Effects of deposition method and conditions for IGZO film and thermal annealing on composite film quality, surface roughness, microstructural defects, and electrical properties of Ti/IGZO/graphene/polyimide specimens
Source abstract
Abstract
Abstract The depositions of a thin graphene as the inter layer of the indium gallium zinc oxide (IGZO) film and polyimide substrate and a Ti film bellow the IGZO layer to induce the IGZO crystallizations have been reported by the authors' study [1] to have a significant reduction in the electrical resistivity (R) and increases in carrier mobility (Mb) and concentration (Cc) via the annealing as compared to those created in the specimens without graphene. In the present study, Ti/IGZO/graphene/polyimide specimens were fabricated using Ti as the top layer, with the IGZO film prepared using e-beam evaporation and radio-frequency magnetron sputtering, in order to compare the ability of preserving the structure integrity of graphene after the IGZO deposition. When sputtering was used, the thicknesses of the Ti and IGZO films were controlled by the deposition power; when e-beam evaporation was used, the thicknesses were controlled by the deposition time. Rapid thermal annealing (RTA) was further applied to some specimens to investigate the combined effects of the IGZO deposition method and heat treatment on the microstructure defects, electrical and mechanical properties, and surface morphology of the specimens. The quantities of bulges and microvoid defects increase after the RTA, and become the governing factors for increasing surface roughness (Ra). The X-ray photoelectron spectroscopy spectra for O1s were deconvoluted to evaluate the peak intensity ratio, IRO2, defined for the evaluation of the oxygen vacancies in the microstructure. When sputtering was used, IRO2 increased after RTA; in contrast, when e-beam evaporation was used, IRO2 decreased after RTA. For all specimens without RTA, an increase in either the deposition power or time of IGZO has decreased IRO2. TiO2, ZnO, and Ga2O3 are the three oxides created in the specimens. The ways of increasing the TiO2 grains result in a rise of IRO2. The electrons released from the TiO2 formations are available to raise the quantity of ZnO. The peak intensity (PIZnO) of ZnO is lowered by annealing, irrespective of the IGZO deposition method. With sputtering and without RTA, increasing the IRO2 value increased the carrier mobility (Mb), but decreased the resistivity (R) and carrier concentration (Cc), irrespective of the deposition power. After the RTA, carrier concentration and resistivity are lowered, and carrier mobility is risen. With e-beam evaporation and without RTA, the vague interface between Ti and IGZO films and the void defects in IGZO make these electrical properties more complicated in behavior and dependent on IGZO deposition time. Specimen's resistivity was lowered and carrier concentration was elevated by applying the RTA. The deposition of the Ti film as top layer can result in a much bigger reduction of R and further increases in Mb and Cc for these two IGZO deposition methods as compared to those shown in Ref. [1].
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Thin-Film Transistor Technologies · ZnO doping and properties · Graphene research and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (61)
Show source-provided references
1. Effects of thin titanium and graphene depositions and annealing temperature on electrical, optical, and mechanical properties of IGZO/Ti/graphene/PI specimen10.1016/j.ceramint.2018.01.060 ↗
2. Solution processed invisible all-oxide thin film transistors10.1039/b912554j ↗
3. Room-temperature fabrication of transparent flexible thin-film transistors using amorphous oxide semiconductors10.1038/nature03090 ↗
4. Amorphous In–Ga–Zn–O coplanar homojunction thin-film transistor10.1063/1.3112566 ↗
5. Development of IGZO TFTs and their applications to next-generation flat-panel displays10.1080/15980316.2010.9665845 ↗
6. TFT backplane technologies for AMLCD and AMOLED applications10.3938/jkps.54.549 ↗
7. RF sputtering deposited a-IGZO films for LCD alignment layer application10.1016/j.apsusc.2015.04.153 ↗
8. Electrical and photosensitive characteristics of a-IGZO TFTs related to oxygen vacancy10.1109/TED.2011.2105879 ↗
9. The electrical, optical, and structural properties of amorphous indium gallium zinc oxide films and channel thin-film transistors10.1016/j.sse.2012.10.002 ↗
10. Effect of O2 plasma immersion on electrical properties and transistor performance of indium gallium zinc oxide thin films10.1016/j.tsf.2013.07.084 ↗
11. Effect of Ti/Cu source/drain on an amorphous IGZO TFT employing SiNx passivation for low data-line resistance10.1149/2.003205esl ↗
12. Specific contact resistances between amorphous oxide semiconductor In–Ga–Zn–O and metallic electrodes10.1016/j.tsf.2007.10.051 ↗
13. Low resistance Ti/Au contacts to amorphous gallium indium zinc oxides
14. Correlation between Ti source/drain contact and performance of InGaZnO-based thin film transistors10.1063/1.4790357 ↗
15. High mobility bilayer metal–oxide thin film transistors using titanium-doped InGaZnO10.1109/LED.2013.2290707 ↗
16. Enhancing transparent thin-film transistor device performances by using a Ti-doped GaZnO channel layer10.1039/C5RA14858H ↗
17. Microscopic structure and electrical transport property of sputter-deposited amorphous indium-gallium-zinc oxide semiconductor films
18. High-mobility thin-film transistor with amorphous InGaZnO4 channel fabricated by room temperature rf-magnetron sputtering10.1063/1.2353811 ↗
19. Low temperature processed InGaZnO thin film transistor using the combination of hydrogen irradiation and annealing10.1016/j.apsusc.2014.09.180 ↗
20. The electrical, optical, and structural properties of amorphous indium gallium zinc oxide films and channel thin-film transistors10.1016/j.sse.2012.10.002 ↗
21. Effects of composition on optical and electrical properties of amorphous In–Ga–Zn–O films deposited using radio-frequency sputtering with varying O2 gas flows10.1016/j.tsf.2012.07.106 ↗
22. Modulation of optical and electrical properties of sputtering-derived amorphous InGaZnO thin films by oxygen partial pressure10.1016/j.jallcom.2014.06.194 ↗
23. Substrate temperature dependent structural, optical and electrical properties of amorphous InGaZnO thin films10.1016/j.jallcom.2015.01.143 ↗
24. Hillock growth in thin films10.1063/1.1663054 ↗
25. Hillock growth kinetics in thin Pb-In-Au films10.1080/01418618608243615 ↗
26. Thermally induced hillock formation in Al–Cu films10.1557/JMR.1989.1172 ↗
27. Microwave-assisted synthesis of functional electrode materials for energy applications10.1007/s10008-016-3315-3 ↗
28. Pressure induced structural and optical properties of cubic phase SnSe: an investigation for the infrared/mid-infrared optoelectronic devices10.1016/j.jallcom.2016.10.120 ↗
29. Investigation of thermoelectric properties of novel cubic phase SnSe: a promising material for thermoelectric applications10.1016/j.jallcom.2017.05.003 ↗
30. An insight into a novel cubic phase SnSe for prospective applications in optoelectronics and clean energy devices10.1016/j.jallcom.2017.10.192 ↗
31. A transmission electron microscopy study of hillocks in thin aluminum films10.1116/1.585790 ↗
32. Study of the thermal behaviour of thin aluminium alloy films10.1016/0040-6090(92)90949-C ↗
33. Initial development of the lateral hillock distribution in optical quality Al thin films studied in real time10.1016/S0040-6090(97)00315-5 ↗
34. High performance a-Si:H thin film transistors based on aluminum gate metallization10.1016/S0026-2714(00)00012-3 ↗
35. Effects of deposition and annealing conditions on the defects in the Al/glass composites of TFT specimens10.1007/s10854-014-2183-9 ↗
36. Ultra-sensitive strain sensors based on piezoresistive nanographene films
37. Review of chemistry vapor deposition of graphene and related applications10.1021/ar300203n ↗
38. Enhanced performance of light-controlled conductive switching in hybrid cuprous oxide/reduced graphene oxide (Cu2O/rGO) nanocomposites10.1364/OL.42.000911 ↗
39. Tunable photoluminescence of water-soluble AgInZnS-graphene oxide (GO) nanocomposites and their application in-vivo bioimaging10.1016/j.snb.2017.07.144 ↗
40. Honeycomb carbon: a review of graphene10.1021/cr900070d ↗
41. Mechanical properties of monolayer graphene oxide10.1021/nn101781v ↗
42. Nonlinear fracture analysis of single-layer graphene sheets10.1016/j.engfracmech.2012.08.010 ↗
43. Elastic fields and moduli in defected graphene
44. Structural defects in graphene10.1021/nn102598m ↗
45. Defects and doping and their role in functionalizing graphene10.1557/mrs.2012.187 ↗
46. Effects of graphene layers in IGZO/graphite-like+Ni/SiO2/Si wafer specimens on electrical and optical properties in tribotests10.1364/OME.6.003857 ↗
47. Ion beam modification of metal: compositional and microstructure changes
48. Ultra-thin chip packaging (UTCP): a promising technology for future flexible display interconnection10.1889/1.3256741 ↗
49. Large-area synthesis of high-quality and uniform graphene films on copper foils10.1126/science.1171245 ↗
50. Synthesis of graphene films on copper foils by chemical10.1002/adma.201504760 ↗
51. Effects of deposition conditions of the Al film in Al/glass specimens and annealing conditions on internal stresses and hillock formations10.1016/j.tsf.2011.12.027 ↗
52. Measurement and interpretation of stress in aluminum-based metallization as a function of thermal history10.1109/T-ED.1987.22981 ↗
53. Klung · 1974
54. The effects of high-energy electron beam irradiation on the properties of IGZO thin films prepared by rf magnetron sputtering
55. Moulder · 1992
56. X-ray photoelectron spectroscopic investigation of air-annealed amorphous In-Ga-Zn-O thin-film surface electronic and photonic devices, and systems10.1149/2.004311jss ↗
57. Organic matter characterization of shale rock by x-ray photoelectron spectroscopy: adventitious carbon contamination and radiation damage10.1021/acs.energyfuels.7b01143 ↗
58. Magnetron sputtering of nanocomposite (Ti, Cr) CN/DLC coatings10.1016/S0257-8972(02)00561-3 ↗
59. Formation mechanism of graphene quantum dots and their edge state conversion probed by photoluminescence and Raman spectroscopy10.1039/C6TC03469A ↗
60. Transparent conductive In2O3:Mo thin films prepared by reactive direct current magnetron sputtering at room temperature10.1016/j.tsf.2005.11.012 ↗
61. Mn doped and undoped ZnO films: a comparative structural, optical and electrical properties study10.1016/j.matchemphys.2005.07.045 ↗