Effect of Ca addition on structure, phase composition and hardness of Al–6 %Cu–2 %Mn sheet alloy

The Al–Cu–Mn–Ca system was proposed as a bases for the design of new group of heat-resistant alloys which can be used for high-temperature applications instead of the 2219 types industrial alloys. Unlike the latter ones, the new alloys also do not require a full cycle of strengthening heat treatment including solid solution treatment, quenching and aging. The effect of calcium addition in the 1–4 wt% range on the structure, phase composition and hardness after high temperature annealing of the Al–6 %Cu–2 %Mn base sheet alloy has been studied. It has been shown that calcium addition leads to the formation of high-temperature eutectics (614–617 °С) with the participation of the Al ₂₇Ca ₃Cu ₇ and (Al,Cu) ₄Ca phases that are capable of spheroidization at high temperature annealing. The ingots of Ca-containing alloys do not require homogenization but have sufficient deformation plasticity at both hot and cold rolling. The structure of the previously unstudied quaternary Al–Cu–Mn–Ca phase diagram in the region of the aluminum corner has been also proposed, according to which it can contain 5 four-phase fields in the solid state with the participation of (Al), binary (Al ₂Cu, Al ₄Ca, Al ₆Mn) and ternary (Al ₈CaCu ₄, Al ₂₇Ca ₃Cu ₇, Al ₁₀CaMn ₂ and Al ₂₀Cu ₂Mn ₃) phases. Based on the obtained data, the composition Al–6 %Cu–2 %Mn–1 %Ca has been proposed as a basis for the development of a new heat-resistant alloy. It is shown that this alloy superior to industrial 2219 alloy in terms of heat resistance, especially after annealing at 400 °C, when the difference in hardness reaches 32 HV. The high heat resistance of the new wrought alloy originates from the formation of a specific microstructure consisting of fine Ca-containing eutectic inclusions and Al ₂₀Cu ₂Mn ₃ phase dispersoids with a size of about 100 nm which prevent recrystallization and allow maintaining the fine sub-grained structure.