Illumination Effects on the Capacitance Spectra and Signal Quality Factor of Al/InSe/C Microwave Sensors
Source abstract
Abstract
Amorphous indium selenide thin films have been used in the design of a microwave-sensitive Schottky barrier. The illumination effects on the capacitance spectra, on the signal quality factor, and on the capacitance (C)–voltage (V) characteristics of the Al/InSe/C device are investigated. Particular shifts in the amplitude and in the resonance peaks of the capacitance spectra which were studied in the frequency range of 10.0 kHz to 3.0 GHz are observed. While the photoexcitation of these devices increased the capacity level by ∼1.6 times the original magnitude, the dark quality factor, which was 2.2 × 106 at 3.0 GHz, fell to 1.2 × 106 when subjected to luminance of 14.7 klux. Analysis of the C–V curves recorded at signal power ranging from wireless local area network (LAN) levels to the maximum output power of third generation (3G) mobiles reflected high tunability of capacitance upon increasing the voltage or power. The tunability of the biased capacitance was much more pronounced in the light than in the dark. The obtained characteristics of the Al/InSe/C sensors indicate their usability in radio and microwave technology.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Semiconductor materials and interfaces · Phase-change materials and chalcogenides · Chalcogenide Semiconductor Thin Films
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (21)
Show source-provided references
1. M. Soylu, A.A. Al-Ghamdi, and F. Yakuphanoglu, Microelectron. Eng. 99, 50 (2012).10.1016/j.mee.2012.07.046 ↗
2. G. Gordillo and C. Calderon, Solar Energy Mater. Solar Cells 77, 163 (2003).10.1016/S0927-0248(02)00319-7 ↗
3. S. Marsillac and J.C. Bernede, Thin Solid Films 315, 5 (1998).10.1016/S0040-6090(97)00462-8 ↗
4. J.C. Bernede and S. Marsillac, Mater. Res. Bull. 32, 1193 (1997).10.1016/S0025-5408(97)00090-1 ↗
5. V.N. Katerinchuk and M.Z. Kovalyuk, Sov. Phys. Semicond. 25, 577 (1991).
6. D. Manno, M.D. Digiulio, T. Siciliano, E. Filippo, and A. Serra, J. Phys. D Appl. Phys. 34, 2097 (2001).10.1088/0022-3727/34/14/303 ↗
7. M.A. Kenway, A.F. El-Shazly, M.A. Afifi, H.A. Zayed, and H.A. El-Zahid, Thin Solid Films 200, 205 (1991).
8. V.M. Koshkin, L.P. Galchinetskii, V.M. Kulik, and B.L. Minkove, Solid Stat. Commun. 13, 1 (1973).10.1016/0038-1098(73)90054-9 ↗
9. W.-J. Li, Y.-N. Zhou, and Z.-W. Fu, Appl. Surf. Sci. 257, 2881 (2011).10.1016/j.apsusc.2010.10.085 ↗
10. K. Yılmaz, M. Parlak, and Ç. ErÇelebi, Semicond. Sci. Technol. 22, 1268 (2007).10.1088/0268-1242/22/12/004 ↗
11. C. Viswanathan, S. Gopal, M. Thamilselvan, K. PremNazeer, D. Mangalaraj, Sa.K. Narayandass, J. Yi, and D.C. Ingram, J. Mater. Sci.: Mater. Electron. 15, 787 (2004).10.1023/B:JMSE.0000045300.00451.51 ↗
12. A.F. Qasrawi, Phil. Mag. 90, 3027 (2010).10.1080/14786431003767041 ↗
13. T. Koschny, P. Markoˇs, D.R. Smith, and C.M. Soukoulis, Phys. Rev. E 68, 065602(R) (2003).10.1103/PhysRevE.68.065602 ↗
14. A.F. Qasrawi, S.M.S. Elayyat, and N.M. Gasanly, Cryst. Res. Technol. 47, 615 (2012).10.1002/crat.201200057 ↗
15. G. Hammer, S. Wuensch, K. Ilin, and M. Siegel, J. Phys.: Conf. Series 97, 012044 (2008).10.1088/1742-6596/97/1/012044 ↗
16. A. Van der Ziel, Solid State Physical Electronics, 2nd ed. (Englewood Cliffs: Prentice-Hall, 1968).
17. A.F. Qasrawi, Opt. Mater. 29, 1751 (2007).10.1016/j.optmat.2006.09.009 ↗
18. I. Dokme, D.E. Yildiz, and S.E. Altindal, Adv. Polym. Technol. 31, 63 (2012).10.1002/adv.20236 ↗
19. S. Demirezen, S. Altındal, and I. Uslu, Curr. Appl. Phys. 13, 53 (2013).10.1016/j.cap.2012.06.009 ↗
20. T.-Y. Hsieh, T.-C. Chang, T.-C. Chen, M.-Y. Tsai, Y.-T. Chen, Y.-C. Chung, H.-C. Ting, and C.-Y. Chen, ECS J. Solid State Sci. Technol. 1, Q6 (2012).10.1149/2.018201jss ↗
21. A. Goswami and A.P. Goswami, Thin Solid Films 16, 175 (1973).10.1016/0040-6090(73)90166-1 ↗