Silicidation of Ni(Yb) Film on Si(001)
Source abstract
Abstract
The influence of the addition of Yb to Ni on the silicidation of Ni was investigated. The Ni(Yb) film was deposited on a Si(001) substrate by co-sputtering, and silicidation was performed by rapid thermal annealing (RTA). After silicidation, the sheet resistance of the silicide film was measured by the four-point probe method. X-ray diffraction and micro-Raman spectroscopy were employed to identify the silicide phases, and the redistribution of Yb after RTA was characterized by Rutherford backscattering spectrometry and Auger electron spectroscopy. The influence of the Yb addition on the Schottky barrier height (SBH) of the silicide/Si diode was examined by current–voltage measurements. The experimental results reveal that the addition of Yb can suppress the formation of the high-resistivity Ni2Si phase, but the formation of low-resistivity NiSi phase is not affected. Furthermore, after silicidation, most of the Yb atoms accumulate in the surface layer and only a small number of Yb atoms pile up at the silicide/Si(001) interface. It is believed that the accumulation of a small amount of Yb at the silicide/Si(001) interface results in the SBH reduction observed in the Ni(Yb)Si/Si diode.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Semiconductor materials and interfaces · Integrated Circuits and Semiconductor Failure Analysis · Silicon and Solar Cell Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (13)
Show source-provided references
1. J.P. Gambino, E.G. Colgan, Mater. Chem. Phys. 52, 99 (1998)10.1016/S0254-0584(98)80014-X ↗
2. S.L. Zhang, M. Ostling, Crit. Rev. Solid State Mater. Sci. 28, 1 (2003)10.1080/10408430390802431 ↗
3. C.M. Osburn, Q.F. Wang, M. Kellam, Appl. Surf. Sci. 53, 291 (1991)10.1016/0169-4332(91)90279-S ↗
4. L. Lauwers, J.A. Kittl, M.J.H. Van Dal, Mater. Sci. Eng. B-Solid State Mater. Adv. Technol. 114–15, 29 (2004)10.1016/j.mseb.2004.07.028 ↗
5. R. Mukai, S. Ozawa, H. Yagi, Thin Solid Films 270, 567 (1995)10.1016/0040-6090(95)06936-4 ↗
6. H. Iwai, T. Ohguro, S. Ohmi, Microelectron. Eng. 60, 157 (2002)10.1016/S0167-9317(01)00684-0 ↗
7. F. Deng, R.A. Johnson, P.M. Asbeck, J. Appl. Phys. 81, 8047 (1997)10.1063/1.365410 ↗
8. P.Q. Xuan, J. Bokor, IEEE Electron Device Lett. 24, 634 (2003)10.1109/LED.2003.817371 ↗
9. S.Y. Zhu, J.D. Chen, M.F. Li, IEEE Electron Device Lett. 25, 565 (2004)10.1109/LED.2004.831582 ↗
10. C.H. Wu, B.F. Hung, A. Chin, IEEE Electron Device Lett. 27, 454 (2006)10.1109/LED.2006.874778 ↗
11. R.T.P. Lee, A.E.J. Lim, K.M. Tan, IEEE Electron Device Lett. 28, 164 (2007)10.1109/LED.2006.889233 ↗
12. K. Maex, M. Van Rossum, Properties of Metal Silicides. INSPEC, IEE, London, UK, (1995)
13. E.H. Rhoderick, R.H. Williams, Metal-Semiconductor Contacts, 2nd ed. (Clarendon, Oxford, 1988)