabuchi M, Fuji A, Yoda M, Kobayashi K, Yokobori T (2006) J Jpn Inst Met 70:45210.2320/jinstmet.70.452 ↗
15. Morito S, Tanaka H, Konishi R, Furuhara T, Maki T (2003) Acta Mater 51:178910.1016/S1359-6454(02)00577-3 ↗
16. Morito S, Yoshida H, Maki T, Huang X (2006) Mat Sci Eng 438–440:23710.1016/j.msea.2005.12.048 ↗
17. Kitahara H, Ueji R, Tsuji N, Minamino Y (2006) Acta Mater 54:127910.1016/j.actamat.2005.11.001 ↗
18. Yardley VA, Sugiura R, Matsuzaki T, Tsurekawa S, Yokobori AT Jr, Hasegawa Y (2007) Strength Fract Complex 5:3910.3233/SFC-2007-089 ↗
19. Tsurekawa S, Fukino T, Matsuzaki T (2009) Int J Mat Res 100:80010.3139/146.110119 ↗
20. Fukino T, Tsurekawa S (2008) Mater Trans 49:277010.2320/matertrans.MAW200824 ↗
21. Watanabe T (1993) Text Micro 23:195