Tensile Behavior of Single-Crystal Tin Whiskers
Source abstract
Abstract
The growth of metallic (predominantly Sn) whiskers from pure metallic platings has been studied for over 50 years. While the phenomenon of Sn whiskering has been studied for decades, very little is known about the mechanical properties of these materials. This can be attributed to the difficulty in handling, gripping, and testing such fine-diameter and high-aspect-ratio whiskers. We report on the stress–strain behavior of Sn whiskers inside a dual-beam focused ion beam (FIB) with a scanning electron microscope (SEM). Lift-out of the whiskers was conducted in situ in the FIB, and the whiskers were tested using a microelectromechanical system tensile testing stage. Using this technique, the whiskers had minimum exposure to ambient air and were not handled by hand. SEM images after fracture enabled reliable calculation of the whisker cross-sectional area. Tests on two different whiskers revealed relatively high tensile strengths of 720 MPa and 880 MPa, respectively, and a limited strain to failure of 2% to 3%. For both whiskers, the Young’s modulus was between 42 GPa and 45 GPa. It is interesting to note that the whiskers were quite strong and had limited ductility. These findings are intriguing and provide a basis for further work to understand the effect of Sn whisker mechanical properties on short circuits in electronics.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Electronic Packaging and Soldering Technologies · Metal and Thin Film Mechanics · Integrated Circuits and Semiconductor Failure Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (18)
Show source-provided references
1. G.T. Gaylon, IEEE Trans. Electron. Packag. Manuf. 28, 94 (2005).10.1109/TEPM.2005.847440 ↗
2. S. Mathew, M. Osterman, M. Pecht, and F. Dunlevey, Circuit World 35, 3 (2009).10.1108/03056120910928662 ↗
3. 100% Sn plating whisker growth study. http://www.amd.com , 10 January 2003.
4. M. Sobiech, M. Wohlschlogel, U. Welzel, E.J. Mittemeijer, W. Hugel, A. Seekamp, W. Liu, and G.E. Ice, Appl. Phys. Lett. 94, 221901 (2009).10.1063/1.3147864 ↗
5. S.-K. Lin, Y. Yorikado, J. Jiang, K.-S. Kim, K. Suganuma, S.-W. Chen, M. Tsujimoto, and I. Yanada, J. Electron. Mater. 36, 1732 (2007).10.1007/s11664-007-0284-4 ↗
6. J.W. Osenbach, R.L. Shook, B.T. Vaccaro, B.D. Potteiger, A.N. Amin, K.N. Hooghan, P. Suratkar, and P. Ruengsinsub, IEEE Trans. Electron. Packag. Manuf. 28, 36 (2005).10.1109/TEPM.2005.847438 ↗
7. B.E. Powell and M.J. Skove, J. Appl. Phys. 36, 1495 (1965).10.1063/1.1714343 ↗
8. B.D. Dunn, Eur. Space Agency (ESA) J. 11, 1 (1987).
9. M.A. Dudek and N. Chawla, Acta Mater. 57, 4588 (2009).10.1016/j.actamat.2009.06.031 ↗
10. J. Rajagopalan, C. Rentenberger, H.P. Karnthaler, G. Dehm, and M.T.A. Saif, Acta Mater. 58, 4772 (2010).10.1016/j.actamat.2010.05.013 ↗
11. J. Rajagopalan and M.T.A. Saif, J. Mater. Res. 26, 2826 (2011).10.1557/jmr.2011.316 ↗
12. J.H. Han and M.T.A. Saif, Rev. Sci. Instrum. 77, 045102 (2006).10.1063/1.2188368 ↗
13. J.H. Han, J. Rajagopalan, and M.T.A. Saif, Proc. SPIE 6464, 64640C (2007).10.1117/12.706115 ↗
14. M.A. Haque and M.T.A. Saif, Exp. Mech. 42, 123 (2002).10.1007/BF02411059 ↗
15. M.W. Barsoum, E.N. Hoffman, R.D. Doherty, S. Gupta, and A. Zavaliangos, Phys. Rev. Lett. 93, 206104 (2004).10.1103/PhysRevLett.93.206104 ↗
16. B.-Z. Lee and D.N. Lee, Acta Mater. 46, 3701 (1998).10.1016/S1359-6454(98)00045-7 ↗
17. X. Deng, M. Koopman, N. Chawla, and K.K. Chawla, Mater. Sci. Eng. A 364, 240 (2004).10.1016/j.msea.2003.08.032 ↗
18. W.D. Callister, Introduction to Materials Science and Engineering, 7th ed. (New York: Wiley, 2007).