Assessment of the Wear Resistance for Gearwheel Teeth in an Open Toothed Gear under the Conditions of a High Level of Dust
Source abstract
Abstract
This paper presents a method for assessing wear resistance for open toothed gears that operate under the conditions of a high level of dust. The size of abrasive particles that occur in the air in a freely suspended state and adhere to the surface of toothed gears in the course of circulation has been determined. The wear rate of a gearwheel tooth is assessed taking the dust level and the size of abrasive particles; the geometrical, kinematic, and dynamic parameters that are characteristic of toothed gears; and the mechanical properties of gearwheel materials into account.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Engineering Technology and Methodologies · Engineering and Environmental Studies · Engineering Diagnostics and Reliability
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (9)
Show source-provided references
1. Ikramov, U.A. and Irgashev, A., Calculation of tooth wear on open gears, Materialy Mezhdunarodnoi nauchno-prakticheskoi konferentsii “Problemnye voprosy mekhaniki mashinostroeniya,” Tezisy dokladov (Proc. Int. Sci.-Pract. Conf. “Problems of Mechanics of Machine Engineering,” Abstracts of Papers), Tashkent, 1993, pp. 280–281.
2. Ishmuratov, Kh.K., Wear resistance of open gears of gear teeth, Vestn. Tashk. Gos. Tekh. Univ., 2019, no. 2, pp. 175–182.
3. Irgashev, A., Mirzaev, N.N., and Irgashev, D.A., Otsenka iznosa detalei agregatov mahsin po kontsentratsiyam produktov iznosa v masle (Evaluation of Wear of Machine Units by Concentration of Wear Products in Oil), Tashkent: Tashk. Gos. Tekh. Univ., 2012.
4. Kragel’skii, I.V., et al., Osnovy raschetov na trenie, iznos (Calculations for Friction and Wear), Moscow: Mashinostroenie, 1977.
5. Vinogradov, B.V., Durability of open gears of drum mills, Metall. Gornorudn. Prom-st., 2001, no. 4, pp. 70–72.
6. Irgashev, A. and Irgashev, B.A., Iznosostoiskost’ zubchatykh peredach (Wear Resistance of Gears), Tashkent: Tashk. Gos. Tekh. Univ., 2013.
7. Dubovik, E.A., Features of gear transmission wear, Trenie Smazka Mash. Mekh., 2015, no. 3, pp. 31–35.
8. Misiewicz, P.A., Blackburn, K., Richards, T.E., Brighton, J.L., and Godwin, R.J., The evaluation and calibration of pressure mapping system for the measurement of the pressure distribution of agricultural tyres, Biosyst. Eng., 2015, vol. 130, pp. 81–91.10.1016/j.biosystemseng.2014.12.006 ↗
9. Starzhinskii, V.E., Soliterman, Yu.L., Goman, A.M., and Osipenko, S.A., Forms of damage to gear wheels: typology and recommendations on prevention, J. Frict. Wear, 2008, vol. 29, no. 5, pp. 340–353.10.3103/S1068366608050048 ↗