Wear and mechanical properties of Ekonol/G/MoS2/PEEK composites
Source abstract
Abstract
High performance resin materials, such as poly(ether ether ketone) (PEEK) and its composites, are becoming more widely used as bearing, bushing and slider materials [1, 2]. Their mechanical properties and tribological behavior are, therefore, of interest and importance. Early research showed that the graphite can cooperate with MoS2 in lowering the friction coefficient of composites [3]. Ekonol has a similar crystal structure to graphite (a layer structure), and also has a high glass transition temperature, melting point and compressive strength. The purpose of this work was to modify PEEK with Ekonol and the solid lubricant (graphite and MoS2), and investigate the mechanical and tribological properties. It was believed that this work would be helpful for understanding the function of Ekonol as a main filler in PEEK and for providing guidance to the tribological application of PEEK. The preparation of the PEEK composites was shown in Fig. 1, in which raw materials were PEEK, Ekonol, G, MoS2, and other aids. In all the composites prepared, the total content of the graphite and MoS2 was kept at 8 percent, and the ratio of the graphite to MoS2 was 7 to 1. The contents of the major filler (Ekonol) was changed from 10 percent to 40 percent, at intervals of 5 percent. The composite modified only by the solid lubricant (graphite and MoS2) will be referred to as GM. Fillers were treated with a coupling agent. The mixed powders was pre-pressed in the model, heated at a rate of 10 ◦C min−1 to the temperature of 380–390 ◦C and held for 90–100 min. Then it was cooled at a rate of 5 ◦C min−1 to room temperature. The impact strength was measured on a tester of type XJJ-5, with no notch in the specimen. The bending strength and compressive strength were examined on an electron omnipotence tester of type RGT-5. The bend rate was 2 mm · min−1, and the compression rate was 1 mm · min−1. All the presented results are the average of five specimens. The friction and wear tests were conducted on a ringblock tester of type MRH-5A. The experimental parameters were: rotation speed 200 r · min−1, load 196 N and test time 2 h. All tests were carried out in dry friction state and at room temperature. The friction coefficient, μ, was calculated by the formula
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Tribology and Wear Analysis · Metal and Thin Film Mechanics · Mechanical stress and fatigue analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (4)
Show source-provided references
1. A. M. Hager and M. Davies, Adv. Comp. 8 (1993) 107.
2. Hager and Friedrich, Wear. 162 (1993) 649.10.1016/0043-1648(93)90062-Q ↗
3. Z. P. Lu and K. Friedrich, ibid. 181 (1995) 624.
4. B. H. Stuart and B. J. Briscoe, High Perform. Poly. 8 (1996) 213.