journal article·2025-10Open access

Thermal deformation behavior and microstructural evolution of AlZnMgCu/TiB2 alloy

Bowen Pang, Ziyu He, Zhong Liu, Xiaodong Zhao, Kai Lu, Yun Zhao, Xiaogang Li, Yanxiang Shi, Lu Li, Zhaolin Zhan, Wenshen Tang

Abstract

AlZnMgCu/TiB 2 alloy was thermally compressed at temperatures of 390–450 °C and strain rates of 0.001–0.5 s −1 . The flow curves, constitutive equations, 3D processing maps, microstructures, and related mechanisms of the composite were studied, and the results are discussed. The results indicate that TiB 2 ceramic particles have a significant influence on the rheological stress curve of the studied alloy. The true stress–strain curves take the form of a broad flow stress peak at high strain rate deformations (0.1–0.5 s −1 ) due to TiB 2 inducing dynamic equilibrium between dynamic softening and dynamic recrystallization (DRX). A modified strain-compensated Arrhenius constitutive model was constructed that accurately describes the rheological behavior of the alloy. The thermal deformation activation energy Q was evaluated as 123,815 J·mol –1 , which was reduced by the presence of the TiB 2 ceramic particles. Hot-processing map analysis revealed the thermal deformation characteristics of the AlZnMgCu/TiB 2 alloy at 390–450 °C within the strain rate range 0.001–0.5 s −1 . Areas of flow instability were identified. Electron back-scattering diffraction (EBSD) analysis of the AlZnMgCu/TiB 2 alloy under different thermal deformation conditions revealed the microstructure evolution. The processes of dynamic recovery (DRV)/DRX were enhanced with increasing deformation and decreasing strain rate, resulting in sufficient DRX and the distribution of second-phase particles at the subgrain boundaries and recrystallization grain boundaries.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Microstructure and mechanical properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (49)

Show source-provided references
1. Study on hot deformation behavior and dynamic recrystallization mechanism of recycled Al–Zn–Mg–Cu alloy10.1016/j.jmrt.2024.10.163 ↗
2. Investigation of constitutive models and microstructure evolution during hot deformation and solution treatment of Al–Zn–Mg–Cu alloy10.1016/j.jmrt.2024.07.201 ↗
3. Enhancing mechanical properties of Al-Zn-Mg-Cu alloys: the impact of high strain rate compression and subsequent heat treatment on microstructural evolution
4. Strain hardening exponent and strain rate sensitivity exponent of cast AZ31B magnesium alloy10.3390/met12111942 ↗
5. Gradient microstructure and superior strength–ductility synergy of AZ61 magnesium alloy bars processed by radial forging with different deformation temperatures10.1016/j.jmst.2023.07.003 ↗
6. Investigation on mechanical and morphological behaviours of Al–Zn–Mg–Cu/(SiC + Al2O3) Hybrid Composites Produced by Squeeze Casting
7. Achieving uniform microstructure and excellent mechanical properties in TiB2/7055 composite via additive friction stir deposition and heat treatment
8. Effect of TiB2 particles on dynamic recrystallization in TiB2-reinforced Al–Zn–Mg–Cu–Zr during hot compression10.1016/j.msea.2024.146891 ↗
9. Interfacial precipitation of the in-situ TiB2-reinforced Al–Zn–Mg–Cu–Zr composite10.1016/j.matchemphys.2023.127561 ↗
10. Effects of co-addition of minor sc and zr on aging precipitates and mechanical properties of Al–Zn–Mg–Cu alloys10.1016/j.jmrt.2022.12.133 ↗
11. Hot compressive deformation characteristics of Al-9.3Zn-2.4Mg-1.1Cu alloy10.1007/s11595-024-2934-2 ↗
12. Dynamic recrystallization nucleation mechanism and precipitation behavior of homogeneous Al-Zn-Mg-Cu alloy during hot deformation10.3390/met14040449 ↗
13. Hot deformation behavior and microstructure evolution of Al-7.92 Zn-1.64 Mg-2.00 cu alloy10.3390/met14020176 ↗
14. Investigation on deformation behaviors and dynamic recrystallization mechanism of spray formed Al–Zn–Mg–Cu alloy under hot compression10.1016/j.jmrt.2024.01.055 ↗
15. Influence of strain rate on hot deformation behavior and recrystallization behavior under isothermal compression of Al-Zn-Mg-Cu alloy10.1016/j.jallcom.2019.151788 ↗
16. Hot deformation behavior and microstructural evolution of as-quenched 7055 al alloy fabricated by powder hot extrusion10.1016/j.matchar.2019.109833 ↗
17. Effect of er on the hot deformation behavior of the crossover Al3Zn3Mg3Cu0.2Zr alloy10.3390/met14101114 ↗
18. Hot deformation and processing map of a typical Al–Zn–Mg–Cu alloy10.1016/j.jallcom.2012.10.114 ↗
19. Microstructural evolution and dynamic softening mechanisms of Al-Zn-Mg-Cu alloy during hot compressive deformation10.3390/ma7010244 ↗
20. Hot deformation mechanism of a rapidly-solidified Al–Zn–Mg–Cu–Zr alloy10.1016/j.jmrt.2024.06.216 ↗
21. Dynamic recrystallization mechanisms and microstructure evolution of a novel Al-Zn-Mg-Cu-Zr alloy by isothermal compression10.1016/j.jmrt.2024.09.200 ↗
22. Effect of extrusion ratio on microstructure evolution and mechanical properties of ultra-high-strength Al-Zn-Mg-Cu-Zr-Sc alloy10.1016/j.msea.2025.147903 ↗
23. Investigation on microstructural evolution of spray formed Al-Zn-Mg-Cu alloy during hot extrusion processes and subsequent solution treatment
24. Hot deformation behavior of a highly alloyed Al-10.0Zn-2.6Mg-1.2Cu-0.15Zr alloy prepared by electromagnetic stirring casting
25. Effects of strain rate on flow stress behavior and dynamic recrystallization mechanism of Al-Zn-Mg-Cu aluminum alloy during hot deformation10.1016/j.msea.2016.03.027 ↗
26. Atomic-scale investigation of the interface precipitation in a TiB2 nanoparticles reinforced Al–Zn–Mg–Cu matrix composite10.1016/j.actamat.2019.11.068 ↗
27. Revealing the precipitation behavior of crack-free TiB2/Al-Zn-Mg-Cu composites manufactured by laser powder bed fusion
28. Microstructure and mechanical response of TiB2/Al–Zn–Mg–Cu composites with more addition of zn10.1016/j.jallcom.2019.152584 ↗
29. Microstructure evolution from homogeneous as-cast state to annealed heterogeneous structure and mechanical properties of Al-Zn-Mg-Cu alloys with trace TiB2 particles
30. Hot deformation behavior and microstructural evolution of a TiB2/Al-Zn-Mg-Cu-Zr composite10.3390/ma17071487 ↗
31. Multi-scale study of microstructure evolution in hot extruded nano-sized TiB2 particle reinforced aluminum composites10.1016/j.matdes.2016.12.070 ↗
32. Investigation of the hot deformation behavior and microstructure evolution of TiB2 + TiAl3/2024Al composite10.1016/j.jallcom.2022.167765 ↗
33. A new set of physically-based unified viscoplastic constitutive equations for superplastic deformation of Al-Zn-Mg-Cu alloy10.1016/j.mechrescom.2022.103904 ↗
34. Constitutive base analysis of a 7075 aluminum alloy during hot compression testing10.1016/j.matdes.2011.05.040 ↗
35. Flow behavior modeling of the 7050 aluminum alloy at elevated temperatures considering the compensation of strain10.1016/j.matdes.2012.06.032 ↗
36. Constitutive model and processing maps of 7055 aluminum alloy used for fasteners
37. Hot deformation behavior of aluminum alloys: a comprehensive review on deformation mechanism, processing maps analysis and constitutive model description
38. Prediction on hot deformation behavior of spray-formed 7055 aluminum alloy via phenomenological models10.1016/S1003-6326(18)64789-2 ↗
39. Study of the constitutive behavior of 7075-T651 aluminum alloy10.1016/j.ijimpeng.2017.05.002 ↗
40. A unified constitutive model and microstructure evolution of a solution treated 7075 aluminum alloys under warm forming condition10.1016/j.jmrt.2024.04.101 ↗
41. Constitutive model and microstructure evolution of thermal deformation behavior of in situ TiB2p/Al-Zn-Mg-Cu composites with high zn content
42. Study of dynamic recrystallization behavior of Al-Zn-Mg-Cu-Er-Zr alloy during isothermal compression10.1016/j.jmrt.2024.12.119 ↗
43. Constitutive equation and dynamic recovery mechanism of high strength cast Al-Cu-Mn alloy during hot deformation
44. Effect of initial grain size on hot deformation behavior and recrystallization mechanism of Al-Zn-Mg-Cu alloy10.1016/j.matchar.2024.114012 ↗
45. Dynamic precipitation and recrystallization behavior during hot deformation of Al-Zn-Mg-Cu alloy: experiment and modeling10.1016/j.ijplas.2024.103995 ↗
46. Recrystallization behavior of an Al-Zn-Mg-Cu alloy during hot deformation and subsequent heat treatment
47. On the mechanism of hot deformation [J]10.1016/0001-6160(66)90207-0 ↗
48. Problems in non-elastic deformation of metals [J]10.1063/1.1707696 ↗
49. Hot deformation behavior and processing map of a new type Al-Zn-Mg-Er-Zr alloy10.1016/j.jallcom.2016.06.254 ↗