journal article·2023-10

Tuning band structure and texture for improved thermoelectric performance in BiSe

Maolin Rao, Peihui Chen, Wenjun Wang, Zimin He, Shiyu Wang, Xiaofang Lai, Fusheng Liu, Jikang Jian

Publisher page

Abstract

Layer-structured BiSe has emerged as a promising Te-free thermoelectric (TE) material because of its intrinsic low thermal conductivity. Herein we report the optimization of TE performance for BiSe through In doping to tune the band structure and the proper annealing treatment to adjust the texture. The first-principles calculations and doping experiments reveal that In dopant in BiSe introduces additional energy levels near Fermi level leading to the increase of carrier effective mass. The preferred orientation of (00 l ) plane in BiSe was well adjusted to optimize the electrical conductivity and Seebeck coefficient. Through tuning band structure and texture simultaneously, the Bi 0.995In 0.005Se sample exhibited a maximum figure of merit ZT value of 0.33 at 523 K, which is about 43.5 % higher than that of the pristine BiSe sample without the texture adjustment. This work presents a potential route to promote the TE performance of layer-structured materials.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced Thermoelectric Materials and Devices · 2D Materials and Applications · Heusler alloys: electronic and magnetic properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (57)

Show source-provided references
1. Cooling, heating, generating power, and recovering waste heat with thermoelectric systems10.1126/science.1158899 ↗
2. Advances in thermoelectric materials research: looking back and moving forward10.1126/science.aak9997 ↗
3. Thermoelectric cooling materials10.1038/s41563-020-00852-w ↗
4. Advanced thermoelectric design: from materials and structures to devices10.1021/acs.chemrev.0c00026 ↗
5. CRC Handbook of Thermoelectrics, 1995, CRC Press, Boca Raton, FL, 701 p.: ill.
6. Stabilizing the optimal carrier concentration for high thermoelectric efficiency10.1002/adma.201103153 ↗
7. Promoted thermoelectric performance of (Ag, Na) co-doped polycrystalline BiSe by optimizing the thermal and electrical transports simultaneously10.1016/j.jallcom.2022.163652 ↗
8. Realizing high thermoelectric properties in p-type polycrystalline SnSe by inducing DOS distortion10.1007/s12598-021-01753-w ↗
9. Realizing high thermoelectric properties of SnTe via synergistic band engineering and structure engineering
10. Enhancement of thermoelectric efficiency in PbTe by distortion of the electronic density of states10.1126/science.1159725 ↗
11. Realizing zT of 2.3 in Ge1-x-ySbxInyTe via Reducing the Phase-Transition Temperature and Introducing Resonant Energy Doping10.1002/adma.201705942 ↗
12. Density of state effective mass and related charge transport properties in K-doped BiCuOSe
13. All-scale hierarchical thermoelectrics: MgTe in PbTe facilitates valence band convergence and suppresses bipolar thermal transport for high performance10.1039/c3ee42187b ↗
14. High-performance bulk thermoelectrics with all-scale hierarchical architectures (vol 489, pg 414, 2012)10.1038/nature11645 ↗
15. High-performance nanostructured thermoelectric materials10.1038/asiamat.2010.138 ↗
16. n-type SnSe2 oriented-nanoplate-based pellets for high thermoelectric performance10.1002/aenm.201702167 ↗
17. Ultralow thermal conductivity from transverse acoustic phonon suppression in distorted crystalline alpha-MgAgSb10.1038/s41467-020-14772-5 ↗
18. Ultralow thermal conductivity and high-temperature thermoelectric performance in n-type K2.5Bi8.5Se1410.1021/acs.chemmater.9b02327 ↗
19. An update review on N-type layered oxyselenide thermoelectric materials10.3390/ma14143905 ↗
20. Realizing synergistic optimization of thermoelectric properties in n-type BiSbSe3 polycrystals via co-doping zirconium and halogen
21. Experimental studies on anisotropic thermoelectric properties and structures of n-type Bi2Te2.7Se0.310.1021/nl101156v ↗
22. Thin-film thermoelectric devices with high room-temperature figures of merit10.1038/35098012 ↗
23. Advanced thermoelectric design: from materials and structures to devices10.1021/acs.chemrev.0c00026 ↗
24. Atomically thick bismuth selenide freestanding single layers achieving enhanced thermoelectric energy harvesting10.1021/ja3102049 ↗
25. Localized vibrations of bi bilayer leading to ultralow lattice thermal conductivity and high thermoelectric performance in weak topological insulator n-type BiSe10.1021/jacs.8b02691 ↗
26. Enhanced thermoelectric performance of BiSe by Sn doping and ball milling10.1016/j.ceramint.2021.06.048 ↗
27. Extended phase homogeneity and improved out-of-plane charge transfer in Sb and Te co-alloyed n-type BiSe layered compound with extraordinary thermoelectric performance
28. Mg/Ca doping ameliorates the thermoelectric properties of GeTe: influence of electronic structure engineering10.1016/j.jallcom.2020.155989 ↗
29. Effect of potassium doping on electronic structure and thermoelectric properties of topological crystalline insulator10.1063/1.4948969 ↗
30. Zhang, D., et al., High thermoelectric performance in earth-abundant Cu3SbS4 by promoting doping efficiency via rational vacancy design. Adv. Funct. Mater. 〈http://dx.doi.org/10.1002/adfm.202214163〉.10.1002/adfm.202214163 ↗
31. Anomalous thermoelectric performance in asymmetric dirac semimetal BaAgBi10.1021/acs.jpclett.2c00379 ↗
32. Zheng, S.K., et al., Symmetry-guaranteed high carrier mobility in quasi-2d thermoelectric semiconductors. Adv. Mater.. 〈http://dx.doi.org/10.1002/adma.202210380〉.10.1002/adma.202210380 ↗
33. Modulation doping enables ultrahigh power factor and thermoelectric ZT in n-type Bi2Te2.7Se0.310.1002/advs.202201353 ↗
34. Grain orientation and transport properties of textured Bi2Te3 alloys10.1016/j.mssp.2021.105979 ↗
35. Mott's formula for the thermopower and the Wiedemann-Franz law10.1103/PhysRevB.21.4223 ↗
36. High efficiency Bi2Te3-based materials and devices for thermoelectric power generation between 100 and 300 degrees C10.1039/C6EE02017H ↗
37. Optimized thermoelectric properties of Bi0.48Sb1.52Te3 through AgCuTe doping for low-grade heat harvesting10.1021/acsami.1c19893 ↗
38. Bi8Se7: delocalized interlayer pi-bond interactions enhancing carrier mobility and thermoelectric performance near room temperature10.1021/jacs.0c05904 ↗
39. X-ray photoelectron spectra and electronic structure of Bi2×3 (X = O, S, Se, Te)10.1016/0301-0104(77)85033-7 ↗
40. Growth and thermal properties of various In2Se3 nanostructures prepared by single step PVD technique10.1016/j.jallcom.2018.09.335 ↗
41. Photosensing and characterizing of the pristine and In-,Sn-doped Bi2Se3 nanoplatelets fabricated by thermal V-S process10.3390/nano11051352 ↗
42. In-doped Bi2Se3 hierarchical nanostructures as anode materials for Li-ion batteries10.1039/c4ta00045e ↗
43. Phonon dynamics in (Bi2Se3)(m)(Bi-2)(n) infinitely adaptive series10.1016/j.ssc.2014.08.004 ↗
44. Temperature effects on novel ultra-low frequency raman spectroscopy of liquid water
45. Optimizing thermoelectric properties of BiSe through Cu additive enhanced effective mass and phonon scattering10.1007/s12598-020-01491-5 ↗
46. Enhanced thermoelectric performance of Te-doped Bi2Se3-xTex bulks by self-propagating high-temperature synthesis10.3390/cryst7090257 ↗
47. Effect of doping indium into a Bi2Te3 matrix on the microstructure and thermoelectric transport properties10.1039/C6RA09767G ↗
48. Goldsmid, H.J., Introduction to thermoelectricity, in: Springer Series in Materials Science,. 2016, Springer Berlin Heidelberg: Imprint: Springer,: Berlin, Heidelberg, 1 online resource (XVIII, 278 pages 154 illustrations).
49. Chen, P., et al., Intrinsically low lattice thermal conductivity and anisotropic thermoelectric performance in In-doped GeSb2Te4 single crystals. Adv. Funct. Mater. 〈http://dx.doi.org/10.1002/adfm.202211281〉.10.1002/adfm.202211281 ↗
50. Largely enhanced seebeck coefficient and thermoelectric performance by the distortion of electronic density of states in Ge2Sb2Te510.1021/acsami.9b12854 ↗
51. Study of texture and microstructure evaluation of steel API 5L X70 under various thermomechanical cycles10.1016/j.msea.2015.05.020 ↗
52. X-ray studies of influence of preliminary stages of annealing on texture and microstructure of quenched alloy Zr-2,5%Nb
53. Influences of postproduction heat treatments on the material anisotropy of nickel-aluminum bronze fabricated using wire-arc additive manufacturing process10.1007/s00170-019-03700-7 ↗
54. Effect of annealing process on the microstructure and texture of cold-rolled high-purity Al-0.5%Cu plates10.3390/ma15103489 ↗
55. Electron density optimization and the anisotropic thermoelectric properties of Ti self-intercalated Ti1+xS2 compounds10.1021/acsami.8b10449 ↗
56. Orientation distribution-Lotgering factor relationship in a polycrystalline material-as an example of bismuth titanate prepared by a magnetic field10.2109/jcersj2.118.921 ↗
57. Thermoelectric properties of n-type (Bi2Se3)x(Bi2Te3)1−x prepared by bulk mechanical alloying and hot pressing10.1016/S0925-8388(00)01159-2 ↗