Enhancing microhardness and surface integrity of Ti–6Al–4V alloy using WC–Cu composite electrode aided electrical discharge coating

Titanium alloy can be found in numerous applications, such as chemical, aerospace, and energy industries, among other sectors, due to its excellent performance. Nevertheless, the possible uses of a variety of titanium-based alloys have been greatly restricted by their low hardness and inadequate resistance to wear. Therefore, in this research work, WC–Cu composite electrode assisted electrical discharge coating (EDC) is used for improving microhardness (MH) and surface integrity of Ti–6Al–4V alloy. By utilizing powder composite electrode, the conductivity of the electrode can be increased, which provides controlled electric spark, resulting in uniform deposition. In order to increase the rate of deposition, the terminal of the EDM has been changed as WC–Cu composite electrode as anode and workpiece as cathode. Response surface methodology is used for studying the variables including compacting pressure (MPa), discharge current (I), pulse on time (Ton). In addition, microstructure, elemental analysis and coating interface of deposited Ti–6Al–4V alloy are investigated through scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS). The surface roughness of 8.86 µm was achieved at 400 MPa, 6 A, and 40 µs. The maximum MH of 988 HV was obtained at 400 MPa, 10 A, and 80 µs. The MH of the deposited layer is around 2–3 times harder than base material. Moreover, a greater adhesion strength coated layer was ∼118 N, which permits the alloy to have improved wear resistance. It was concluded that using a high-pressure electrode with lower settings resulted in an improved surface finish, while higher settings led to increased MH.