Dissimilar Ti/Mg alloy butt welding by fibre laser with Mg filler wire – preliminary study

A fibre laser was used to join Ti–6Al–4V alloy to AZ31B Mg alloy with the same thickness of 2 mm, and a filler wire was used to avoid weld underfill resulting from Mg vaporisation. The acceptable joints were only obtained when the laser beam was offset from the edge of the weld seam at 0·2 mm to the AZ31B side of the joint. Cross-weld tensile testing found joint strengths of up to 200·3 MPa, which is 85·1% of the AZ31B tensile strength. All the joints were fractured at the Ti/fusion zone interfacial layer. When the laser offset increased from 0·2 to 0·3 mm or laser power reduced to 1·2 kW, the joining mode of the interfacial layer changed from a semimetallurgical joining with high strength to a mechanical joining with poor strength. Moreover, the fracture surface of acceptable joints was characterised by scraggly remaining weld metal, while that of poor joints was almost only characterised by smooth Ti surface.