Effect of Cu content on the mechanical reliability of Ni/Sn–3.5Ag system

Copper was supplied to Sn–3.5Ag by electroplating Cu/Ni double under-bump metallization (UBM), and the amount of Cu was controlled by varying the Cu UBM thickness. Supposed Cu contents in the solder were; 0.2, 0.5, and 1.0 wt%, respectively, and the solder joint microstructure was investigated after 1, 5, and 10 reflows. In the case of specimens with 0.2 and 1.0 wt% Cu, only one type of intermetallic compound (IMC) formed, either (Cu,Ni)₆Sn₅ or (Ni,Cu)₃Sn₄, while two types formed in specimen with 0.5 wt% Cu. No correlation could be found between the solder joint microstructure and the ball shear test. However, drop test results showed two opposite trends. The drop resistance of 0.2 and 1.0 wt% Cu specimens was quite good initially but degraded dramatically with multiple reflows, in contrast to that of the 0.5 wt% Cu specimen, which was very poor after one reflow but improved substantially later on. The former was ascribed to thickening of IMC during reflow, while the latter was related to (Ni,Cu)₃Sn₄ thickening beneath (Cu,Ni)₆Sn₅ and subsequent spalling of (Cu,Ni)₆Sn₅ from (Ni,Cu)₃Sn₄.