journal article·2002-05

A study of moisture diffusion in plastic packaging

Xia Cai, Weidong Huang, Bulu Xu, Gisela Kaltenpoth, Zhaonian Cheng

Journal of Electronic Materials· Volume 31· Issue 5
Publisher page

Abstract

The absorption and desorption processes of moisture in plastic material were studied with experimental measurement and finite element (FE) simulation. The diffusion coefficient and the saturate concentration were determined by experiment and simulation results with Fick's law. The water molecules inside the plastic material were chemically bonded with polymers by hydrogen bonds in the microholes formed by the polymer molecule chains. On the saturate concentration, the moisture density in the effective volumes was 100 times larger than the vapor density in standard state. However. it is only 8% of liquid water. The water inside the plastic material was in a liquid situation. The delamination and the delamination recovery of flip-chip packaging inspected by C-mode scanning acoustic microscropy (C-SAM) during a high-temperature and high-humidity accelerating test could be explained with the state change of the water in plastic material space. The delamination recovery resulted from the increase in content of liquid water. The bonding of water molecules and polymers reduced the adhesive strength at the interface between epoxy material and die, and the delamination on the interface was initiated. A comparison of three cases with noncoated film, top-side SiCx coated, and both-sides SiCx coated indicated that the delamination would occur when the moisture concentration was between 50% and 95% of the saturate concentration. During the reflow process, the low interface-adhesive strength and the high vapor pressure of the wet sample might cause popcorning of the plastic packaging. Popcorning could be predicted by simulation of the moisture concentration at the interface.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Electronic Packaging and Soldering Technologies · Material Properties and Processing · Mechanical Behavior of Composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (17)

Show source-provided references
1. S. Luo, J. Leisen, and C.P. Wong, Proc. of 4th Int. Symp. on Electronic Packaging Technology (Piscataway, NJ: IEEE, 2001) p. 133.
2. J.H. Wu, N.S. Fang, and J.C. Lu, 1st Int. Symp. on High Density Packaging & Component Failure Analysis in Electronics Manufacturing (Piscataway, NJ: IEEE, 1998) p. 13.
3. W. Tong and A. Teng, Proc. Int. Symp. on Electronic Materials and Packaging (Piscataway, NJ: IEEE, 2000) p. 464.
4. K. Yamamoto, Jpn. J. Appl. Phys. 34, 2043 (1995).10.1143/JJAP.34.2043 ↗
5. T.C. Wong and L.J. Broutman, Polymer Eng. Sci. 25, 529 (1985).10.1002/pen.760250904 ↗
6. M.R. Vanlandingham, R.F. Eduljee, and J.W. Gillespie, Jr., J. Appl. Polymer Sci. 71, 787 (1999).10.1002/(SICI)1097-4628(19990131)71:5<787::AID-APP12>3.0.CO;2-A ↗
7. C.L. Soles and A.F. Yee, J. Polymer Sci. Part B: Polymer Phys. 38, 792 (2000).10.1002/(SICI)1099-0488(20000301)38:5<792::AID-POLB16>3.0.CO;2-H ↗
8. C.L. Soles, F.T. Chang, B.A. Hristov, D.W. Gidley, and A.F. Yee, J. Polymer Sci. Part B: Polymer Phys. 36, 3035 (1998).10.1002/(SICI)1099-0488(199812)36:17<3035::AID-POLB4>3.0.CO;2-Y ↗
9. M.J. Adamson, J. Mater. Sci. 15, 1736 (1980).10.1007/BF00550593 ↗
10. D.W. Van Krevelen, Properties of Polymers, 3rd ed. (Amsterdam: Elsevier, 1991), p. 334.
11. C.G.L. Khoo and J. Liu, Circuit World 22, 9 (1996).
12. R.P. Prasad, Surface Mount Technology: Principles and Practice, (New York: Van Nostrand Reinhold, 1989), p. 184.
13. T.O. Steiner and D. Suhl, IEEE Trans. Comp., Hybrid, Manuf. Technol. 10, 209 (1987).10.1109/TCHMT.1987.1134724 ↗
14. V. Gektin and A. Bar-Cohen, Proc. Int. Soc. Conf. Thermal Phenomena in Electronic Systems, I-THERMV (Piscataway, NJ: IEEE, 1996), p. 306.
15. M.G. Pecht and A. Govind, IEEE Trans. Comp., Packag., Manuf. Technol. C 20, 207 (1997).10.1109/3476.649442 ↗
16. C. Alger, W.A. Huffman, S. Gordon, S. Prough, R. Sandkuhle, and K. Yee, IPC Tech. Rev. 192 (1988).
17. S. Ohizumi, Proc. IEEE 40th Electron. Comp. Technol. Conf. (Piscataway, NJ: IEEE, 1990), p. 632.