The radiative characteristics of inconel 718 superalloy after thermal oxidation
Source abstract
Abstract
Abstract The Inconel 718 is a promising Ni-based alloy for a wide range of high-temperature industrial applications. However, the radiative characteristics of Inconel 718 alloy change due to surface oxidation and cause large deviation in temperature field computation and radiation thermometry. Herein, the Inconel 718 alloy has been oxidized at different temperatures, ranging from 700 K to 1100 K, for different time (up to 100 h) to systematically study the influence of oxidation on radiative properties. The highly oxidized alloy samples have been prepared, whose oxidation degrees are more similar to the engineering applications. The normal spectral emittance of as-prepared and surface-oxidized Inconel 718 alloys has been measured in the range of 2–15 μm at different temperatures (400–1400 K). The spectral data have been integrated to analyze the effect of temperature on total emittance. In the case of as-prepared Inconel 718, the normal spectral emittance increased with decreasing wavelength, whereas the total emittance linearly increased with increasing temperature. By comparing the emittance data of oxidized and as-prepared samples, it is clear that the high-temperature oxidation improves the emittance of Inconel 718 alloy. The effect of oxidation on radiative characteristics of Inconel 718 can be divided into three stages: 1. the spectral emittance slightly increases in short wavelength range; 2. obvious emittance fluctuation occurs due to radiation interference; 3. emittance oscillations disappear and the spectral emittance curves shows more radiative characteristics of the main oxide (Cr2O3). Moreover, the total emittance of Inconel 718 alloy, with compact oxide scales, decreased with increasing temperature, and during the 2nd stage, a knee point is observed on the total emittance curve near the Neel temperature of NiO. To unveil the mechanism of oxidation-induced emittance variations, scanning electron microscope (SEM) and energy disperse spectroscopy (EDS) are employed. The structure of a multilayered oxide scale is demonstrated and the process of oxidation is explained. According to the analysis, the oxidation degree determines the weight of influence of substrate alloy and surface oxides on radiative characteristics of oxidized alloy, and this is also the reason why the influence of oxidation on radiative characteristics shows staged. Moreover, NiO was detected on the surface of oxidized samples, and combined with the emittance results, it can be concluded that the magnetic ordering of oxides will influence the radiative behavior of Inconel 718 alloy.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Radiative Heat Transfer Studies · Additive Manufacturing Materials and Processes · Catalytic Processes in Materials Science
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (38)
Show source-provided references
1. A review of mechanical properties of additively manufactured Inconel 718
2. Oxidation and emissivity of Inconel 718 alloy as potential space debris during its atmospheric entry
3. Total hemispherical emissivity of Inconel 71
4. Hemispherical total emissivity of potential structural materials for very high temperature reactor systems: haynes 230
5. The prediction of cutting force in milling Inconel-718
6. High temperature oxidation behavior of Ni-based superalloy GH202
7. Planck · 1959 · 31
8. Radiative heat transfer
9. Emissivity characteristics of polished aluminum alloy surfaces and assessment of multispectral radiation thermometry (MRT) emissivity models
10. Emissivity modeling of metals during the growth of oxide film and comparison of the model with experimental results
11. System for measuring the spectral distribution of normal emissivity of metals with direct current heating
12. Study of Ti–6Al–4V alloy spectral emissivity characteristics during thermal oxidation process
13. Normal spectral emissivity of GH536 (HastelloyX) in three surface conditions
14. The normal spectral emission characteristics of Ni-based alloys during oxidation at high temperatures
15. The normal spectral emittance of the real surface from worked aero-engine nozzle
16. Total hemispherical emissivity of oxidized Inconel 718 in the temperature range 300–1000°C
17. Measurement of total hemispherical emittance and specific heat of aluminum and Inconel 718 by a calorimetric technique
18. Ultra-high temperature emittance measurements for space and missile applications
19. Emissivity measurements on aeronautical alloys
20. Spectral emissivity model of steel 309S during the growth of oxide layer at 800–1100 K
21. Kinetics inversion in isothermal oxidation of uncoated WC-based carbides between 450 and 800°C
22. Iron oxidation kinetics study by using infrared spectral emissivity measurements below 570°C
23. Spectral emissivity of copper and nickel in the mid-infrared range between 250 and 900°C
24. Infrared normal spectral emissivity of Ti–6Al–4V alloy in the 500–1150K temperature range
25. The influence of stress on the oxidation of a Ni-based superalloy
26. Normal spectral emissivity measurement on five aeronautical alloys
27. Johnson · 1995 · vol. 3 · 99
28. Born · 1956
29. The change of crystal and exchange parameters in the vicinity of TN in Cr2O3
30. Role of surface defects and microstructure in infrared optical properties of thermochromic VO2 materials
31. Alloy depletion profiles resulting from the preferential removal of the less noble metal during alloy oxidation
32. Oxidation behavior of Alloy 718 at a high temperature
33. Oxidation behavior and microstructure degeneration of cast Ni-based superalloy M951 at 900 °C
34. Normal spectral emittance of Inconel 718 aeronautical alloy coated with yttria stabilized zirconia films
35. Thermophysical properties of matter
36. Ab initio calculations of Curie temperatures
37. Evolution of the infrared emissivity of Ni during thermal oxidation until oxide layer opacity
38. Temperature-dependent dielectric function of nickel