Alloying and Doping Control in the Layered Metal Phosphide Thermoelectric CaCuP

High Resolution Image Download MS PowerPoint Slide We recently identified CaCuP as a potential low cost, low density thermoelectric material, achieving zT = 0.5 at 792 K. Its performance is limited by a large lattice thermal conductivity, κ L, and by intrinsically large p-type doping levels. In this paper, we address the thermal and electronic tunability of CaCuP. Isovalent alloying with As is possible over the full solid solution range in the CaCuP 1– x As x series. This leads to a reduction in κ L due to mass fluctuations but also to a detrimental increase in p-type doping due to increasing Cu vacancies, which prevents zT improvement. Phase boundary mapping, exploiting small deviations from 1:1:1 stoichiometry, was used to explore doping tunability, finding increasing p-type doping to be much easier than decreasing the doping level. Calculation of the Lorenz number within the single parabolic band approximation leads to an unrealistic low κ L for highly doped samples consistent with the multiband behavior in these materials. Overall, CaCuP and slightly Cu-enriched CaCu 1.02 P yield the best performance, with zT approaching 0.6 at 873 K.