Effect of layer thickness on the mechanical behaviour of oxidation-strengthened Zr/Nb nanoscale multilayers

The mechanical behaviour and deformation mechanisms of magnetron-sputtered Zr/Nb nanoscale multilayers were analysed as a function of the periodicity (L = 10 and 75 nm) and annealing time at 350C (2-336 hrs). The strength of the as-deposited multilayers was independent of the layer thickness and it was controlled by the co-deformation of the Zr and Nb layers. Annealing led to transformation of the Zr layers into ZrO2 after a few hours, while the Nb layers oxidised at a much slower rate. The volumetric expansion associated with the oxidation led to the formation of cracks at the interfaces and within the ZrO2 layers for the multilayers with L = 75 nm but not in the case of L = 10 nm. The nanoindentation hardness increased significantly after annealing due to the contribution of the residual stresses associated with the volume increase due to oxidation and to the higher strength of the oxides. The strength increase after annealing, as measured by micropillar compression tests, was smaller than that measured by nanoindentation, as it did not include the contribution of the residual stresses, which were relieved during micropillar fabrication. The nanolaminate with L = 10 nm presented the highest strength and toughness as damage during oxidation was suppressed, and a deformation mechanism controlled by the formation of shear bands.