Oxidation behavior of TA15 titanium alloy at high-temperature and the effect on infrared emissivity
Source abstract
Abstract
In this study, TA15 titanium alloys were oxidized at 550–850 °C for different times (from 1 h to 100 h) to investigate the effect of oxide film structure on infrared (IR) emissivity. We characterized the oxide film structure, analyzed the emissivity evolution and discussed the relationship between oxidation and IR emissivity. The oxidation of the TA15 alloy followed a parabolic rate law at 550–850 °C, with the parabolic rate constant varying from 6.07 × 10 −4 to 4.18 mg 2∙cm −4∙h −1 and the film thickness increasing from 0.03 µm (550 °C for 1 h) to 38 µm (850 °C for 100 h). Additionally, the multi-layer oxide film structure formed on the surface of the alloy comprise Al 2O 3 +TiO 2/TiO 2/Al 2O 3 +TiO 2 /substrate. Two patterns were evident from the thickness versus infrared emissivity curves—that is, below 0.3 µm, the emissivity was almost constant (approximately 0.18); after which the emissivity increases rapidly up to 0.67 at a thickness of 38 µm. At temperature range from 550 °C to 850 °C, the integrated emissivity exhibited a linear increase up to 0.31 (at 850 °C for 1 h) with increasing temperature. Finally, the experimentally obtained spectra are in excellent correspondence with the results from simulation at wavelengths under 8 µm. FDTD simulations showed that infrared radiation was pervasive throughout the oxide film at the wavelength range of 2.5–5 µm and 10–12 µm.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: High-Temperature Coating Behaviors · Catalytic Processes in Materials Science · Advanced ceramic materials synthesis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (65)
Show source-provided references
1. High temperature softening mechanism of powder metallurgy TA15 alloy10.1016/j.msea.2023.145160 ↗
2. Oxidation behaviors of TA15 titanium alloy and TiBw reinforced TA15 matrix composites prepared by spark plasma sintering10.1016/j.jmst.2019.07.037 ↗
3. Synthesis, structural, strength and corrosion properties of thin films of the type CuX (X = Bi, Mg, Ni)10.1007/s10854-019-01556-x ↗
4. Phase transformations in FeCo – Fe2CoO4/Co3O4-spinel nanostructures as a result of thermal annealing and their practical application10.1007/s10854-021-06226-5 ↗
5. Preparation, phase stability, and magnetization behavior of high entropy hexaferrites10.1016/j.isci.2023.107077 ↗
6. Temperature induced structural and polarization features in BaFe12O1910.1039/D3TC01533E ↗
7. Features of the growth processes and magnetic domain structure of NiFe nano-objects10.1021/acs.jpcc.9b06997 ↗
8. Research of the shielding effect and radiation resistance of composite CuBi2O4 films as well as their practical applications10.1007/s10854-020-03724-w ↗
9. Experimental and theoretical study of the effect of Si on the oxidative behavior of Ti-6Al-4V alloys10.1016/j.jallcom.2018.10.291 ↗
10. The effect of oxidation on the subsurface microstructure of a Ti-6Al-4V alloy10.1016/j.scriptamat.2018.01.015 ↗
11. Effect of temperature on thermal oxidation behavior of biomedical Ti-Zr-Mo alloys10.1016/j.jallcom.2022.164202 ↗
12. Investigation of the effects of Ni-based alloy DZ125 on the normal spectral emissivity during oxidation10.1016/j.applthermaleng.2016.08.122 ↗
13. Study of normal spectral emissivity of copper during thermal oxidation at different temperatures and heating times10.1016/j.ijheatmasstransfer.2018.09.116 ↗
14. Improved energy storage performance of sandwich-structured P(VDF-HFP)-based nanocomposites by the addition of inorganic nanoparticles10.1039/D3TC00979C ↗
15. Effect of doping of Ce4+/3+ on optical, strength and shielding properties of (0.5-x)TeO2-0.25MoO-0.25Bi2O3-xCeO2 glasses10.1016/j.matchemphys.2021.124444 ↗
16. Behavior of TA6V alloy at high temperature in air plasma conditions: part 2—thermal diffusivity and emissivity10.1007/s11665-020-04985-6 ↗
17. Prediction of oxidation behavior of near-α titanium alloys10.1016/j.scriptamat.2016.06.044 ↗
18. Studies on different oxidation behaviors of TiAlN on titanium alloy and stainless steel under thermal cycling10.1016/j.corsci.2021.109865 ↗
19. Modeling the oxidation kinetics of titanium alloys: review, method and application to Ti-64 and Ti-6242s alloys10.1016/j.corsci.2020.109041 ↗
20. Effect of niobium addition on tensile properties and oxidation resistance of a titanium-based alloy10.1016/j.corsci.2020.109198 ↗
21. Study of titanium alloy Ti6242S oxidation behaviour in air at 560°C: effect of oxygen dissolution on lattice parameters10.1016/j.corsci.2019.06.004 ↗
22. The oxidation of titanium in oxygen at high temperatures10.1016/0001-6160(60)90170-X ↗
23. Oxidation of Ti–6Al–4V alloy10.1016/j.jallcom.2008.04.024 ↗
24. Infrared normal spectral emissivity of Ti–6Al–4V alloy in the 500–1150K temperature range10.1016/j.jallcom.2012.06.117 ↗
25. Emissivity estimation for high temperature radiation pyrometry on Ti–6Al–4V10.1016/j.measurement.2012.10.019 ↗
26. Study of Ti–6Al–4V alloy spectral emissivity characteristics during thermal oxidation process10.1016/j.ijheatmasstransfer.2016.05.069 ↗
27. Effect of the surface oxidization and nitridation on the normal spectral emissivity of titanium alloys Ti–6Al–4V at 800–1100K at a wavelength of 1.5μm10.1016/j.infrared.2016.01.005 ↗
28. Normal spectral emissivity study for GH3044 alloy and Ti-6Al-4V alloy10.1016/j.infrared.2022.104278 ↗
29. Effect of oxidation on spectral and integrated emissivity of Ti-6Al-4V alloy at high temperatures10.1016/j.jallcom.2021.161545 ↗
30. The normal spectral emission characteristics of Ni-based alloys during oxidation at high temperatures10.1016/j.ijheatmasstransfer.2018.09.008 ↗
31. The radiative characteristics of inconel 718 superalloy after thermal oxidation10.1016/j.jallcom.2020.156414 ↗
32. Emissivity measurements on metallic surfaces with various degrees of roughness: a comparison of laser polarimetry and integrating sphere reflectometry10.1023/B:IJOT.0000028489.81327.b7 ↗
33. Evolution of the infrared emissivity of Ni during thermal oxidation until oxide layer opacity10.1016/j.infrared.2019.01.002 ↗
34. Experimental measurements and quantified approach of spectral emissivity of cupronickel alloy C7701 during oxidation10.1016/j.infrared.2022.104106 ↗
35. Effect of surface morphology and densification on the infrared emissivity of C/SiC composites10.1016/j.apsusc.2014.06.044 ↗
36. Computation of total hemispherical emissivity from directional spectral models10.1016/j.ijheatmasstransfer.2017.01.120 ↗
37. Design of near-α Ti alloys via a cluster formula approach and their high-temperature oxidation resistance10.1016/j.jmst.2018.12.013 ↗
38. Effect of in situ TiB short fibre on oxidation behavior of Ti–6Al–1.2B alloy10.1016/S1359-6462(02)00081-7 ↗
39. Air oxidation behaviour of Ti-6A1-4V alloy between 650 and 850°C10.1016/0010-938X(94)90069-8 ↗
40. Theoretical research for oxidation mechanism of α-Ti: a combination of DFT and ab initio molecular dynamics study10.1016/j.vacuum.2021.110522 ↗
41. Effect of minor Sc modification on the high-temperature oxidation behavior of near-α Ti alloy10.1016/j.corsci.2023.111122 ↗
42. Oxidation behavior of STA β-21S alloy and variants [Ti-xNb-yMo-5.6Al-0.5Si at%; x + y = 9.5]10.1016/j.corsci.2022.110342 ↗
43. Enhanced high temperature oxidation resistance of discontinuous distributed TiBw reinforced TA15 titanium alloy by simple pack cementation method10.1016/j.corsci.2023.111073 ↗
44. High hydrostatic pressure effect on magnetic state of anion-deficient La0.70Sr0.30MnOx perovskite manganites10.1016/j.jmmm.2008.02.021 ↗
45. Evaluation of the efficiency of detection and capture of manganese in aqueous solutions of FeCeOx nanocomposites doped with Nb2O510.3390/s20174851 ↗
46. Influence of the nitrogen flow rate on the infrared emissivity of TiNx films10.1016/j.infrared.2017.11.015 ↗
47. Isothermal oxidation kinetics of nitrided Ti-6Al-4V studied by infrared emissivity10.1016/j.corsci.2020.108723 ↗
48. Initial oxidation of Ti–Al intermetallics: an in situ MXPS study10.1016/S0169-4332(99)00583-8 ↗
49. Growth and characterization of the oxide scales and core/shell nanowires on Ti-6Al-4V particles during thermal oxidation10.1016/j.ceramint.2014.11.130 ↗
50. Howell · 2021
51. Optical properties of fourteen metals in the infrared and far infrared: Al, Co, Cu, Au, Fe, Pb, Mo, Ni, Pd, Pt, Ag, Ti, V, and W10.1364/AO.24.004493 ↗
52. Effect of oxidation on aluminum alloys temperature prediction using multispectral radiation thermometry10.1016/j.ijheatmasstransfer.2011.06.038 ↗
53. Iron oxidation kinetics study by using infrared spectral emissivity measurements below 570°C10.1016/j.corsci.2007.05.029 ↗
54. A density functional study of structural, electronic and optical properties of titanium dioxide: characterization of rutile, anatase and brookite polymorphs10.1016/j.mssp.2014.12.027 ↗
55. G. Teodorescu, Radiative Emissivity of Metals and Oxidized Metals at High Temperature (Ph.D. thesis), in: Materials Engineering, Auburn University, Alabama,USA, 2007.
56. Phase-pure TiO2 nanoparticles: anatase, brookite and rutile10.1088/0957-4484/19/14/145605 ↗
57. Effects of annealing temperature, thickness and substrates on optical properties of m-plane ZnO films studied by photoluminescence and temperature dependent ellipsometry10.1016/j.jallcom.2020.156631 ↗
58. O. Rozenbaum, Etude de l′influence de la texture sur l′émissivité spectrale de matériaux poreux semi-transparents à haute température, in, 1999.
59. Infrared-optical characteristics of ceramics at elevated temperatures10.1016/j.infrared.2011.06.001 ↗
60. Temperature dependence of infrared dispersion in ionic crystals LiF and MgO10.1103/PhysRev.146.526 ↗
61. "Nanophotonic FDTD simulation software - lumerical FDTD (Online). 〈https://www.lumerical.com/products/fdtd/〉. (Accessed 12 July 2023). 2023.
62. A multilayer film based on thin-film interference and impedance matching for dual-laser and infrared stealth as well as thermal management10.1016/j.ijleo.2023.171261 ↗
63. FDTD modeling of sputtered Mo–Al2O3 nanocomposites10.1016/j.solmat.2021.111027 ↗
64. E.D. Palik, Handbook of Optical Constants of Solids, ScienceDirect (Online). 〈https://www.sciencedirect.com/book/9780125444156/handbook-of-optical-constants-of-solids〉. (Accessed 1August 2023). 2023.
65. Optical properties of Ti, Zr, and Hf from 0.15 to 30 ev10.1103/PhysRevB.11.3617 ↗