journal article·2014-07

Thermoelectric Properties of Magnesium Silicide Deposited by Use of an Atmospheric Plasma Thermal Spray

Gaosheng Fu, Lei Zuo, Jon Longtin, Chao Nie, Yikai Chen, Mahder Tewolde, Sanjay Sampath

Journal of Electronic Materials· Volume 43· Issue 7
Publisher page

Abstract

The thermoelectric properties of magnesium silicide (Mg2Si) samples prepared by use of an atmospheric plasma spray (APS) were compared with those of samples prepared from the same feedstock powder by use of the conventional hot-pressing method. The characterization performed included measurement of thermal conductivity, electrical conductivity, Seebeck coefficient, and figure of merit, ZT. X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy dispersive x-ray spectroscopy (EDX) were used to assess how phase and microstructure affected the thermoelectric properties of the samples. Hall effect measurements furnished carrier concentration, and measurement of Hall mobility provided further insight into electrical conductivity and Seebeck coefficient. Low temperature and high velocity APS using an internal-powder distribution system achieved a phase of composition similar to that of the feedstock powder. Thermal spraying was demonstrated in this work to be an effective means of reducing the thermal conductivity of Mg2Si; this may be because of pores and cracks in the sprayed sample. Vacuum-annealed APS samples were found to have very high Seebeck coefficients. To further improve the figure of merit, carrier concentration must be adjusted and carrier mobility must be enhanced.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Intermetallics and Advanced Alloy Properties · Semiconductor materials and interfaces · Superconductivity in MgB2 and Alloys

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (33)

Show source-provided references
1. S.C. Davis and S.W. Diegel, Transportation Energy Data Book (Oak Ridge, Tenn: Oak Ridge National Laboratory, 2012).
2. J.H. Yang and F.R. Stabler, J. Electron. Mater. 38, 1245 (2009).10.1007/s11664-009-0680-z ↗
3. D.H. Wei, X.S. Lu, Z. Lu, and J.M. Gu, Energy Convers. Manag. 48, 1113 (2007).10.1016/j.enconman.2006.10.020 ↗
4. N. Ishikawa, Int. J. Engine Res. 13, 99 (2012).10.1177/1468087411434885 ↗
5. T. Katrasnik, S. Rodman, F. Trenc, A. Hribernik, and V. Medica, J. Eng. Gas Turbines Power Trans. Asme 125, 590 (2003).10.1115/1.1563246 ↗
6. P. Patel, MIT Technology Review (2011).
7. G. Min, D.M. Rowe, and K. Kontostavlakis, J. Phys. D 37, 1301 (2004).10.1088/0022-3727/37/8/020 ↗
8. G. Busch and U. Winkler, Helv. Phys. Acta 26, 395 (1953).
9. R.G. Morris, R.D. Redin, and G.C. Danielson, Phys. Rev. 109, 1909 (1958).10.1103/PhysRev.109.1909 ↗
10. R.J. Labotz, D.R. Mason, and D.F. Okane, J. Electrochem. Soc. 110, 127 (1963).10.1149/1.2425689 ↗
11. V.K. Zaitsev, M.I. Fedorov, E.A. Gurieva, I.S. Eremin, P.P. Konstantinov, A.Y. Samunin, and M.V. Vedernikov, Phys. Rev. B 74, 045207 (2006).10.1103/PhysRevB.74.045207 ↗
12. Y. Isoda, S. Tada, T. Nagai, H. Fujiu, and Y. Shinohara, Mater. Trans. 51, 868 (2010).10.2320/matertrans.MH200906 ↗
13. J.Y. Jung and I.H. Kim, Electron. Mater. Lett. 6, 187 (2010).10.3365/eml.2010.12.187 ↗
14. K.S. Shida, K. Shiraishi, T. Ito, M. Omori, and T. Hirai, Thermoelectric figure of merit of impurity doped and hot-pressed magnesium silicide elements, 1998.
15. K.S. Shida, S. Suhihara, M. Ohmori, and T. Hirai, Thermoelectric properties of magnesium silicide processed by powdered elements plasma activated sintering method, 1997.
16. J. Tani and H. Kido, Physica B Condens. Matter. 364, 218 (2005).10.1016/j.physb.2005.04.017 ↗
17. M. Akasaka, T. Iida, T. Nemoto, J. Soga, J. Sato, K. Makino, M. Fukano, and Y. Takanashi, J. Cryst. Growth 304, 196 (2007).10.1016/j.jcrysgro.2006.10.270 ↗
18. D. Tamura, R. Nagai, K. Sugimoto, H. Udono, I. Kikuma, H. Tajima, and I.J. Ohsugi, Thin Solid Films 515, 8272 (2007).10.1016/j.tsf.2007.02.065 ↗
19. Q. Li, Z.W. Lin, and J. Zhou, J. Electron. Mater. 38, 1268 (2009).10.1007/s11664-008-0628-8 ↗
20. S. Sampath, J. Therm. Spray Technol. 19, 921 (2010).10.1007/s11666-010-9475-2 ↗
21. J. Zhou, Q. Jie, L.J. Wu, I. Dimitrov, Q. Li, and X. Shi, J.␣Mater. Res. 26, 1842 (2011).10.1557/jmr.2011.79 ↗
22. J.P. Longtin, L. Zuo, D. Hwang, G.S. Fu, M. Tewolde, Y.K. Chen, and S. Sampath, J. Therm. Spray Technol. 22, 577 (2013).10.1007/s11666-013-9903-1 ↗
23. L. Zuo, J.P. Longtin, S. Sampath, Q. Li, and B. Li, DOE, Thermoelectrics Workshop (2011).
24. G. Fu, L. Zuo, J.P. Longtin, C. Nie, Y.K. Chen, M. Tewolde, and S. Sampath, Fall MRS at Boston (2012).
25. M. Cherigui, N.E. Fenineche, and C. Coddet, Surf. Coat. Technol. 192, 19 (2005).10.1016/j.surfcoat.2004.02.023 ↗
26. J. Schilz, E. Muller, K. Schackenberg, H. Ernst, W.A. Kaysser, G. Langer, and E. Lugscheider, J Mater. Sci. Lett. 17, 1487 (1998).10.1023/A:1026486703748 ↗
27. Y.T. Makita, H. Takahashi, H. Shibata, N. Kobayashi, M. Hasegawa, S. Kimura, A. Obara, J. Tanabe, and S. Uekusa, Optical, electrical and structural properties of polycrystallinel beta-FeSi 2 thin films fabricated by electron beam evaporation of ferrosilicon, 1996.
28. S.S. Sodeoka, M. Suzuki, A. Tsutsumi, K. Kuramoto, J. Sawazaki, K. Yoshida, H. Huang, K. Nagai, H. Kondo, and S. Nakahama, Fabrication of large size FeSi 2 thermoelectric device by thermal spraying process, 1998.
29. W.G. Chi, S. Sampath, and H. Wang, J. Am. Ceram. Soc. 91, 2636 (2008).10.1111/j.1551-2916.2008.02476.x ↗
30. N.P. Padture, M. Gell, and E.H. Jordan, Science 296, 280 (2002).10.1126/science.1068609 ↗
31. L. Pawlowski, The science and engineering of thermal spray coatings (2008).10.1002/9780470754085 ↗
32. N.D.H. Arora, J.R. Hauser, and D.J. Roulston, IEEE Trans. Electron. Devices 29, 292 (1982).10.1109/T-ED.1982.20698 ↗
33. Y.F. Hu, E. Sutter, W.D. Si, and Q. Li, Appl Phys Lett 87, 171912 (2005).10.1063/1.2117615 ↗