journal article·2024-11

Refining Alnico 8 magnets with composition optimization of matrix phase, directional solidification and magnetic field annealing

Zhihao Liu, Yongqiang Deng, Sajjad Ur Rehman, Haihua Liu, Abdul Jabbar Khan, Shuwei Zhong, Xiaoqiang Yu, Munan Yang

Publisher page

Abstract

Optimized shape anisotropy of the Fe-Co rich ferromagnetic (α 1) phase and the effective separation of the α 1 and α 2 phases with maximum magnetization difference—where α 2 represents a paramagnetic magnetic phase—are the key parameters for maximizing the magnetic properties of Alnico magnets. In this manuscript, efforts have been undertaken to optimize the shape anisotropy of the α 1 phase and increase the difference in magnetization and separation between α 1 and α 2 phases by fine tuning Al and Ni contents, directional solidification and magnetic field annealing methods. At first, Alnico magnets were fabricated by adjusting the content of α 2 phase followed by homogenization, magnetic field annealing at high temperature, and low-temperature tempering. Intrinsic coercivity ( H cj) of ⁓146.0 kA/m, remanence ( B r) of ⁓0.90 T and maximum energy density ( (BH) max) of 46.02 kJ/m 3 are achieved in the magnet with 8.2 wt% Al and 12.8 wt% Ni treated in field of 1.5 T for 10 minutes. At the second stage, the magnet with optimal magnetic properties is directionally solidified to develop columnar grains, and then the α 1 phase is grown in the direction of the columnar grains by magnetic field annealing to enhance the (BH) max to 79.8 kJ/m 3. The axial ratio of the α 1 phase increased significantly with the increase of the grain size, particularly in the directionally solidified magnets. The Curie temperature of the α 1 phase is noted near 1150 K, while the Curie temperature of the α 2 phase is below 400 K. The magnets demonstrated excellent temperature stability, with magnetic properties decreasing by only 10–12 % at 800 K. These results may pave the way for further development of Alnico magnets specifically for high temperature applications.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Magnetic Properties of Alloys · Magnetic Properties and Applications · Magnetic properties of thin films

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (45)

Show source-provided references
1. Architecture and magnetism of Alnico10.1016/j.actamat.2014.04.044 ↗
2. Tailoring the microstructure, magnetic properties and interaction mechanisms of Alnico-Ta alloys by magnetic field treatment10.1016/j.jallcom.2020.157586 ↗
3. Microstructure and magnetic properties of Dy-added Alnico alloys10.1016/j.jallcom.2023.172894 ↗
4. Synthesis, microstructures, magnetic properties and thermal stabilities of isotropic alnico ribbons10.1016/j.jmmm.2018.07.020 ↗
5. Simulation of alnico coercivity10.1063/1.4992787 ↗
6. High-performance Alnico magnets prepared by powder bed fusion10.1016/j.jallcom.2023.173380 ↗
7. Additively manufactured alnico permanent magnet materials—a review.10.3390/magnetism4020010 ↗
8. Magnetic structure and coercivity mechanism of AlNiCo magnets studied by electron holography10.1016/j.jallcom.2017.05.210 ↗
9. The structure and properties of alnico permanent magnet alloys
10. Microstructural and magnetic property evolution with different heat-treatment conditions in an alnico alloy10.1016/j.actamat.2017.05.012 ↗
11. Microstructure and coercivity in alnico 910.1016/j.jmmm.2018.09.085 ↗
12. Phase and elemental distributions in Alnico magnetic materials10.1109/TMAG.2013.2252155 ↗
13. The phase and microstructure analysis of Alnico magnets with high coercivity10.1016/j.jmmm.2014.12.003 ↗
14. Novel pre-alloyed powder processing of modified alnico 8: correlation of microstructure and magnetic properties10.1063/1.4916996 ↗
15. On the formation and evolution of Cu–Ni-rich bridges of alnico alloys with thermomagnetic treatment.10.1109/TMAG.2016.2555956 ↗
16. Microstructures and magnetic properties of cast alnico 8 permanent magnets under various heat treatment conditions10.1016/j.physb.2018.10.007 ↗
17. Effect of Co on the thermal stability and magnetic properties of AlNiCo 8 alloys10.1063/1.4868083 ↗
18. Evolution of microstructure, magnetic properties, and thermal stabilities of isotropic alnico ribbons10.1109/TMAG.2019.2953160 ↗
19. Role of the applied magnetic field on the microstructural evolution in alnico 8 alloys
20. On the evolution of Cu-Ni-rich bridges of Alnico alloys with tempering10.1016/j.jmmm.2016.07.040 ↗
21. Effects of titanium in alnico 8-type magnet alloys10.2320/matertrans1960.11.268 ↗
22. Synthesis, magnetic and microstructural properties of Alnico magnets with additives10.1016/j.jmmm.2016.12.023 ↗
23. Effects of Zr alloying on the microstructure and magnetic properties of Alnico permanent magnets10.1016/j.jmmm.2017.06.114 ↗
24. Improved microstructure and magnetic properties of Alnico 8 Alloys by B-doping10.1109/TMAG.2018.2822620 ↗
25. Synthesis and magnetic properties of Nb-doped Al–Ni–Co–Ti–Cu–Fe permanent magnets.10.1080/09500839.2010.542190 ↗
26. Contribution to the study of influence of niobium on the magnetic properties of alnico alloys containing 4.5 to 6.5% titanium.
27. Effects of adding elements on alnico
28. Role of alloying elements in phase decomposition in alnico magnet alloys10.1007/BF02816044 ↗
29. Microstructure and magnetic properties of alnico permanent magnetic alloys with Zr-B additives10.1016/j.jmmm.2017.11.043 ↗
30. Tailoring the magnetic properties and microstructure of Alnico 8 magnets by various Ti contents and processing conditions10.1016/j.intermet.2022.107486 ↗
31. Investigations of thermo-magnetic treatment of Alnico 8 alloy
32. Investigations of thermo-magnetic treatment of Alnico 8 alloy
33. Magnetic properties of alnico-type magnet alloys at elevated temperatures10.2320/matertrans1960.8.18 ↗
34. Deformation mechanism of highly textured Alnico magnets10.1016/j.jallcom.2023.169334 ↗
35. The effects of average grain size on the magnetic properties and corrosion resistance of NdFeB sintered magnets10.1063/1.362291 ↗
36. Interaction Anisotropy” model of the structure of alnico magnet alloys.10.1063/1.1984611 ↗
37. Correlations of phase structure and thermal stability for Alnico 8 alloys10.1016/j.jmmm.2017.06.118 ↗
38. Nanomagnetics
39. Zn, Ni, Ti) substituted barium ferrite particles with improved temperature coefficient of coercivity10.1016/S0921-5107(01)00925-4 ↗
40. Grain size dependence of coercivity of hot-deformed Nd–Fe–B anisotropic magnets.10.1016/j.actamat.2014.09.021 ↗
41. Tailoring the magnetic properties and microstructure of NdFeB ribbon alloys by Hf addition10.1016/j.jallcom.2021.160197 ↗
42. A study on the microstructure of Alnico8 alloy thermomagnetically treated at various temperatures10.1016/S0254-0584(01)00397-2 ↗
43. Grain boundary and interface chemistry of an Nd–Fe–B-based sintered magnet.10.1016/j.actamat.2011.10.043 ↗
44. Microstructure and magnetic properties of NdFeB alloys by co-doping alnico elements10.1016/j.physleta.2019.125878 ↗
45. Evolution of Fe–Co Rich particles in Alnico 8 alloy thermomagnetically treated at 800◦C10.1179/026708300101508810 ↗