journal article·2011-05

Distribution of Elements in a Cu-Added FeSi2 Alloy Under Peritectoid and Eutectoid Reactions

Somchai Kiatgamolchai, Aparporn Sakulkalavek

Journal of Electronic Materials· Volume 40· Issue 5
Publisher page

Abstract

The distribution of Si, Fe, and Cu in FeSi2 alloys, with or without the addition of Cu, were studied by electron probe microanalysis (EPMA). Alloys were prepared by slow solidification from the melt. Without Cu addition, both e- and α-phases were clearly observed, and a β-phase surrounding the e-phase was additionally observed after in situ annealing at 950°C for 12 h. With inclusion of 0.5 at.% Cu, the eutectoid reaction (α → β + Si) was enhanced greatly. Only 0.01 at.% Cu was dissolved into the e-phase, with the excess Cu atoms being largely found at the outer edge of the e-phase. Ex situ annealing at 950°C for 12 h greatly changed the distribution of Si, Fe, and Cu. The e-phase changed its Si/Fe atomic ratio from 1.470 to 1.907, indicating an early stage of the peritectoid reaction (e + α → β) and/or the subsequent reaction (e + Si → β), with an increase in the Cu content up to 0.04 at.%. The size of this new phase was smaller than the original e-phase, and this new phase was surrounded by a shell of Si/Fe with an atomic ratio of 0.727 to 1.788 and a Cu content of 0.01 at.% to 0.11 at.%. In situ annealing under the same condition yielded different results: a large amount of Si segregates from the α-phase matrix, leaving a Si/Fe atomic ratio of only 0.506 to 0.530. The peritectoid reaction of the e-phase was found to depend on the Cu content. For the e-phase with undetectable levels of Cu, the Si/Fe atomic ratio remained at 0.954 to 0.998, but this ratio decreased with increasing Cu content to 0.55 at 2.20 at.% Cu. A plot of at.% Cu versus Si/Fe atomic ratio revealed a local minimum at the e-phase and expectedly at both the β- and α-phases. Nonstoichiometric structures (neither α-, β- nor e-phases) seemed to have higher at.% Cu compared with those with the closest Si/Fe composition.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Metallurgical and Alloy Processes · Semiconductor materials and interfaces · Advanced Materials Characterization Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (7)

Show source-provided references
1. T. Sakata, Y. Sakai, H. Yoshino, H. Fujii, and I. Nishida, J. Less-Common Met. 61, 301 (1978).10.1016/0022-5088(78)90225-4 ↗
2. I. Yamauchi, A. Suganuma, T. Okamoto, and I. Ohnaka, J. Mater. Sci. 32, 4603 (1997).10.1023/A:1018685620758 ↗
3. S.-C. Ur and I.-H. Kim, Mater. Letter. 57, 543 (2002).10.1016/S0167-577X(02)00826-1 ↗
4. W.-S. Cho, K. Park, S.-W. Choi, and Y.-S. Yoon, Mater. Sci. Eng. B76, 200 (2000).10.1016/S0921-5107(00)00443-8 ↗
5. I. Yamauchi, H. Okamoto, A. Sugunuma, and I. Ohnaka, J. Mater. Sci. 33, 385 (1998).10.1023/A:1004323930521 ↗
6. I. Yamauchi, T. Nagase, and I. Ohnaka, J. Alloys Compd. 292, 181 (1999).10.1016/S0925-8388(99)00155-3 ↗
7. J.X. Jiang, T. Sakakawa, K. Matsugi, G. Sasaki, and O. Yanagisawa, J. Alloys Compd. 391, 115 (2005).10.1016/j.jallcom.2004.07.070 ↗