journal article·2022-11

Strain rate sensitivity of a Cu60Zr40 metallic and nanoglass

A. Sharma, S.S. Hirmukhe, Sree Harsha Nandam, Horst Hahn, I. Singh, R. Lakshmi Narayan, K. Eswar Prasad

Publisher page

Abstract

The strain rate sensitivity, m, of a binary Cu 60 Zr 40 nanoglass (NG) and metallic glass (MG) are investigated using nanoindentation. Indentations were performed at different loading rates in the range of 0.26–8 mN/s, which gives equivalent indentation strain rates over three decades. The load vs. displacement curves of MG exhibited noticeable displacement bursts at low loading rates, which gradually decreased with increasing loading rate suggesting a transition from more to less severe heterogeneous plastic flow. While in the case of NG, no noticeable displacement bursts are present at any of the loading rates suggesting a near homogeneous plastic flow. In both NG and MG, the hardness decreases with increasing loading rate, resulting in negative strain rate sensitivity, m. The m for NG is higher than the MG, indicating a more homogeneous flow underneath the indentation. Interface indentation experiments and subsequent analysis of the deformation zone showed a larger number of fine secondary shear bands (SSBs) in NG as compared to the primary shear bands (PSBs), while the plastic flow in MG is accommodated mostly by the PSBs. The findings of the current study will help improve the understanding of the plastic deformation behavior of NGs and provide insights for designing the novel microstructural architecture of amorphous alloys with improved ductility.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Metallic Glasses and Amorphous Alloys · Microstructure and mechanical properties · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (63)

Show source-provided references
1. Mechanical behavior of amorphous alloys10.1016/j.actamat.2007.01.052 ↗
2. Dynamics of viscoplastic deformation in amorphous solids10.1103/PhysRevE.57.7192 ↗
3. Homogeneous deformation of Au-based metallic glass micropillars in compression at elevated temperatures10.1063/1.3081111 ↗
4. Effect of temperature on the plastic zone size and the shear band density in a bulk metallic glass. Mater10.1016/j.msea.2011.12.040 ↗
5. Microstructure controlled shear band pattern formation and enhanced plasticity of bulk metallic glasses containing in situ formed ductile phase dendrite dispersions10.1103/PhysRevLett.84.2901 ↗
6. Nanoglasses: a new kind of noncrystalline materials10.3762/bjnano.4.61 ↗
7. Structure and properties of nanoglasses10.1002/adem.201800404 ↗
8. Plastic deformation of a Zr-based bulk metallic glass fabricated by selective laser melting10.1016/j.jmst.2020.06.007 ↗
9. Structure, stability and mechanical properties of internal interfaces in Cu64Zr36 nanoglasses studied by MD simulations10.1016/j.actamat.2011.07.013 ↗
10. Influence of microstructural features on the plastic deformation behavior of metallic nanoglasses10.1016/j.actamat.2019.02.033 ↗
11. Interfaces and interphases in nanoglasses: surface segregation effects and their implications on structural properties10.1016/j.actamat.2016.05.002 ↗
12. Evidence for enhanced ferromagnetism in an iron-based nanoglass10.1063/1.4818493 ↗
13. Formation and properties of Au-based nanograined metallic glasses10.1016/j.actamat.2011.07.007 ↗
14. Nanoscale morphology of Ni50Ti45Cu5 nanoglass10.1016/j.matchar.2015.12.025 ↗
15. Cu-Zr nanoglasses: atomic structure, thermal stability and indentation properties10.1016/j.actamat.2017.07.001 ↗
16. Effect of structural relaxation on the indentation size effect and deformation behavior of Cu-Zr-based nanoglasses
17. On the differences in shear band characteristics between a binary Pd-Si metallic and nanoglass10.1016/j.scriptamat.2020.09.009 ↗
18. Influence of topological structure and chemical segregation on the thermal and mechanical properties of Pd-Si nanoglasses10.1016/j.actamat.2020.03.021 ↗
19. Plasticity of a scandium-based nanoglass10.1016/j.scriptamat.2014.11.010 ↗
20. Sample size effects on strength and deformation mechanism of Sc75Fe25 nanoglass and metallic glass10.1016/j.scriptamat.2016.01.036 ↗
21. Controlling shear band instability by nanoscale heterogeneties in metallic nanoglasses10.1557/s43578-021-00285-4 ↗
22. Mechanical Metallurgy
23. Negative strain rate sensitivity in bulk metallic glass and its similarities with the dynamic strain aging effect during deformation
24. Strain-rate dependence of hardening and softening in compression of a bulk-metallic glass10.1557/JMR.2007.0351 ↗
25. Effect of strain rate on compressive behavior of a Pd40Ni40P20 bulk metallic glass10.1016/S0966-9795(02)00137-1 ↗
26. Constitutive model for inhomogeneous flow in bulk metallic glasses10.1016/j.actamat.2008.10.027 ↗
27. Deformation and strain rate sensitivity of a Zr-Cu-Fe-Al metallic glass10.1016/j.msea.2011.01.049 ↗
28. Effect of annealing on strain rate sensitivity of metallic glass under nanoindentation10.3390/met10081063 ↗
29. Negative strain rate sensitivity induced by structure heterogeneity in Zr64.13Cu15.75Ni10.12Al10 bulk metallic glass10.3390/met11020339 ↗
30. Size dependent hidden serration behaviors of shear banding in metallic glass thin films10.1016/j.jnoncrysol.2020.119953 ↗
31. Experimental characterization of shear transformation zones for plastic flow of bulk metallic glasses10.1073/pnas.0806051105 ↗
32. Enhanced strain rate sensitivity of Zr-based bulk metallic glasses subjected to high pressure torsion10.1016/j.jallcom.2018.03.018 ↗
33. On the strain rate sensitivity of plastic flow in metallic glasses10.1016/j.msea.2014.12.004 ↗
34. Influence of the loading rate on the indentation response of Ti-based metallic glass10.1557/jmr.2009.0117 ↗
35. Mechanism of negative strain rate sensitivity in metallic glass film10.1016/j.jallcom.2019.01.024 ↗
36. Nanoindentation studies of strain rate sensitivities in bulk metallic glasses10.1016/j.jnoncrysol.2021.120852 ↗
37. Effect of testing conditions on the nanomechanical behavior of surface and inner core of as-cast Zr-base bulk metallic glassy plates10.1016/j.msea.2022.143206 ↗
38. An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments10.1557/JMR.1992.1564 ↗
39. Testing effects on hardness of a Zr-based metallic glass under nanoindentation10.1016/j.scriptamat.2017.05.046 ↗
40. Investigation of softening induced indentation size effect in Nanoglass and Metallic glass
41. Nanoindentation study of size effect and loading rate effect on mechanical properties of a thin film metallic glass Cu49.3Zr50.710.1016/j.physb.2011.10.050 ↗
42. Binary Cu-Zr thin film metallic glasses with tunable nanoscale structures and properties10.1016/j.jnoncrysol.2018.06.015 ↗
43. Using the P–δ2 analysis to deconvolute the nanoindentation response of hard-coated systems10.1557/JMR.1999.0305 ↗
44. The use of the indentation loading curve to detect fracture of coatings10.1016/S0257-8972(00)01091-4 ↗
45. A nanoindentation study of serrated flow in bulk metallic glasses10.1016/S1359-6454(02)00303-8 ↗
46. New regime of homogeneous flow in the deformation map of metallic glasses: elevated temperature nanoindentation experiments and mechanistic modelling10.1016/j.actamat.2004.09.005 ↗
47. C.A. Schuh, T.G. Nieh. A survey of instrumented indentation studies on metallic glasses. J. Mater. Res. 19(1), 46–57, https://doi.org/10.1557/jmr.2004.19.1.46.10.1557/jmr.2004.19.1.46 ↗
48. Investigation of pressure sensitive plastic flow in nanoglasses from finite element simulations10.1016/j.scriptamat.2020.01.022 ↗
49. Thermal and plastic behavior of nanoglasses10.1557/jmr.2014.101 ↗
50. Nanoindentation of nanoglasses tested by molecular dynamics simulations: influence of structural relaxation and chemical segregation on the mechanical response10.3389/fmats.2021.664220 ↗
51. Hardness and shear band evolution in bulk metallic glasses after plastic deformation and annealing10.1016/j.actamat.2008.07.009 ↗
52. G. Subhash, H. Zhang. Dynamic indentation response of ZrHf-based bulk metallic glasses, J. Mater. Res. 22(02), 478–485, https://doi.org/10.1557/JMR.2007.0058.10.1557/jmr.2007.0058 ↗
53. B.G. Yoo, K.W. Park, J.C. Lee, U. Ramamurty and J. Jang. Role of free volume in strain softening of as-cast and annealed bulk metallic glass. J. Mater. Res., 24(04) 1405–1416, https://doi.org/10.1557/JMR.2009.0167.10.1557/jmr.2009.0167 ↗
54. Effect of shot peening on the fatigue life of a Zr-based bulk metallic glass10.1016/j.scriptamat.2008.03.009 ↗
55. Plastic flow softening in a bulk metallic glass10.1016/j.actamat.2006.05.011 ↗
56. Micropillar compression studies on a bulk metallic glass in different structural states10.1016/j.scriptamat.2008.12.013 ↗
57. Hardness and plastic deformation in a bulk metallic glass10.1016/j.actamat.2004.10.023 ↗
58. Rate-dependent inhomogeneous-to-homogeneous transition of plastic flows during nanoindentation of bulk metallic glasses: fact or artifact?10.1063/1.2742286 ↗
59. Enhancing the plasticity of metallic glasses: shear band formation, nanocomposites and nanoglasses investigated by molecular dynamics simulations
60. Deformation behavior of bulk and nanostructured metallic glasses studied via molecular dynamics simulations10.1103/PhysRevB.83.100202 ↗
61. Analysis of indentation of pressure sensitive plastic solids using the expanding cavity model10.1016/S0167-6636(03)00075-9 ↗
62. Indentation size effect and shear transformation zone size in a bulk metallic glass in two different structural states10.1016/j.actamat.2012.08.061 ↗
63. Revealing the structural heterogeneity of metallic glass: mechanical spectroscopy and nanoindentation experiments10.1016/j.ijmecsci.2021.106469 ↗