journal article·2024-12

Temperature dependence on γ/γ' partitioning behaviors of alloying elements and γ/γ' interfacial energy of a Mo-rich Ni based single crystal superalloy

Cheng Ai, Jiahui Yang, Yi Ru, Heng Zhang, Shusuo Li, Shengkai Gong, Xinhao Dang, Min Guo, Taiwen Huang, Lin Liu

Publisher page

Abstract

Based on three-dimensional atom probe technique and Ardell method, the influences of temperature (850℃∼1150℃) on microstructure, compositions and solid solution strengths of γ and γ′ phases, γ/γ` partitioning behaviors of alloying elements and γ/γ` interfacial energy of a Mo-rich Ni based single crystal superalloy were investigated. After quenching from 1100℃, microstructure was basically similar as heat-treated state. However, after quenching from 1150℃, γ′ phase obviously re-dissolved, and γ channel obviously widened. Meanwhile, with increasing temperature, Co, Cr, Mo and Re contents in γ phase decreased, while Al and Ta contents in γ phase increased. With increasing temperature, Co, Cr and Re contents in γ′ phase slightly decreased, Mo content in γ′ phase significantly decreased, while Al and Ta contents in γ′ phase increased. Meanwhile, with increasing temperature, solid solution strength of γ phase decreased, while solid solution strength of γ′ phase increased. In addition, with increasing temperature, partitioning ratios of Co, Cr and Re elements decreased, partitioning ratios of Mo and Al elements increased, while partitioning ratio of Ta firstly decreased and then increased. Moreover, both γ/γ′ interfacial width and γ/γ′ interfacial energy decreased with increasing temperature.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: High Temperature Alloys and Creep · Advanced Materials Characterization Techniques · Intermetallics and Advanced Alloy Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (62)

Show source-provided references
1. Reed · Superalloys Fundam. Appl. · 200610.1017/CBO9780511541285 ↗
2. Microstructural evolution and creep mechanisms in Ni-based single crystal superalloys: a review10.1016/j.jallcom.2019.152954 ↗
3. Determining the precipitation temperature of secondary γ′ phases by remelting method in Ni-based single crystal superalloys10.1016/j.intermet.2023.108017 ↗
4. Nano-cutting deformation characteristics and atomic-scale behavior of two-phase γ/γ′ nickel-based single crystal superalloy10.1016/j.intermet.2023.107985 ↗
5. The creep behaviors of single crystal Ni-based superalloys with slant film cooling holes10.1016/j.intermet.2023.108026 ↗
6. A new approach of designing superalloys for low density10.1007/s11837-010-0011-0 ↗
7. Chapter 63 Dislocations and high-temperature plastic deformation of superalloy single crystals10.1016/S1572-4859(02)80014-6 ↗
8. Solid solution hardening of nickel—role of transition metal and B-subgroup solutes10.2320/matertrans1960.27.656 ↗
9. The effect of lattice misfit on the dislocation motion in superalloys during high-temperature low-stress creep10.1016/j.actamat.2005.06.013 ↗
10. Dependence of creep strength on the interfacial dislocations in a fourth generation SC superalloy TMS-13810.1016/S1359-6462(02)00379-2 ↗
11. Interfacial dislocation networks strengthening a fourth-generation single-crystal TMS-138 superalloy10.1007/s11661-002-0246-7 ↗
12. Microstructure and mechanical properties of Ni3Al-based single crystsal alloy IC21
13. Improved 1200°C stress rupture property of single crystal superalloys by γ′-forming elements addition10.1016/j.scriptamat.2017.12.023 ↗
14. Elements distribution and deformation features of a 4.5% Re nickel-based single crystal superalloy during creep at high temperature10.1016/j.matchar.2018.05.017 ↗
15. The alloying behaviour and mechanical properties of polycrystalline Ni3Al (γ′ phase) with ternary additions10.1007/BF00543696 ↗
16. Improved creep strength of nickel-base superalloys by optimized γ/γ′ partitioning behavior of solid solution strengthening elements10.1016/j.msea.2016.08.121 ↗
17. Partitioning behavior and lattice misfit of γ/γ′ phases in Ni-based superalloys with different Mo additions10.1007/s12598-019-01309-z ↗
18. Temperature dependence of element partitioning in rhenium and ruthenium bearing nickel-base superalloys10.1016/j.msea.2010.08.091 ↗
19. The effect of long-term thermal exposures on the microstructure and properties of CMSX-10 single crystal Ni-base superalloys10.1016/j.msea.2004.04.001 ↗
20. Effect of thermal exposure on the microstructure and creep properties of a fourth-generation Ni-based single crystal superalloy10.1016/j.jmst.2020.07.008 ↗
21. Application of a modified Ostwald ripening theory in coarsening of γ′ phases in Ni based single crystal superalloys10.1016/j.jallcom.2015.01.215 ↗
22. Role of Re and Co on microstructures and γ′ coarsening in single crystal superalloys10.1016/j.msea.2007.06.031 ↗
23. Coarsening kinetics of γ′ precipitates in a Re-containing Ni-based single crystal superalloy during long-term aging10.1016/j.jmst.2020.05.034 ↗
24. Trans-interface diffusion-controlled coarsening10.1038/nmat1340 ↗
25. The kinetics of precipitation from supersaturated solid solutions10.1016/0022-3697(61)90054-3 ↗
26. Theorie der alterung von niederschlägen durch umlösen (Ostwald-reifung)
27. Progress in Ostwald ripening theories and their applications to the γ'-precipitates in nickel-base superalloys10.1023/A:1015408116016 ↗
28. Designing nickel base alloys for microstructural stability through low γ-γ′ interfacial energy and lattice misfit10.1016/j.matdes.2017.11.065 ↗
29. Effect of alloying elements on the coarsening rate of γ ′ precipitates in multi-component CoNi-based superalloys with high Cr content10.1016/j.scriptamat.2021.114004 ↗
30. A correlative multidimensional study of γ′ precipitates with Ta addition in Re-containing Ni-based single crystal superalloys10.1016/j.jmst.2020.10.025 ↗
31. The effect of rhenium on the microstructure stability and γ/γ′ interfacial characteristics of Ni-based single crystal superalloys during long-term aging10.1016/j.jallcom.2021.160114 ↗
32. Investigation on solution heat treatment response and γ′ solvus temperature of a Mo-rich second generation Ni based single crystal superalloy10.1016/j.intermet.2020.106896 ↗
33. Study on the precipitation of γ′ in a Fe-Ni base alloy during ageing by APT
34. Effect of substituting Mo for W on γ/γ′ partitioning behaviors of alloying elements in heat-treated second generation Ni based single crystal superalloys: An atom probe tomography study10.1016/j.intermet.2021.107198 ↗
35. Evolutions of microstructure and lattice misfit in a γ′-rich Ni-based superalloy during ultra-high temperature thermal cycle10.1016/j.intermet.2018.05.011 ↗
36. Influence of composition on microstructural parameters of single crystal nickel-base superalloys10.1016/j.matchar.2012.05.001 ↗
37. Thermophysical properties of some Ni-based superalloys in the liquid state relevant for solidification processing10.1007/s10853-015-9452-8 ↗
38. Development of Si-bearing 4th generation Ni-base single crystal superalloys
39. Diffusion of Al and Al-substituting elements in Ni3Al at elevated temperatures10.2320/matertrans.M2012218 ↗
40. Single-phase interdiffusion in Ni3Al10.1016/S1359-6454(98)00209-2 ↗
41. Measurement of interdiffusion coefficients in Co–Al and Ni–Al systems between 1000 and 1200℃10.1179/mst.1985.1.2.101 ↗
42. Interdiffusion in the face-centred cubic phase of the Ni–Re, Ni–Ta and Ni–W systems between 900 and 1300℃10.1016/S0921-5093(99)00705-4 ↗
43. Alloying behaviour of Ni3Al, Ni3Ga, Ni3Si and Ni3Ge10.1016/0001-6160(84)90057-9 ↗
44. Element distribution in the macro- and microstructure of nickel base superalloy CMSX-410.1016/S0921-5093(98)00516-4 ↗
45. Partitioning behavior of platinum group metals on the γ and γ′ phases of Ni-base superalloys at high temperatures10.1016/S1359-6462(03)00437-8 ↗
46. R.A. MacKay, T.P. Gabb, A. Garg, R.B. Rogers, M.V. Nathal. Compositional Effects on Nickel-Base Superalloy Single Crystal Microstructures, NASA/TP—2012-217626, National Aeronautics and Space Administration, Glenn Research Center, 2012.
47. Effect of the atomic size distribution on glass forming ability of amorphous metallic alloys10.1016/S0025-5408(01)00715-2 ↗
48. Site preference of transition metal elements in Ni3Al10.1016/j.scriptamat.2006.05.016 ↗
49. Modeling solid solution strengthening in nickel alloys10.1007/s11661-997-0268-2 ↗
50. Solid solution hardening of nickel-role of transition metal and B-subgroup solutes10.2320/matertrans1960.27.656 ↗
51. Influence of solid solution hardening on creep properties of single-crystal nickel-based superalloys10.1007/s11661-014-2727-x ↗
52. The effect of Re and Ru on γ/γ' microstructure, γ solid solution strengthening and creep strength in nickel-base superalloys10.1016/j.msea.2011.01.023 ↗
53. High γ′ solvus new generation nickel-based superalloys for single crystal turbine blade applications
54. Influence of the γ′ fraction on the γ/γ′ topological inversion during high temperature creep of single crystal superalloys10.1007/s11661-014-2727-x ↗
55. Effect of Ru additions on very high temperature creep properties of a single crystal Ni-based superalloy10.1016/j.msea.2013.05.028 ↗
56. Gradient energy, interfacial energy and interface width10.1016/j.scriptamat.2011.11.043 ↗
57. Free energy of a nonuniform system. I. Interfacial free energy10.1063/1.1744102 ↗
58. Ostwald ripening in multicomponent alloys10.1016/j.actamat.2013.03.049 ↗
59. of γ′ precipitates in Ni-based single crystal superalloys10.1016/j.actamat.2022.117979 ↗
60. Unveiling the Mo effect on the microstructural stability of L12-strengthened chemically complex alloys10.1016/j.jallcom.2024.174943 ↗
61. Revealing the effect of Ta on coarsening behavior of γ′ phases during thermal exposure at 1000℃ in a Ni-based SX superalloy
62. Coarsening transitional kinetics of γ′ precipitates in a nickel-based single crystal superalloy during thermal exposure10.1016/j.jallcom.2024.175380 ↗