journal article·2021-05

Integrated Approach to Estimating the State of Rolling Bearings by Physical Methods

O. V. Kholodilov

Journal of Friction and Wear· Volume 42· Issue 3
Publisher page

Abstract

In this paper, we substantiate the use of physical methods, resistive and acoustic emission, to estimate the state of bearing assemblies. Technical means and methods for monitoring the state of rolling bearings were developed. Regularities and criteria, by which it is possible to carry out incoming inspection of bearings and estimate the quality of their manufacture, were established. A correlation between the parameters of electrical conductivity and acoustic emission during the incoming inspection of rolling bearings was established. The resistive method is shown to be more sensitive than the acoustic emission method in diagnostics of rolling bearings by the lubricant state. It is noted that for bearings without defects and with defects, the temperature recorded under the experimental conditions practically did not change and was ≈20°C. This indicates the ineffectiveness of using this parameter when carrying out incoming inspection of rolling bearings. Diagnostics of bearings on the developed stand using the described complex of physical methods allows one to exclude the use of low-quality or worn-out bearings and, therefore, to significantly reduce the number of equipment failures during operation and the associated costs.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Engineering Diagnostics and Reliability · Machine Fault Diagnosis Techniques · Material Properties and Failure Mechanisms

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (24)

Show source-provided references
1. Review of vibration methods and technical means for diagnostics of rolling bearings. http://www.vibrocenter.ru/vibro01.htm/. Accessed November 25, 2013.
2. Barkov, A.V., Diagnostics and prediction of the condition of rolling bearings based on vibration signal, Sudostroenie, 1985, no. 3, pp. 21–23.
3. Barkov, A.V., Barkova, N.A., and Azovtsev, A.Yu., Monitoring i diagnostika rotornykh mashin po vibratsii (Vibration Monitoring and Diagnostics of Rotary Machines), St. Petersburg: S.-Peterb. Gos. Morsk. Tekh. Univ., 2000.
4. Barkov, A.V. and Barkova, N.A., Vibratsionnaya diagnostika mashin i oborudovaniya. Analiz vibratsii (Vibration Diagnostics of Machines and Equipment. Vibration Analysis), St. Petersburg: S.-Peterb. Gos. Morsk. Tekh. Univ., 2004.
5. Barkova, N.A., Current state of vibroacoustic diagnostics of machines. http://www.vibrotek.ru/russian/biblioteka/book23/. Accessed November 25, 2013.
6. Markova, L.V. and Myshkin, N.K., Tribodiagnostika mahsin (Tribodiagnostics of Machines), Minsk: Belarusskaya Nauka, 2005.
7. Anur’ev, V.I., Spravochnik konstruktora-mashinostroitelya (Handbook of Machine Engineer), Moscow: Mashinostroenie, 2001, vol. 2.
8. Galakhov, M.A. and Burmistrov, A.N., Raschet podshipnikovykh uzlov (Calculation of Bearing Units), Moscow: Mashinostroenie, 1988.
9. Perel’, L.Ya., Podshipniki kacheniya: Raschet, proektirovanie i obsluzhivanie opor. Spravochnik (Rolling Bearings: Calculation, Design, and Support of Bearings. Handbook), Moscow: Mashinostroenie, 1983.
10. Pollock, A., Acoustic emission control, in Nondestructive Evaluation of Materials, ASM Handb. vol. 17, Materials Park, OH: ASM Int., 1989, pp. 278–294.
11. Sviridenok, A.I., et al., Akusticheskie i elektricheskie metody v tribotekhnike (Acoustic and Electric Methods in Tribological Engineering), Belyi, V.A., Ed., Minsk: Nauka i Tekhnika, 1987.
12. Baranov, V.M., et al., Akusticheskaya emissiya pri trenii (Acoustic Emission during Friction), Moscow: Energoatomizdat, 1998.
13. Podmaster’ev, K.V., Elektroparametricheskie metody kompleksnogo diagnostirovaniya opor kacheniya (Electroparametric Methods for Complex Diagnostics of Rolling Bearings), Moscow: Mashinostroenie, 2001.
14. Konchits, V.V., Kirpichenko, Yu.E., and Korotkevich, S.V., Temperature tests of interfaces using the contact electrical resistance method, Trenie Iznos, 1996, vol. 17, no. 4, pp. 513–526.
15. Kholodilov, O.V., et al., Analysis of extreme pressure properties of engine oils, Trenie Smazka Mash. Mekh., 2006, no. 12, pp. 6–15.
16. Bénard, J., L’Oxydation des métaux, in Monographies et Problèmes Techniques, Paris: Gauthier-Villars, 1964, vol. 2.
17. Grigor’ev, A.Ya., Kholodilov, O.V., Gutsev, D.M., Kudritskii, V.G., Korotkevich, S.V., and Kravchenko, V.V., BY Patent 23 202, 2020.
18. Kholodilov, O.V., Korotkevich, S.V., Kravchenko, V.V., and Yanchilik, A.V., BY Patent 20175, 2016.
19. Korotkevich, S.V., Pinchuk, V.G., and Bobovich, S.O., Iznosostoikost’ metallov pri granichnom trenii (Wear Resistance of Metals during Boundary Friction), Gomel: Gomel. Gos. Univ. im. F. Skoriny, 2011.
20. Belonogii, D.Yu. and Butkevich, A.V., Modeling of registration channel of the acoustic emission, Materialy II Respublikanskoi nauchno-tekhnicheskoi konferentsii molodykh uchenykh “Novye funktsional’nye materialy, sovremennye tekhnologii i metody issledovaniya,” Gomel’, 2–4 oktyabrya 2012 g., Tezisy dokladov (Proc. II Resp. Sci.-Tech. Conf. of Young Scientists “New Functional Materials, Modern Technologies, and Research Methods,” Gomel, October 2–4, 2012, Abstracts of Papers), Gomel: Inst. Mekh. Metallopolim. Sist., 2012, pp. 67–69.
21. Dubravin, A.M., Komkov, O.Yu., and Myshkin, N.K., Analysis of acoustic emission on a reciprocating microtribometer, Trenie Iznos, 2004, vol. 25, no. 4, pp. 363–367.
22. Kholodilov, O.V. and Markavtsov, A.A., Connection of primary pulse of elastic stress with a signal at the output of the measuring system, Nerazrushayushchii Kontrol Diagn., 2019, no. 1, pp. 53–61.
23. Kholodilov, O.V. and Belonogii, D.Yu., The contribution of thermoactivation component acoustic emissions while friction, Nerazrushayushchii Kontrol Diagn., 2012, no. 4, pp. 14–19.
24. Tandon, N. and Choudhury, A.A., A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearings, Tribol. Int., 1999, vol. 32, pp. 469–480.10.1016/S0301-679X(99)00077-8 ↗