journal article·2003-04

Solderability testing of 95.5Sn-3.9Ag-0.6Cu solder on oxygen-free high-conductivity copper and Au-Ni-Plated kovar

Edwin P. Lopez, Paul T. Vianco, Jerome A. Rejent

Journal of Electronic Materials· Volume 32· Issue 4
Publisher page

Abstract

The solderability of 95.5Sn-3.9Ag-0.6Cu solder on oxygen-free high-conductivity (OFHC) copper and Au-Ni-plated Kovar was examined as a function of flux and process temperature. The three solder fluxes included a rosin-based (R) material, a rosin mildly activated (RMA) flux, and a low-solids (LS) flux. The solderability metric was the contact angle, θC, measured by a meniscometer and wetting-balance techniques. The wetting rate and time to maximum force parameters were also documented. In most cases, the contact angles for the 95.5Sn-3.9Ag-0.6Cu solder alloy, regardless of the type of flux or temperature, were higher then those for the 63Sn-37Pb eutectic-solder alloy, indicating a less “solderable” surface.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Electronic Packaging and Soldering Technologies · Metal and Thin Film Mechanics · Copper Interconnects and Reliability

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (4)

Show source-provided references
1. B. Richards, An Analysis of the Current Status of Lead-Free—Update 2000 (Uxbridge, UK: Middlesex Centre for Materials and Measurement Technology, 2000).
2. Kovar is a registered trademark of Carpenter Technologies, Reading, PA.
3. P. Vianco, Solder. Surf. Mt. Technol. 24, 12 (1996).10.1108/09540919610777708 ↗
4. R.J. Klein Wassink, Soldering in Electronics (Ayr, Scotland: Electrochemical Publications Limited, 1984), p. 235.