journal article·2025-12

Determination of sp2/sp3 Fractions in Diamond-Like Carbon Coatings on a Tungsten–Cobalt Base Using CKLL Auger Spectra

A. V. Sidashov, A. T. Kozakov, A. V. Nikolskiy, E. S. Novikov, D. S. Manturov

Journal of Friction and Wear· Volume 46· Issue 6
Publisher page

Abstract

Abstract The elemental composition and chemical bonds in a diamond-like carbon film on the surface of a tungsten–cobalt alloy base were studied using X-ray photoelectron spectroscopy. The ratios of sp2/sp3 bond fractions were determined using various parameters of the CKLL Auger spectra excited in X-ray photoelectron spectrometers; the average values were 0.32/0.68. It was revealed that the tribological interaction of a counterbody in the form of an aluminum oxide ball with the base material begins with a friction coefficient of approximately 0.4, and with the diamond-like film surface with a friction coefficient of approximately 1.0. With further sliding, starting from approximately 25,000 sliding cycles, the friction coefficient with the tungsten-cobalt base increases to ~0.65, and the friction coefficient with the diamond-like film drops to values of ~0.50. In the range of 20 000–25 000 sliding cycles, the friction coefficient of the counterbody on the diamond-like film drops to ~0.32, then returns to 0.62. The values characterizing the wear of the counterbody when interacting with a hard alloy base are higher than when interacting with the surface of the diamond-like film. The results confirm that films of this type are technologically feasible for use in friction units that require a combination of high deformation resistance under heavy loads and high corrosion resistance at high temperatures and in adverse environmental conditions.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Diamond and Carbon-based Materials Research · Lubricants and Their Additives · Tribology and Wear Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (15)

Show source-provided references
1. Liu, Zh., Zhao, D., Ao, J.-P., Wang, W., Chang, X., Wang, Ya., Fu, J., and Wang, H.-X., Enhanced ultraviolet photoresponse of diamond photodetector using patterned diamond film and two-step growth process, Mater. Sci. Semicond. Process., 2019, vol. 89, pp. 110–115. https://doi.org/10.1016/j.mssp.2018.08.03110.1016/j.mssp.2018.08.031 ↗
2. Jia, X., Huang, N., Guo, Yu., Liu, L., Li, P., Zhai, Zh., Yang, B., Yuan, Z., Shi, D., and Jiang, X., Growth behavior of CVD diamond films with enhanced electron field emission properties over a wide range of experimental parameters, J. Mater. Sci. Technol., 2018, vol. 34, no. 12, pp. 2398–2406. https://doi.org/10.1016/j.jmst.2018.04.02110.1016/j.jmst.2018.04.021 ↗
3. Bhaumik, A., Sachan, R., and Narayan, J., Tunable charge states of nitrogen-vacancy centers in diamond for ultrafast quantum devices, Carbon, 2019, vol. 142, pp. 662–672. https://doi.org/10.1016/j.carbon.2018.10.08410.1016/j.carbon.2018.10.084 ↗
4. Nistor, P.A. and May, P.W., Diamond thin films: Giving biomedical applications a new shine, J. R. Soc., Interface, 2017, vol. 14, no. 134, p. 20170382. https://doi.org/10.1098/rsif.2017.038210.1098/rsif.2017.0382 ↗
5. Domonkos, M., Varga, M., Ondič, L., Gajdošová, L., and Kromka, A., Microsphere lithography for scalable polycrystalline diamond-based near-infrared photonic crystals fabrication, Mater. Des., 2018, vol. 139, pp. 363–371. https://doi.org/10.1016/j.matdes.2017.10.07610.1016/j.matdes.2017.10.076 ↗
6. Williams, O.A., Nanocrystalline diamond, Diamond Relat. Mater., 2011, vol. 20, nos. 5–6, pp. 621–640. https://doi.org/10.1016/j.diamond.2011.02.01510.1016/j.diamond.2011.02.015 ↗
7. Konicek, A.R., Grierson, D.S., Gilbert, P.U.P.A., Sawyer, W.G., Sumant, A.V., and Carpick, R.W., Origin of ultralow friction and wear in ultrananocrystalline diamond, Phys. Rev. Lett., 2008, vol. 100, no. 23, pp. 235502–235505. https://doi.org/10.1103/physrevlett.100.23550210.1103/physrevlett.100.235502 ↗
8. Rani, R., Kumar, N., Kozakov, A.T., Googlev, K.A., Sankaran, K.J., Das, P.Kr., Dash, S., Tyagi, A.K., and Lin, I.-N., Superlubrication properties of ultra-nanocrystalline diamond film sliding against a zirconia ball, RSC Adv., 2015, vol. 5, no. 122, pp. 100663–100673. https://doi.org/10.1039/c5ra18832f10.1039/c5ra18832f ↗
9. Parfenov, A.S., Shilov, M.A., Smirnova, A.I., Berezina, E.V., Tkachev, A.G., Burkov, A.A., Rozhkova, N.N., and Usol’tseva, N.V., Influence of various carbon allotropes on tribological and rheological characteristics of model lubricating systems, J. Frict. Wear, 2021, vol. 42, no. 3, pp. 217–224. https://doi.org/10.3103/s106836662103013210.3103/s1068366621030132 ↗
10. Grigoriev, A., Gutsev, D.M., Kudrytski, U.G., Tran, H.V., Nguyen, T.V., Pham, T.V., Doan, P.D., Grigoriev, F.A., and Myshkin, N.K., Effect of modified graphene on the tribotechnical characteristics of electrolytic nickel–molybdenum coatings, J. Frict. Wear, 2025, vol. 46, no. 2, pp. 137–141. https://doi.org/10.3103/s106836662570039410.3103/s1068366625700394 ↗
11. Kumar, N., Sankaran, K.J., Kozakov, A.T., Sidashov, A.V., Nicolskii, A.V., Haenen, K., and Kolesnikov, V.I., Surface and bulk phase analysis of the tribolayer of nanocrystalline diamond films sliding against steel balls, Diamond Relat. Mater., 2019, vol. 97, p. 107472. https://doi.org/10.1016/j.diamond.2019.10747210.1016/j.diamond.2019.107472 ↗
12. Drijkoningen, S., Pobedinskas, P., Korneychuk, S., Momot, A., Balasubramaniam, Ya., Van Bael, M.K., Turner, S., Verbeeck, J., Nesládek, M., and Haenen, K., On the origin of diamond plates deposited at low temperature, Cryst. Growth Des., 2017, vol. 17, no. 8, pp. 4306–4314. https://doi.org/10.1021/acs.cgd.7b0062310.1021/acs.cgd.7b00623 ↗
13. Voropaev, A.I., Kolesnikov, V.I., Kudryakov, O.V., Varavka, V.N., Kolesnikov, I.V., Lifar, M.S., Guda, S.A., Guda, A.A., and Sidashov, A.V., Nitrogen-stabilized DLC coatings: Optimization of properties and deposition parameters using randomized tree and neural network algorithms, Phys. Mesomech., 2024, vol. 27, no. 4, pp. 355–369. https://doi.org/10.1134/s102995992404001510.1134/s1029959924040015 ↗
14. Kozakov, A.T., Kochur, A.G., Kumar, N., Panda, K., Nikolskii, A.V., and Sidashov, A.V., Determination of sp 2 and sp 3 phase fractions on the surface of diamond films from C1s, valence band X-ray photoelectron spectra and CKVV X-ray-excited Auger spectra, Appl. Surf. Sci., 2021, vol. 536, p. 147807. https://doi.org/10.1016/j.apsusc.2020.14780710.1016/j.apsusc.2020.147807 ↗
15. Dementjev, A.P. and Petukhov, M.N., Comparison of X-ray-excited Auger lineshapes of graphite, polyethylene and diamond, Surf. Interface Anal., 1996, vol. 24, no. 8, pp. 517–521. https://doi.org/10.1002/(SICI)1096-9918(199608)24:8<517::AID-SIA154>3.0.CO;2-L10.1002/(SICI)1096-9918(199608)24:8<517::AID-SIA154>3.0.CO;2-L ↗