Novel sol-gel route for expanding the glass forming region of tin phosphate glass for secondary battery electrode applications
Source abstract
Abstract
In this paper, tin-phosphate amorphous glass and nano-crystallized ceramic materials were synthesized by sol-gel methods and heat treated at 400 °C with the composition of xSnO2− (100-x)P2O5 (xSnP: ‘x’ from 40 to 90 mol%). The electrical and thermal properties of tin-phosphate materials were investigated by electrical impedance spectroscopy (EIS) and thermogravimetry – differential thermal analysis – mass spectroscopy (TG–DTA–MS). Moreover, the local structure of xSnP was characterized by 119Sn-Mössbauer and magic angle spinning (MAS) 31P NMR spectroscopies. Homogeneous glasses were obtained for xSnP with ‘x’ from 50 to 80, while Sn(HPO4), SnO2, and Sn3(PO4)2 nanoparticles formed in 40SnP and 90SnP compositions, respectively. The nano-crystallized 40SnP and 90SnP samples showed large electrical conductivity (σ) of 2.02×10−5 and 1.04×10−4 S cm−1 due to the conductive crystalline phases of SnP2O7 and defective SnO2, respectively. The lower σ of about 10−8 S cm−1 were recorded for xSnP with ‘x’ from 50 to 80 owing to the decomposition of the 3D network built by phosphate tetrahedrons. 119Sn-Mössbauer spectra proved the growing number of SnIVO6 units, which do not contribute to the rise of electrical conductivity. On the other hand, larger σ values of 1.79×10−4 and 6.4×10−3 S cm−1 were confirmed for 40SnP and 90SnP samples after heat treatment, resulting in partial reduction of SnIV to SnII and growing of the 3D network structure by PO43−. It is concluded that highly electrically conductive xSnP samples can be synthesized by the sol-gel method followed by slow heat treatment. In addition, the battery evaluation was performed of xSnP samples as cathode and anode in a sodium-ion battery. The highest initial capacity recorded for 90SnP nano-crystallized ceramic at 37.97 mAh g−1 under a current rate of 20 mA g−1 with capacity retention (%) of 48.15% after 100 cycles as a cathode material. The anode test showed that the 40SnP nano-crystallized ceramic has the largest initial capacity of 375 mAh g−1 and after heat treatment 50SnP glass significantly increased to 425 mAh g−1 compared with 186 mAh g−1 before heat treatment. Also, the heat treatment effect on the initial capacity of 90SnP nano-crystallized ceramic with observation largest value of 470 mAh g−1. These results open the way to maybe applying these glass and nano-crystallized ceramic materials in all-solid-state batteries.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advancements in Battery Materials · Advanced Battery Materials and Technologies · Transition Metal Oxide Nanomaterials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (66)
Show source-provided references
1. Advances of lithium-ion batteries anode materials—a review10.1016/j.ceja.2023.100569 ↗
2. Photocatalytic and cathode active abilities of Ni-Substituted α-FeOOH nanoparticles10.3390/ijms241814300 ↗
3. Enhancement of the electrochemical performance of LiCoPO4 by Fe doping10.1016/j.ceramint.2021.08.065 ↗
4. Building better batteries10.1038/451652a ↗
5. 2021 roadmap for sodium-ion batteries
6. Pressure less all solid-state sodium-ion battery consisting of sodium iron pyrophosphate glass ceramic cathode and β″-alumina solid electrolyte composite10.1111/jace.16607 ↗
7. Enhanced rate capabilities in a glass-ceramic-derived sodium all-solid-state battery10.1038/s41598-020-66410-1 ↗
8. Synthesis and Na+ ion conductivity of stoichiometric Na3Zr2Si2PO12 by liquid-phase sintering with NaPO3 glass10.3390/ma14143790 ↗
9. Electrical conductivity of Na2O–Nb2O5–P2O5 glass and fabrication of glass–ceramic composites with NASICON type Na3Zr2Si2PO1210.1016/j.ssi.2014.11.009 ↗
10. Research development on sodium ion batteries10.1021/cr500192f ↗
11. Stabilizing tin anodes in sodium-ion batteries by alloying with silicon10.1021/acsaem.0c01641 ↗
12. Influence of M/A substitution on material properties of intermetallic compounds MSn2 (M = Fe, and Co; A = Li, and Na): a first-principles study10.1039/D0NJ04537C ↗
13. Single-crystal intermetallic M-Sn (M = Fe, Cu, Co, Ni) nanospheres as negative electrodes for lithium-ion batteries10.1021/am100218v ↗
14. Amorphous bimetallic Co3Sn2 nanoalloys are better than crystalline counterparts for sodium storage10.1021/acs.jpcc.5b05232 ↗
15. Coexistence of Sn and FeSn2 nanoparticles dispersed in glass-ceramics and their electrochemical performance as sodium-ion battery anode
16. Electrochemical performance of In2O3-coated LiFePO4 as a cathode material in lithium-ion batteries10.1007/s10971-022-05927-5 ↗
17. Klein · 2018
18. Structural characterization and magnetic properties of iron-phosphate glass prepared by sol-gel method10.1016/j.jnoncrysol.2020.120158 ↗
19. Preparation of Proton Conductive Crystallized Tin Phosphate Glasses by Hydrothermal Treatments10.1002/pssa.201800355 ↗
20. Tin-phosphate glass anode for sodium ion batteries10.1063/1.4826938 ↗
21. New photo-Fenton type catalyst of soda-lime aluminosilicate glass prepared by recycling waste slag–a review10.1007/s10967-023-09127-5 ↗
22. Doped graphene encapsulated SnP2O7 with enhanced conversion reactions from polyanions as a versatile anode material for sodium dual-ion battery10.1016/j.electacta.2020.137657 ↗
23. Amorphous Sn(HPO4)2-derived phosphorus-modified Sn/SnOx core/shell catalyst for efficient CO2 electro reduction to formate10.1016/j.jechem.2022.12.022 ↗
24. Electric fatigue of BCZT ceramics sintered in different atmospheres10.1007/s00339-019-3062-2 ↗
25. Effect of P2O5 content in two series of soda lime phosphosilicate glasses on structure and properties -Part I NMR10.1016/j.jnoncrysol.2008.03.034 ↗
26. Formation of metaphosphate hydrogels and their proton conductivities10.1016/j.jnoncrysol.2005.01.066 ↗
27. structural study of sol-gel and melt quenched phosphate based glasses10.1016/j.jnoncrysol.2007.02.008 ↗
28. Solid state 29Si and 31P NMR study of gel derived phosphosilicate glasses10.1039/b004107f ↗
29. Sol-gel synthesis of SiO2•P2O5 glasses10.1016/0022-3093(94)90077-9 ↗
30. Local structure of Si and P in SiO2•P2O5 and Na2O•SiO2•P2O5 glasses: A XANES study10.1016/0022-3093(95)00100-X ↗
31. Network Structure and Connectivity in SnO-P2O5 Glasses, Results from 2D 31P and 119Sn NMR Spectroscopy10.1021/acs.jpcb.8b04236 ↗
32. Extreme behavior of Li-ion conductivity in the Li2O-Al2O3-P2O5 glass system10.1016/j.jnoncrysol.2015.10.003 ↗
33. Vibrational characterization of the various forms of (solvated or unsolvated) mobile proton in the solid state. Advantages, limitations and open questions10.1016/j.ssi.2023.116187 ↗
34. Nanoscale Hydration in Layered Manganese Oxides10.1021/acs.langmuir.0c02592 ↗
35. the impact of gallium ions on borosilicate glasses for structural, optical and biological applications10.1007/s11082-023-05677-w ↗
36. The structure and properties of xZnO-(67-x)SnO-P2O5 glasses: (I) optical and thermal properties, Raman and infrared spectroscopies10.1016/j.jnoncrysol.2018.01.030 ↗
37. FTIR and XPS studies of P2O5-Na2O-CuO glasses10.1016/S0022-3093(99)00011-3 ↗
38. Structure and ionic transport studies of sodium boro phosphate glassy system10.1016/j.matchemphys.2004.09.029 ↗
39. Influence of cobalt oxide on the structure, optical transitions and ligand field parameters of lithium phosphate glasses10.1016/j.ceramint.2021.07.011 ↗
40. Structure and red-ox chemistry of tin in SnO-NaPO3 pseudo-binary glasses10.1016/S0022-3093(01)00804-3 ↗
41. Enhancement of structural and optical properties of transparent sodium zinc phosphate glass-ceramics nanocomposite10.1007/s41779-022-00716-3 ↗
42. Enhancement of Electrical Conductivity and Thermal Stability of Iron- or Tin- substituted Vanadate Glass and Glass-Ceramics nanocomposite to be applied as a High-Performance Cathode Active Material in Sodium-Ion Batteries10.1016/j.jallcom.2022.167366 ↗
43. 57Fe and 119Sn Mössbauer, XRD, FTIR and DC conductivity study of Li2O-Fe2O3-SnO2-P2O5 glass and glass ceramics10.1016/j.jallcom.2018.06.207 ↗
44. Mössbauer effect in inorganic glasses10.1007/BF02146303 ↗
45. Debye Temperature Evaluation for Secondary Battery Cathode of α-SnxFe1−xOOH Nanoparticles Derived from the 57Fe- and 119Sn-Mössbauer Spectra10.3390/ijms25052488 ↗
46. Delving into the properties of nanostructured Mg ferrite and PEG composites: A comparative study on structure, electrical conductivity, and dielectric relaxation10.1016/j.heliyon.2023.e19745 ↗
47. Investigation of pressure dependence of anisotropy and elastic modulus of SbSI compound in ferroelectric phase by Ab initio method10.1016/j.mseb.2023.116787 ↗
48. 119Sn-Mössbauer, IR, and DSC study of tin oxyfluoride glasses10.1007/BF02063749 ↗
49. Structural and electrical properties of Li2O-ZnO-P2O5 glasses
50. Ionic Conductivity of Lithium Germanium Phosphate Glass-Ceramics10.1021/acs.jpcc.9b03666 ↗
51. Impact of adding Fe ions on the local structure and electrochemical performance of P2O5–V2O5 glass and glass ceramics used as a cathode in LIBs10.1016/j.jpcs.2023.111391 ↗
52. Insight on the weak hopping conduction produced by titanium ions in the lead borate glassy system10.1016/j.materresbull.2021.111323 ↗
53. Glass anode crystallization for high specific capacity Lithium-ion batteries10.1016/j.cej.2022.136228 ↗
54. Structural and electrochemical properties of Li2O-V2O5-B2O3-Bi2O3 glass and glass-ceramic cathodes for lithium-ion batteries10.3390/molecules28010229 ↗
55. Structural, electrical, and electrochemical properties of a Na2O-V2O5 ceramic nanocomposite as an active cathode material for a Na-Ion battery10.3390/cryst13101521 ↗
56. Compositional dependence of properties of SnO-P2O5 glasses10.2109/jcersj2.116.915 ↗
57. Preparation and characterization of SnO–P2O5 glasses as anode materials for lithium secondary batteries10.1016/j.jnoncrysol.2004.08.069 ↗
58. SnP2O7 covered carbon nanosheets as a long-life and high-rate anode material for sodium-ion batteries10.1002/adfm.201804672 ↗
59. Preparation of binder-free MoP/SnO2 carbon fiber composites with Cu-mediated surface modification for high-rate sodium ion storage
60. Revisiting and enhancing electrochemical properties of SnO2 as anode for sodium-ion batteries10.1007/s10008-020-04779-9 ↗
61. Electrochemical performance and structural change during charge–discharge reaction of SnO–P2O5 glassy electrodes in rechargeable lithium batteries10.1016/j.jnoncrysol.2007.07.047 ↗
62. A Proton-Conducting In3+-Doped SnP2O7 Electrolyte for Intermediate-Temperature Fuel Cells10.1149/1.2159298 ↗
63. Electrical conductivity, Seebeck coefficient and optical properties of SnO2 film deposited on ITO by dip coating10.1016/j.jallcom.2008.03.013 ↗
64. Performance of Lithium-Ion battery with Tin-phosphate glass anode and Its Characteristics10.1149/2.049310jes ↗
65. Tin-phosphate glass anode for sodium ion batteries10.1063/1.4826938 ↗
66. Formation of highly dispersed tin nanoparticles in amorphous silicates for sodium ion battery anode10.1016/j.jpcs.2021.110377 ↗