journal article·2022-12

Effect of Al addition and annealing on the microstructure evolution of Mg-3Sn Mg alloy subjected to high-speed rolling

Pei Di, Wang Li, Yan Tingliang, Li Xinlin, Wang Xiang

Publisher page

Abstract

The microstructure evolution of Mg-3Sn, Mg-3Sn-3Al-Zn (ATZ331), and Mg-3Sn-6Al-Zn (ATZ631) alloys during high-speed rolling (HSR) and annealing was studied. High-speed rolling was carried out on the three alloys at a rolling speed of 1100 m/min, a rolling temperature of 400 °C, and a reduction of 40% during a single pass. The results showed that the microstructure of the samples after HSR contained many twins and was dominated by {10−12} extension twins (ETs) and supplemented by {10−11} contraction twins (CTs) and {10−11}-{10−12} double twins (DTs). After adding Al, the content of these different types of twins was reduced. The twinning fraction decreased significantly with 3 wt% Al addition, while the twinning fraction decreased slightly with 6 wt% Al addition. The high-speed rolled alloys were annealed at 370 °C for 1 min, 2 min, 3 min, 5 min, and 8 min. When the annealing time was 1 min, the recrystallization fraction of the ATZ631 alloy was low, indicating that increasing the Al content to 6 wt% inhibited recrystallization. When the annealing time increased to 3 min, the recrystallized grains in the ATZ631 alloy grew, indicating that the grain growth progressed faster in this alloy. When the annealing time was 8 min, the grain size of the three alloys grew. The electron backscattered diffraction (EBSD) results of the alloy annealed for 8 min showed that the twin fraction in the annealed state was lower than that after high-speed rolling. In addition with the increase in Al content, the twin fraction decreased. During high-speed rolling, the maximum intensity also increased with an increase in Al content, were 22.72, 25.09, and 26.35, and the texture of the annealed alloy was weakened. The Al addition also increased the maximum intensity.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Metal and Thin Film Mechanics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (33)

Show source-provided references
1. Effect of intermediate heat treatment during hot rolling on the texture and formability of annealed AZ31 Mg alloy sheets10.1016/j.jallcom.2021.163238 ↗
2. Corrosion behavior of Mg-Li alloys: a review10.1016/S1003-6326(21)65728-X ↗
3. Cold rolling textures in AZ31 wrought magnesium alloy10.1016/j.scriptamat.2004.01.010 ↗
4. Microstructure evolution of twinning-induced shear bands and correlation with ‘Rd-split’ texture during hot rolling in a Mg-1.1Zn-0.76Y-0.56Zr alloy10.1016/j.matchar.2022.111853 ↗
5. Effect of carbonate additive on the microstructure and corrosion resistance of plasma electrolytic oxidation coating on Mg-9Li-3Al alloy10.1007/s12613-021-2377-0 ↗
6. Influence of deformation twinning on static annealing of AZ31 Mg alloy10.1016/j.actamat.2013.06.037 ↗
7. Mechanical properties and microscopic deformation mechanism of polycrystalline magnesium under high-strain-rate compressive loadings10.1016/j.msea.2012.01.116 ↗
8. Orientational analysis of static recrystallization at compression twins in a magnesium alloy AZ3110.1016/j.msea.2009.03.045 ↗
9. Dynamic deformation behavior and microstructural evolution during high-speed rolling of Mg alloy having non-basal texture10.1016/j.jmst.2018.10.010 ↗
10. Dynamic recrystallization behavior and microstructural evolution of My alloy AZ31 through high-speed rolling10.1016/j.jmst.2018.03.002 ↗
11. Ameliorating mechanical properties and reducing anisotropy of as-extruded Mg-1.0Sn-0.5Ca alloy via Al addition10.1016/j.pnsc.2021.08.007 ↗
12. Influence of aluminum content on twinning and texture development of cast Mg-Al-Zn alloy during compression10.1016/j.jallcom.2014.10.096 ↗
13. Effects of doping atoms on the generalized stacking-fault energies of Mg alloys from first-principles calculations10.1016/j.scriptamat.2013.05.026 ↗
14. Texture evolution and dynamic mechanical behavior of cast AZ magnesium alloy under high strain rate compressive loading10.1016/j.matdes.2014.04.049 ↗
15. Effect twinning and dynamic recrystallization on the high strain rate rolling process10.1016/j.scriptamat.2010.07.029 ↗
16. Fabrication of Mg-Al-Zn-Mn alloy sheets with homogeneous fine-grained structures using high strain-rate rolling in a wide temperature range10.1016/j.msea.2012.09.022 ↗
17. Static recrystallization behavior of hot-rolled Mg-Zn-Ce magnesium alloy sheet10.1016/j.jallcom.2017.07.093 ↗
18. Dynamic recrystallization and the development of microstructure during the high temperature deformation of magnesium10.1016/0001-6160(82)90031-1 ↗
19. Improvement of mechanical properties and reduction of yield asymmetry of extruded Mg-Sn-Zn alloy through Ca addition10.1016/j.jallcom.2018.12.109 ↗
20. Solute segregation and texture modification in an extruded magnesium alloy containing gadolinium10.1016/j.scriptamat.2011.08.012 ↗
21. Twin recrystallization mechanisms and exceptional contribution to texture evolution during annealing in a magnesium alloy10.1016/j.actamat.2016.12.058 ↗
22. J. Humphreys, G.S. Rohrer, A. Rollett. Recrystallization and related annealing phenomena, Amsterdam, Oxford, Cambridge, 1996.10.1016/B978-0-08-041884-1.50017-9 ↗
23. Role of Yb in enhancing the heat resistance of cast Mg-Sm-Zn alloy10.1016/j.msea.2022.143009 ↗
24. Synergistically improved damping, elastic modulus and mechanical properties of rolled Mg-3Li-4Y–2Er-2Zn-0.6Zr alloy with twins and long-period stacking ordered phase10.1016/j.jallcom.2021.160663 ↗
25. Annealing coordinates the deformation of shear band to improve the microstructure difference and simultaneously promote the strength-plasticity of composite plate10.1016/j.matdes.2022.110696 ↗
26. Static recrystallization behavior of magnesium AZ31 alloy subjected to high speed rolling10.1016/j.msea.2016.03.047 ↗
27. The role of double twinning on transgranular fracture in magnesium AZ61 in a localized stress field10.1016/j.actamat.2015.09.026 ↗
28. Profuse slip transmission across twin boundaries in magnesium10.1016/j.actamat.2016.11.022 ↗
29. Solute strengthening of twinning dislocations in Mg alloys10.1016/j.actamat.2014.07.045 ↗
30. The deformation, recrystallization and texture of three magnesium alloy extrusions10.1179/174328407X226509 ↗
31. First-principles study of generalized-stacking-fault (GSF) energy in Mg with Al and Zn alloyings10.1016/j.jallcom.2013.05.187 ↗
32. Microband/twin recrystallization during back extrusion of AZ31 magnesium10.1016/j.msea.2017.09.134 ↗
33. Twinning-induced dynamic recrystallization and micro-plastic mechanism during hot-rolling process of a magnesium alloy10.1016/j.msea.2017.05.037 ↗