Transient Soldering Reaction Mechanisms of SnCu Solder on CuNi Nano Conducting Layer and Fracture Behavior of the Joint Interfaces
Source abstract
Abstract
Soldering can be used in the connection of thin film solar cells, while the soldering quality is difficult to control as the conducting layer on the solar cells is nano-sized and can be consumed within a few seconds. In this study, the microstructure and fracture behavior of the Sn-0.7wt.%Cu/Cu-30wt.%Ni joint interfaces were investigated. The use of CuNi conducting layer deposited on the Al/Si film with about 150 nm thickness and a soldering time of a few seconds were investigated. The results reveal that dense rod-like (Cu,Ni)6Sn5 grains with a diameter of 100–200 nm are formed at the edge of the joint interface, which gradually transform into coarsely and loosely distributed rod-like (Cu,Ni)6Sn5 grains from the edge to the inner of the solder joint. The CuNi layer is completely consumed at the inner region, and the diameter of the (Cu,Ni)6Sn5 grain were constant at about 1 μm. With longer soldering time, the width of the transition region between the fine and coarse (Cu,Ni)6Sn5 grains decrease sharply from a few hundred micrometers to about 10 μm, and the coarse rod-like (Cu,Ni)6Sn5 grains distribute throughout all the joint interface. Tensile fracture of the Cu/SnCu/CuNi solder joints occurs around the (Cu,Ni)6Sn5/CuNi interface at the edge and along the solder/Al or Al/Si interfaces at the inner region. The longer reaction time results in exhaustion of the CuNi layer, weakening of the bonding between the Al/Si/SnO2 films, and decreased joint strength from over 40 MPa to lower than 35 MPa.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Electronic Packaging and Soldering Technologies · Advanced Welding Techniques Analysis · Aluminum Alloys Composites Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (24)
Show source-provided references
1. T.D. Lee and A.U. Ebong, Renew. Sustain. Energy Rev. 70, 1286 (2017).10.1016/j.rser.2016.12.028 ↗
2. V. Jung, F. Heinemeyer, M. Köntges, and R. Brendel, Energy Procedia 38, 362 (2013).10.1016/j.egypro.2013.07.290 ↗
3. G.P. Veronese, M. Allegrezza, M. Canino, E. Centurioni, L. Ortolani, R. Rizzoli, V. Morandi, and C. Summonte, Sol. Energy Mater. Sol. Cells 138, 35 (2015).10.1016/j.solmat.2015.02.026 ↗
4. K. Chu, Y. Sohn, and C. Moon, Scr. Mater. 109, 113 (2015).10.1016/j.scriptamat.2015.07.032 ↗
5. T. Laurila, V. Vuorinen, and J.K. Kivilahti, Mater. Sci. Eng., R 49, 1 (2005).10.1016/j.mser.2005.03.001 ↗
6. L. Qu, N. Zhao, H.J. Zhao, M.L. Huang, and H.T. Ma, Scr Mater. 72–73, 43 (2014).10.1016/j.scriptamat.2013.10.013 ↗
7. H.Y. Chen and C. Chen, J. Electron. Mater. 38, 338 (2009).10.1007/s11664-008-0580-7 ↗
8. T. Geipel, M. Moeller, J. Walter, A. Kraft, and U. Eitner, Sol. Energy Mater. Sol. Cells 159, 370 (2017).10.1016/j.solmat.2016.08.039 ↗
9. W.A. Sasangka, J. Alloys Compd. 731, 1053 (2018).10.1016/j.jallcom.2017.10.106 ↗
10. H.F. Zou, H.J. Yang, and Z.F. Zhang, Acta Mater. 56, 2649 (2008).10.1016/j.actamat.2008.01.055 ↗
11. P.S. Lee, D. Mangelinck, K.L. Pey, J. Ding, D.Z. Chi, J.Y. Dai, and A. See, J. Electron. Mater. 30, 1554 (2001).10.1007/s11664-001-0173-1 ↗
12. Y.H. Xia, X.M. Xie, C.Y. Lu, and J.L. Chang, J. Alloys Compd. 417, 143 (2006).10.1016/j.jallcom.2005.09.051 ↗
13. H.J. Ji, Y.F. Qiao, and M.Y. Li, Scr. Mater. 110, 19 (2016).10.1016/j.scriptamat.2015.07.036 ↗
14. V. Vuorinen, H. Yu, T. Laurila, and J.K. Kivilahti, J. Electron. Mater. 37, 792 (2008).10.1007/s11664-008-0411-x ↗
15. T.M. Korhonen, P. Su, S.J. Hong, M.A. Korhonen, and C.Y. Li, J. Electron. Mater. 29, 1194 (2000).10.1007/s11664-000-0012-9 ↗
16. T. Laurila, V. Vuorinen, and M. Paulasto-Kröckel, Mater. Sci. Eng., R 68, 1 (2010).10.1016/j.mser.2009.12.001 ↗
17. H. Zhao, D.R. Nalagatla, and D.P. Sekulic, J. Electron. Mater. 38, 284 (2009).10.1007/s11664-008-0590-5 ↗
18. Satyanarayan and K.N. Prabhu, Adv. Colloid Interface Sci. 166, 87 (2011).10.1016/j.cis.2011.05.005 ↗
19. O.Y. Liashenko and F. Hodaj, Scr. Mater. 127, 24 (2017).10.1016/j.scriptamat.2016.08.035 ↗
20. M.A.A.M. Salleh, S.D. McDonald, H. Yasuda, A. Sugiyama, and K. Nogita, Scr. Mater. 100, 17 (2015).10.1016/j.scriptamat.2014.11.039 ↗
21. M.F. Arenas, M. He, and V.L. Acoff, J. Electron. Mater. 35, 1530 (2006).10.1007/s11664-006-0144-7 ↗
22. L. Zhang, J.G. Han, Y.H. Guo, and L. Sun, Sol. Energy Mater. Sol. Cells 130, 397 (2014).10.1016/j.solmat.2014.07.034 ↗
23. M.J. Brand, E.I. Kolp, P. Berg, T. Bach, P. Schmidt, and A. Jossen, J. Energy Storage 12, 45 (2017).10.1016/j.est.2017.03.019 ↗
24. D.S. Liu and C.Y. Ni, Microelectron. Eng. 63, 363 (2002).10.1016/S0167-9317(02)00551-8 ↗