Microstructure and Thermoelectric Properties of AgSbO3 Ceramics Prepared by Ion-Exchange Powder Synthesis and Normal Sintering
Source abstract
Abstract
Silver antimonate (AgSbO 3 ) is a potential high-temperature thermoelectric oxide with a low thermal conductivity, but it is difficult to fabricate dense bulk material with high phase purity. Well-dispersed AgSbO 3 nanopowder with an average diameter of 50 nm was synthesized by an ion-exchange process in this study, the sintering density of which was apparently enhanced. Nearly single-phase AgSbO 3 ceramic samples with a relative density close to 90% were obtained when sintered at a relatively low temperature (1273 K). The electrical conductivity of AgSbO 3 increased greatly with increasing sintering temperature, probably because of defects originating from the compositional deviation caused by sintering, in addition to increased density. This study also confirmed that AgSbO 3 had a low thermal conductivity, from 1.1 W m −1 K −1 at room temperature to 0.8 W m −1 K −1 at 673 K.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Thermoelectric Materials and Devices · Gas Sensing Nanomaterials and Sensors · Thermal properties of materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (18)
Show source-provided references
1. J.-F. Li, W.S. Liu, L.D. Zhao, and M. Zhou, NPG Asia Mater. 2, 152 (2010).10.1038/asiamat.2010.138 ↗
2. M. Zhou, J.-F. Li, and T. Kita, J. Am. Chem. Soc. 130, 4527 (2008).10.1021/ja7110652 ↗
3. B. Poudel, Q. Hao, Y. Ma, Y.C. Lan, A. Minnich, B. Yu, X. Yan, D.Z. Wang, A. Muto, D. Vashaee, X.Y. Chen, J.M. Liu, M.S. Dresselhaus, G. Chen, and Z. Ren, Science 320, 634 (2008).10.1126/science.1156446 ↗
4. S. Katsuyama, Y. Takagi, M. Ito, K. Majima, H. Nagai, H. Sakai, K. Yoshimura, and K. Kosuge, J. Appl. Phys. 92, 1391 (2002).10.1063/1.1489091 ↗
5. R. Funahashi and S. Urata, Int. J. Appl. Ceram. Technol. 4, 297 (2007).10.1111/j.1744-7402.2007.02144.x ↗
6. I. Terasaki, Y. Sasago, and K. Uchinokura, Phys. Rev. B 56, 12685 (1997).10.1103/PhysRevB.56.R12685 ↗
7. S.W. Li, R. Funahashi, I. Matsubara, K. Ueno, S. Sodeoka, and H. Yamada, Chem. Mater. 12, 2424 (2000).10.1021/cm000132r ↗
8. Y. Fujishiro, M. Miyata, M. Awano, and K. Maeda, J. Am. Ceram. Soc. 86, 2063 (2003).10.1111/j.1151-2916.2003.tb03610.x ↗
9. K.H. Lee, S.W. Kim, H. Ohta, and K. Koumoto, J. Appl. Phys. 101, 083707 (2007).10.1063/1.2718280 ↗
10. N. Ma, J.-F. Li, B.-P. Zhang, Y.H. Lin, L.R. Ren, and G.F. Chen, J. Phys. Chem. Solids 71, 1344 (2010).10.1016/j.jpcs.2010.06.006 ↗
11. H.Y. Sang and J.F. Li, J. Alloys Compd. 493, 678 (2010).10.1016/j.jallcom.2009.12.190 ↗
12. S. Nishiyama, A. Ichikawa, and T. Hattori, J. Ceram. Soc. Jpn. 112, 298 (2004).10.2109/jcersj.112.298 ↗
13. A.J.G. Zarbin, O.L. Alves, J.M. Amarilla, R.M. Rojas, and J.M. Rojo, Chem. Mater. 11, 1652 (1999).10.1021/cm9803915 ↗
14. H. Wiggers, U. Simon, and G. Schon, Solid State Ionics 107, 111 (1998).10.1016/S0167-2738(97)00518-3 ↗
15. M. Yasukawa, H. Hosono, N. Ueda, and H. Kawazoe, Solid State Commun. 95, 399 (1995).10.1016/0038-1098(95)00201-4 ↗
16. G.J. Snyder and E.S. Toberer, Nat. Mater. 7, 105 (2008).10.1038/nmat2090 ↗
17. T. Kako, N. Kikugawa, and J. Ye, Catal. Today 131, 197 (2008).10.1016/j.cattod.2007.10.094 ↗
18. J. Singh and S. Uma, J. Phys. Chem. C 113, 12483 (2009).10.1021/jp901729v ↗