Finite element simulation of ironing process under warm conditions
Source abstract
Abstract
Metal forming is one of the most important steps in manufacturing of a large variety of products. Ironing in deep drawing is done by adjusting the clearance between the punch and the die and allow the material flow over the punch. In the present investigation effect of extent of ironing behavior on the characteristics of the product like thickness distribution with respect to temperature was studied. With the help of finite element simulation using explicit finite element code LS-DYNA the stress in the drawn cup were predicted in the drawn cup. To increase the accuracy in the simulation process, numbers of integration points were increased in the thickness direction and it was found that there is very close prediction of finite element results to that of experimental ones.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Metal Forming Simulation Techniques · Metallurgy and Material Forming · Microstructure and Mechanical Properties of Steels
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (18)
Show source-provided references
1. Dieter · 1988
2. Mathematical modelling and experimental validation of excessive ironing of EDD steel in deep drawing setup in warm conditions
3. Effect of ironing on the residual stresses in deep drawn cups10.1016/S0924-0136(99)00360-X ↗
4. The residual stress distribution in the wall of a drawn and ironed cup determined experimentally and by FE10.1016/S0007-8506(07)62206-9 ↗
5. A study on the cold ironing process for the drum clutch with inner gear shapes10.1016/j.ijmachtools.2005.07.027 ↗
6. Consideration of the re-drawing of sheet metals based on finite-element simulation10.1016/0924-0136(94)90087-6 ↗
7. Experimental and numerical dynamic modeling of ironing process10.1016/0924-0136(96)02404-1 ↗
8. Formability of Stamping Magnesium Alloy: AZ31 Sheets10.1016/S0924-0136(03)00684-8 ↗
9. Forming of high strength/low formability metal sheets at elevated temperatures
10. Simulation of aluminum sheet forming at elevated temperatures10.1016/j.cma.2005.05.054 ↗
11. Prediction of mechanical properties of extra deep drawn steel in blue brittle region using artificial neural network10.1016/j.matdes.2009.12.012 ↗
12. Formability studies of ASS 304 and aluminum and evaluation of friction in deep drawing setup at elevated temperatures using LS-DYNA
13. A study on the extent of ironing of EDD steel at elevated temperature10.1016/j.cirpj.2010.07.002 ↗
14. Understanding formability of EDD steel at elevated temperatures using finite element simulation10.1016/j.matdes.2010.04.049 ↗
15. Development of ANN model and study the effect of temperature on strain ratio and sensitivity index of EDD steel10.1007/s12289-010-0685-4 ↗
16. On the dynamic effects of explicit FEM in sheet metal forming analysis10.1108/02644409810231880 ↗
17. Evaluation of stamping lubricants using the deep drawing test10.1016/j.ijmachtools.2007.04.014 ↗
18. Development of constitutive models for dynamic strain aging regime in austenitic stainless steel 30410.1016/j.matdes.2012.09.041 ↗