journal article·2008-08

Threshold stress intensity factor, KIH for delayed hydride cracking of a Zr-2.5Nb tube with loading mode

Young Suk Kim, Sun Sam Park, Sook In Kwun

Journal of Alloys and Compounds· Volume 462· Issue 1-2
Publisher page

Abstract

Abstract The threshold stress intensity factors, KIH's, for delayed hydride cracking of a Zr-2.5Nb tube were determined using either load-increasing or decreasing modes over a temperature range of 160–280 °C with a step-wise load increase or decrease by 0 .5 MPa m , respectively. KIH's in the load-increasing mode were found to be higher than those in the load-decreasing mode. The striation spacing corresponding to the critical hydride length or lc showed a sharp drop between the 1st striation line to the 9th line and then leveled off to a constant value in the load-increasing mode. In the load-decreasing mode, it was rather constant from the 1st line to the 14th line due to a higher stress intensity factor KI with its gradual increase at a reduced KI closed to KIH. Supplementary tests demonstrated that a higher KIH in the load-increasing mode is due to the combined effects of a larger tip radius of the fatigue crack and creep working in the load-increasing mode. KIH had a negative temperature dependency in the load-increasing mode and it had no temperature dependency in the load-decreasing mode. To correlate KIH with twins, tensile tests were conducted on the Zr-2.5Nb tube and its textural changes during the tensile tests were investigated using an X-ray diffractometer. The number of twins increased over a temperature range of 150–300 °C and then decreased rapidly at over 300 °C with no twins at 350 °C. KIH of the Zr-2.5Nb tube with the loading modes was discussed in view of cracking of the hydrides by twining.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Nuclear Materials and Properties · Fusion materials and technologies · Nuclear and radioactivity studies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. Simpson · J. Nucl. Mater. · 1979 · 87 · 30310.1016/0022-3115(79)90567-1 ↗
2. Kim · J. Nucl. Mater. · 2000 · 278 · 25110.1016/S0022-3115(99)00249-4 ↗
3. Shi · J. Nucl. Mater. · 1994 · 208 · 23210.1016/0022-3115(94)90332-8 ↗
4. D.A. Scarth, T. Smith, Proceedings of 2002 ASME Pressure Vessels and Piping Conf. PVP-Vol.437, ASME2002, PVP2002-1171, 2002, p. 19.
5. Sagat · 2002
6. Warren · J. Nucl. Mater. · 1968 · 26 · 27310.1016/0022-3115(68)90101-3 ↗
7. Westlake · Trans. ASM · 1963 · 56 · 1
8. S. Sagat, C.E. Coleman, M. Griffiths, B.J.S. Wilkins, in: A.M. Garde, E.R. Bradley (Eds.), Zirconium in the Nuclear Industry: Tenth International Symposium, ASTM STP 1245, ASTM, 1994, pp. 35–61.
9. Kim · J. Kor. Inst. Met. Mater. · 2000 · 38 · 985
10. E. Tenckhoff, J. ASTM Inter., vol. 2, Paper ID JAI 12945, pp. 25–50.10.1520/JAI12945 ↗
11. Perlovich · J. Phys. IV · 1996 · C6 · 335
12. Kim · J. Nucl. Mater. · 2001 · 297 · 29210.1016/S0022-3115(01)00628-6 ↗
13. Y.S. Kim, Characterization test procedures for Zr-2.5Nb tubes, Korea Atomic Energy Research Institute Report, KAERI/TR-1329/99, 1999.
14. Aktar · Acta Met. · 1973 · 21 · 110.1016/0001-6160(73)90213-7 ↗
15. S.S. Park, Dependence of threshold stress intensity factor, KIH on temperature and hydrogen concentration for delayed hydride cracking in Zr-2.5Nb pressure tube, M.S. Thesis, Korea University, 2001.
16. Shi · J. Nucl. Mater. · 1995 · 218 · 18910.1016/0022-3115(94)00405-6 ↗
17. Kim · J. Alloys Compd. · 2008 · 453 · 21010.1016/j.jallcom.2006.11.197 ↗
18. Shek · J. Nucl. Mater. · 1996 · 231 · 22110.1016/0022-3115(96)00370-4 ↗
19. Kim · Mater. Sci. Eng. A · 2007 · 468–470 · 28110.1016/j.msea.2006.09.123 ↗
20. Westlake · Trans. Metall. Soc. AIME · 1969 · 245 · 287
21. Kim · J. Alloys Compd. · 2007 · 429 · 22110.1016/j.jallcom.2006.09.034 ↗
22. E. Tenckhoff, ASTM STP 966, PA, 1988.
23. Reed-Hill · 1963 · 295
24. Himbeault · Met. Trans. · 1994 · 25A · 13510.1007/BF02646682 ↗
25. C. Regnard, B. Verhaehge, F. Lefebvre-Joud, C. Lemaignan, in: G.D. Moan, P. Rudling (Eds.), Zirconium in the Nuclear Industry: Thirteenth International Symposium, ASTM STP 1423, ASTM International, 2002, pp. 384–399.
26. M.R. Levi, M.P. Puls, in: 18th International Conference on Structural Mechanics in Reactor Technology (SMiRT 18), Beijing, 2005, G10_3.
27. C.E. Coleman, B.A. Cheadle, C.D. Cann, J.R. Theaker, in: E.R. Bradley, G.P. Sabol (Eds.), Zirconium in the Nuclear Industry: Eleventh International Symposium, ASTM STP 1295, ASTM, 1996, pp. 884–896.
28. Kim · J. Nucl. Mater. · 2000 · 279 · 28610.1016/S0022-3115(99)00284-6 ↗
29. Kim · J. Nucl. Mater. · 2000 · 280 · 30410.1016/S0022-3115(00)00054-4 ↗