journal article·2011-07

Specific surface area of clay minerals: Comparison between atomic force microscopy measurements and bulk-gas (N2) and -liquid (EGME) adsorption methods

Felix Macht, Karin Eusterhues, Geertje Johanna Pronk, Kai Uwe Totsche

Applied Clay Science· Volume 53· Issue 1
Publisher page

Abstract

Abstract The specific surface area of natural particles is an important parameter to quantify processes such as mineral dissolution and sorptive interactions in soils and sediments. In this study, the external specific surface area (SSA), specific edge surface area (ESA) and specific basal surface area (BSA) of an illite (Inter-ILI) and a montmorillonite (Ceratosil) were determined by atomic force microscopy (AFM) and compared with the SSA obtained by N 2 gas adsorption (BET) and by liquid adsorption using ethylene glycol monomethyl ether (EGME). For the illite we found an SSA of 41 ± 3 m 2 g − 1 by BET and of 83 ± 5 m 2 g − 1 by analysing 54 particles by AFM. For the montmorillonite BET we estimated a SSA of 61 ± 2 m 2 g − 1 , whereas the analysis of 62 particles by AFM images gave a much larger mean SSA of 346 ± 37 m 2 g − 1 . We assume that the sample treatment prior to AFM imaging (involving dispersion by NaOH in a dilute dispersion and sonication for 2 min) resulted in delamination of the clay mineral particles. The ESA was 5.6 ± 0.4 m 2 g − 1 for the illite, and 15 ± 2 m 2 g − 1 for the montmorillonite. This leads to an ESA/BSA ratio of 0.07 for the illite and 0.05 for the montmorillonite for the delaminated particles. For the untreated, non-delaminated particles we calculated an ESA/BSA ratio of 0.16 for the illite and of 0.27 for the montmorillonite. The specific surface area as estimated by EGME was 112 m 2 g − 1 for the illite and 475 m 2 g − 1 for the montmorillonite, i.e. about 30–40% larger than the respective AFM values. However, this difference in specific surface area was not in agreement with the expected interlayer surface area of both minerals.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Soil and Unsaturated Flow · Clay minerals and soil interactions · Groundwater flow and contamination studies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (31)

Show source-provided references
1. Micropore size distributions of clay mineral systems10.1111/j.1365-2389.1967.tb01481.x ↗
2. Quantifying surface areas of clays by atomic force microscopy10.2138/am-2002-5-622 ↗
3. Tactoid size and osmotic swelling in calcium montmorillonite10.2136/sssaj1961.03615995002500030009x ↗
4. The dissolution of hectorite: in-situ, real-time observations using atomic force microscopy10.2138/am-2000-8-914 ↗
5. Adsorption of gases in multimolecular layers10.1021/ja01269a023 ↗
6. Ethylene glycol monoethyl ether for determining surface area of silicate minerals
7. Comparison of various methods for the determination of specific surfaces of subsoils10.1111/j.1365-2389.1991.tb00422.x ↗
8. BET measurements: outgassing of minerals10.1006/jcis.2000.6880 ↗
9. Phosphate adsorption and desorption in relation to morphology and crystal properties of synthetic hematites10.1016/0016-7037(94)90380-8 ↗
10. T-curve of multimolecular N2-adsorption10.1016/0095-8522(66)90006-7 ↗
11. Baseline studies of The Clay Minerals Society special clays: specific surface area by the Brunauer Emmett Teller (BET) method10.1346/CCMN.2007.0550508 ↗
12. AFM and low-pressure argon adsorption analysis of geometrical properties of phyllosilicates10.1016/j.jcis.2005.09.028 ↗
13. Repercussions of size heterogeneity on the measurement of specific surface areas of colloidal minerals: combination of macroscopic and microscopic analyses10.2138/am-2004-1013 ↗
14. Surface chemistry of soil minerals
15. Influence of layer charge density on the determination of the internal surface area of smectites
16. N2-BET specific surface area of bentonites10.1016/j.jcis.2010.05.018 ↗
17. Klinkenberg, 2008: Einfluss des Mikrogefüges auf ausgewählte petrophysikalische Eigenschaften von Tongesteinen und Bentoniten. Ph.D. thesis (in german), Georg-August-Universiät Göttingen, http://webdoc.sub.gwdg.de/diss/2008/klinkenberg/.
18. Towards the establishment of a reliable proxy for the reactive surface area of smectite10.1016/j.gca.2004.11.009 ↗
19. Meunier · 2005
20. Surface Area and Porosity
21. Fourier-transform infrared study of ethylene-glycol monoethyl ether adsorbed on montmorillonite—implications for surface-area measurements of clays10.1346/CCMN.1987.0350108 ↗
22. Textural effects in powdered montmorillonite induced by freeze-drying and ultrasound pretreatment10.1016/j.clay.2005.10.002 ↗
23. Pennell, K.D., 2002. Aggregate specific surface area, in: Dane, J.H. and Topp, G.C. (Eds.), Part 4. Physical Methods, Soil Science Society of America Book Series, Vol. 5, Madison, pp. 295–315.10.2136/sssabookser5.4.c13 ↗
24. Appraisal of the ethylene glycol monoethyl ether method for measuring hydratable surface area of clays and soils10.2136/sssaj1999.634839x ↗
25. Effects of exchanged cation on the microporosity of montmorillonite10.1346/CCMN.1997.0450405 ↗
26. Surface area of montmorillonite from dynamic sorption of nitrogen and carbon dioxide10.1346/CCMN.1968.0160110 ↗
27. Limitations of EGME retention to estimate the surface-area of soils10.1071/SR9900001 ↗
28. Nanomorphology of montmorillonite particles: estimation of the clay edge sorption site density by low-pressure gas adsorption and AFM observations10.2138/am-2003-11-1243 ↗
29. Tröger · 1982
30. Van Olphen · 1979
31. Van Reeuwijk · 2002