journal article·2024-06

Experimental investigation of thermomechanical fatigue behavior in directionally solidified Ni-based superalloy under in-phase and out-of-phase conditions

Van Hung Dao, Hee Soo Yun, Jeon Sang Koo, Park Jaeyeong, Seung Hoon Nahm

Publisher page

Abstract

The fatigue behavior of a directionally solidified (DS) Ni-based superalloy was investigated under in-phase (IP) and out-of-phase (OP) thermomechanical fatigue (TMF) conditions. Specimens were tested under strain control with a temperature range of 450–850 °C. In some tests, an optional 5 min out-of-phase dwell (OPD) time was introduced. In the case of IP TMF, the primary damage manifestation was predominantly intergranular cracks, whereas in the OP tests, the damage was mainly transgranular cracks. The fatigue life of IP TMF was found to be significantly shorter than that of OP TMF. This indicated that the intergranular cracks propagated faster than the transgranular cracks. The dwell time did not influence the dominant damage form; however, it led to an increase in the density of the microcracks. This increase resulted in a reduced lifetime, leading to lower stress amplitudes and higher plastic strain amplitudes compared with the continuous cycle tests. In addition, cycle hardening became apparent during the initial stages of cyclic loading. The microstructures and damage evolution were examined to provide insights into the changes in fatigue life. A model for predicting the fatigue life of DS Ni-based superalloy under given test conditions has been assessed. The proposed fracture mechanics model, which outlines the failure mechanism of directionally solidified Ni-based superalloy under TMF conditions, has proven to be effective in predicting fatigue life.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: High Temperature Alloys and Creep · Aluminum Alloy Microstructure Properties · Microstructure and Mechanical Properties of Steels

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (60)

Show source-provided references
1. Microstructural and compositional design of Ni-based single crystalline superalloys―a review10.1016/j.jallcom.2018.01.224 ↗
2. Influence of dwell times on the thermomechanical fatigue behavior of a directionally solidified Ni-base superalloy10.1016/j.ijfatigue.2015.07.005 ↗
3. Thermomechanical fatigue behavior and failure mechanism of a nickel-based directional solidification column crystal superalloy10.1016/j.engfracmech.2023.109674 ↗
4. Thermomechanical fatigue damage mechanism and life assessment of a single crystal Ni-based superalloy10.1016/j.jallcom.2021.159578 ↗
5. Assessment of fatigue crack closure under in-phase and out-of-phase thermomechanical fatigue loading using a temperature dependent strip yield model10.1016/j.ijfatigue.2015.03.022 ↗
6. Effects of creep and oxidation to thermomechanical fatigue life assessment for nickel-based superalloy10.1016/j.ijfatigue.2023.107873 ↗
7. An approach to lifetime prediction for a wrought Ni-base alloy under thermo-mechanical fatigue with various phase angles between temperature and mechanical strain10.1016/j.ijfatigue.2016.10.015 ↗
8. Parameters influencing thermomechanical fatigue of a directionally-solidified Ni-base superalloy10.1016/j.ijfatigue.2015.07.011 ↗
9. Thermo-mechanical fatigue behavior of a single crystal nickel-based superalloy10.1016/j.msea.2011.04.083 ↗
10. Anisotropic thermomechanical fatigue of a nickel-base single-crystal superalloy part I: effects of crystal orientations and damage mechanisms10.1016/j.ijfatigue.2022.107438 ↗
11. The effect of dwell on thermomechanical fatigue behaviour of Ni-base superalloy Inconel 713LC10.1016/j.ijfatigue.2022.107238 ↗
12. Isothermal and thermomechanical fatigue behavior of Inconel 718 superalloy10.1016/j.msea.2018.11.052 ↗
13. Thermomechanical fatigue and damage mechanisms in Sanicro 25 steel10.1016/j.msea.2015.10.030 ↗
14. A comparative assessment of crack closure mechanisms in Timetal 834 near α titanium alloy under isothermal and thermomechanical fatigue loading10.1016/j.jallcom.2016.06.258 ↗
15. Effects of crack closure and cyclic deformation on thermomechanical fatigue crack growth of a near α titanium alloy10.1007/s11661-016-3482-y ↗
16. Influence of dwell times on microstructure, deformation and damage behavior of NiCr22Co12Mo9 under thermomechanical fatigue10.1016/j.msea.2020.139970 ↗
17. Hold-time effect on the thermo-mechanical fatigue crack growth behaviour of Inconel 71810.1016/j.msea.2011.08.027 ↗
18. Assessment of thermo-mechanical fatigue in a nickel-based single-crystal superalloy CMSX-4 accounting for temperature gradient effects10.1016/j.msea.2021.140918 ↗
19. Deformation behavior and crack mechanism of a first generation single-crystal Ni-based superalloys under thermomechanical fatigue loading10.1016/j.engfracmech.2023.109820 ↗
20. L. Coffin, Predictive parameters and their application to high-temperature, low-cycle fatigue, in: Proceedings of Second International Conference on Fracture, Brighton, London, 1969, pp. 43–654.
21. A creep-fatigue-oxidation microcrack propagation model for thermomechanical fatigue10.1115/1.2904174 ↗
22. A damage function and associated failure equations for predicting hold time and frequency effects in elevated temperature, low cycle fatigue10.1520/JTE10520J ↗
23. Effects of dwell time on the isothermal and thermomechanical fatigue behavior of 316LN stainless steel10.1016/j.ijfatigue.2022.106989 ↗
24. Thermal-mechanical fatigue behaviour and life prediction of P92 steel, including average temperature and dwell effects10.1016/j.jmrt.2019.11.022 ↗
25. Thermomechanical fatigue behavior and lifetime modeling of powder metallurgy superalloy considering phase angle effect10.1016/j.ijfatigue.2022.107164 ↗
26. A study on thermo mechanical fatigue life prediction of Ni-base superalloy10.1016/j.ijfatigue.2013.10.011 ↗
27. Thermomechanical fatigue, oxidation, and creep: part II. Life prediction10.1007/BF02663208 ↗
28. Thermo-mechanical fatigue life assessment of aluminium components using the damage rate model of Sehitoglu10.1016/j.ijfatigue.2007.01.054 ↗
29. Thermomechanical fatigue of nickel-based single-crystal superalloys10.1016/j.engfracmech.2023.109262 ↗
30. Crack formation and microstructure-sensitive propagation in low cycle fatigue of a polycrystalline nickel-based superalloy with different heat treatments10.1016/j.ijfatigue.2017.10.012 ↗
31. Creep properties of a nickel-based single crystal superalloy with low density
32. Creep fracture mechanism of a single crystal nickel base alloy under high temperature and low stress10.1007/s12540-021-00965-0 ↗
33. Isothermal and thermomechanical fatigue behaviour of Ti–6Al–4V titanium alloy10.1016/j.msea.2011.04.085 ↗
34. Creep-fatigue-oxidation interactions in a 9Cr–1Mo martensitic steel. Part II: effect of compressive holding period on fatigue lifetime10.1016/j.ijfatigue.2007.05.008 ↗
35. AFM, SEM AND TEM study of damage mechanisms in cyclically strained mar-M247 at room temperature and high temperatures10.1016/j.tafmec.2020.102606 ↗
36. Low cycle fatigue behavior of a high Co polycrystalline nickel-base superalloy at 750C10.1016/j.jallcom.2018.03.364 ↗
37. Characterization of fatigue crack growth, damage mechanisms and damage evolution of the nickel-based superalloys MAR-M247 CC (HIP) and CM-247 LC under thermomechanical fatigue loading using in situ optical microscopy10.1016/j.ijfatigue.2017.01.015 ↗
38. Investigation of isothermal and thermo-mechanical fatigue behavior of the nickel-base superalloy IN738LC using standardized and advanced test methods10.1016/j.msea.2016.05.114 ↗
39. Rafting in superalloys10.1007/BF02648942 ↗
40. Dependence of the high-temperature low-cycle fatigue behaviour of the monocrystalline nickel-base superalloys CMSX-4 and CMSX-6 on the γ/γ′-morphology10.1016/S0921-5093(99)00453-0 ↗
41. From dislocation junctions to forest hardening10.1103/PhysRevLett.89.255508 ↗
42. Hardening mechanisms and the theory of deformation10.1007/BF03398123 ↗
43. The theory of solution hardening10.1080/14786437708235994 ↗
44. Study on staged work hardening mechanism of nickel-based single crystal alloy during atomic and close-to-atomic scale cutting10.1016/j.precisioneng.2020.11.005 ↗
45. A critical assessment of cyclic softening and hardening behavior in a near-α titanium alloy during thermomechanical fatigue.10.1007/s11661-016-3670-9 ↗
46. Thermomechanical fatigue mechanism in a modern single crystal nickel base superalloy TMS-8210.1016/j.actamat.2008.02.035 ↗
47. Thermal–mechanical fatigue behaviour of a new single crystal superalloy: effects of Si and Re alloying10.1016/j.actamat.2015.03.060 ↗
48. Influence of crystal orientation on the thermomechanical fatigue behaviour in a single-crystal superalloy10.1016/j.msea.2014.11.026 ↗
49. Time dependent ductility improvement of stainless-steel SS 316 using stress relaxation10.1016/j.msea.2016.07.074 ↗
50. Hydrogen, as an alloying element, enables a greater strength-ductility balance in an Fe-Cr-Ni-based, stable austenitic stainless steel10.1016/j.actamat.2020.08.024 ↗
51. Combined effect of secondary dendrite orientation and wall thickness on creep behavior of a Ni-base single crystal superalloy
52. Effect of tensile dwell on high-temperature low-cycle fatigue and fracture behaviour of cast superalloy MAR-M24710.1016/j.engfracmech.2017.04.002 ↗
53. Investigation and modeling of low cycle fatigue behaviors of two Ni-based superalloys under dwell conditions10.1016/j.ijpvp.2009.04.002 ↗
54. W. Schmitt, R. Mohrmann, H. Riedel, A. Dietsche, A. Fischersworring-Bunk, Modeling the fatigue life of automobile components, in: Fatigue 2002 - Proceedings of the Eighth International Fatigue Congress, Stockholm, Sweden (Ed. A. F. Blom), 2002, pp. 781–788.
55. Mechanism-based thermomechanical fatigue life prediction of cast iron. Part I: models10.1016/j.ijfatigue.2010.02.004 ↗
56. Mechanisms and modelling of fatigue crack growth under combined low and high cycle fatigue loading10.1016/j.ijfatigue.2010.08.008 ↗
57. Assessment of fatigue crack closure under in-phase and out-of-phase thermomechanical fatigue loading using a temperature dependent strip yield model10.1016/j.ijfatigue.2015.03.022 ↗
58. Life prediction for random load fatigue based on the growth behavior of microcracks
59. Thermomechanical fatigue of 1.4849 cast steel–experiments and life prediction using a fracture mechanics approach: dedicated to Professor Dr. Hermann Riedel on the occasion of his 65th birthday.10.3139/146.110363 ↗
60. Theoretical estimation to the cyclic yield strength and fatigue limit for alloy steels10.1016/j.mechrescom.2008.10.011 ↗