Additive manufacturing of polyamide 12 bulk structures using directed energy deposition with a thulium laser: Effect of process conditions on morphology and mechanical performance

Laser-based directed energy deposition of polymers (DED-LB/P) is a highly flexible additive manufacturing process capable of fabricating three-dimensional structures with a high degree of customization on free-form surfaces. In this article, the manufacturability of polyamide 12 bulk structures using DED-LB/P in combination with a thulium laser operating at a wavelength of 1.94 μm is investigated for the first time. The typical absorption bands at this wavelength eliminate the need for additives such as carbon-based nanoparticles, which would limit the range of applications. The generated structures were analyzed regarding porosity, thermal behavior, and mechanical properties to evaluate the potential of DED-LB/P with a thulium laser. As a consequence of the evaporation of absorbed moisture or ethanol residues resulting from powder preparation, a thermal pretreatment of the polymer powder reduced the porosity of the DED-LB/P structures to 0.9%. Depending on the processing parameters, the crystallinity of the produced structures ranged from 25.6% to 29.9%. For the tensile tests, the required geometries were milled from the DED-LB/P bulk structures. The results show that an ultimate tensile strength of up to 52 MPa, an elongation at break of up to 58%, and Young's modulus of up to 1590 MPa can be achieved. These remarkable mechanical properties are primarily attributed to the complete melting of the powder particles in DED-LB/P and the improved surface quality resulting from the milling process.